*Chapter 30, Problem 021 In the figure, a stiff wire bent into a semicircle of radius a = 2.7 cm is rotated at constant angular speed 38 rev/s in a uniform 17 mT magnetic fleld. What are the (a) frequency and (b) the amplitude of the emf induced in volts in the loop? X X X 1. X xX (a) Number 1 Units (b) Number Units

*Chapter 30, Problem 021 In the figure, a stiff wire bent into a semicircle of radius a = 2.7 cm is rotated at constant angular speed 38 rev/s in a uniform 17 mT magnetic fleld. What are the (a) frequency and (b) the amplitude of the emf induced in volts in the loop? X X X 1. X xX (a) Number 1 Units (b) Number Units

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter34: Electromagnetic Waves

Section: Chapter Questions

Problem 34.4P: An election moves through a uniform electric field E = (2.50i + 5.00j) V/m and a uniform magnetic...

See similar textbooks

Related questions

Q: 6. A 10 cm long rod is placed on two parallel rails so that it completes a loop. This device is…

Q: Consider the arrangement shown in the figure below. Assume that R = 6.00 0, l-1.20 m, and a uniform…

Q: In the figure, a stiff wire bent into a semicircle of radius a = 2.7 cm is rotated at constant…

Q: B is uniform sliding rod e mass of the rod is 3.99g. The resistor has a value of 8.83 ohm. The…

Q: Express the current I in terms of B, N and d. Calculate the numerical value of I in amps.

Q: In the figure, a conducting rod with length L = 27.0 cm moves in a magnetic field B of magnitude…

Q: If 71.4 cm of copper wire (diameter = 0.860 mm, resistivity 1.69 x 10 S-m) is formed into a circular…

Q: Question 3 x x x x Xx x x x x x x x xxBX x x x x x xx x x xx x x x x/x x x x x xx x .XxX XX.X.X.X…

Q: square wire loop is held in a uniform 4 T magnetic field directed perpendicular to the plane of the…

Q: For a conducting rod of U-shaped metal wire of length, I = 30m is connected to a lightbulb having a…

Q: A solenoid has the following dimensions. inner diameter d = 4.92 cm length L = 30.7 cm When a…

Q: While this field is changing, what does the ammeter read? Express your answer in milliamperes. I =…

A: Given area (A)=0.3 x0.6=0.18 m2 Resistance(R)=15 ohms rate of change of magnetic field dBdt=-0.34…

Q: The following figure shows a copper wire bent into a circular shape with a radius of 0.50 m. B (into…

Q: A permanent magnet is moved toward a 320 turn solenoid such that the magnetic field inside the…

A: The emf induced is given by the equation,

Q: A long solenoid has 78 turns/cm and carries current i. An electron moves within the solenoid in a…

A: The current i in the solenoid. given: Speed of electronve=0.0359cnumber of turns per unit…

Q: A long, straight current carrying solenoid creates a uniform magnetic field B = 12 mT inside itself…

Q: (a) Calculate the applied force required to move the bar to the right at a constant speed of 1.90…

Q: A rectangular coil with sides 0.120 m by 0.210 m has 495 turns of wire. It is rotated about its long…

Q: B A rectangular coil has 13 turns and sides of length a = 25 cm and c = 20 cm. The coil is pivoted…

A: Given, total turns are n=13 and the side lengths are a=25cm=0.25mc=20cm=0.20m And the magnetic field…

Q: A planar coil of wire has a single turn. The normal to this coil is parallel to a uniform and…

Q: he figure represents a thin conducting loop placed in a uniform magnetic field directed…

A: According to faraday Law the voltage induced in a coil is equal to rate of change of magnetic flux…

Q: Refer To: Ref 22-2 Which one of the following statements concerning this situation is true? Since…

A: Have a look dear

Q: Chapter 30, Concept Question 04 The figure shows two circuits in which a conducting bar is slid at…

Q: A loop of wire enclosing an area of 0.09m2 has a magnetic field passing through its plane at an…

A: Given data: Area (A) = 0.09 m2 Component of magnetic field perpendicular to the plane = 0.12 T…

Q: In a region of space where the magnetic field of the earth has a magnitude of 80 mT and is directed…

Q: 6. A loop of a wire has the shape shown in the drawing. The top part of the wire is bent into a…

A: Given, r=0.18 m B=0.79 T Area of semicircle is A=πr22=0.050 m2during half revolution the semi circle…

Q: The emf of a coil rotating in a magnetic field is zero at t=0, and the coil rotates at an angular…

Q: A circuit is made with a resistor of resistance 25 ohms and a movable bar with length 15 cm moving…

A: The magnetic flux (Φm) through a surface is Φm=BlxSince B and l are constant and the velocity of…

Q: 6. A loop of a wire has the shape shown in the drawing. The top part of the wire is bent into a…

Q: A conducting bar of length & moves to the right on two frictionless rails as shown in the figure…

Q: The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is…

Q: In each of two coils the rate of change of the magnetic flux in a single loop is the same. The emf…

A: Given data : Number of loops in coil 1 ( N1 ) = 245 loop Induced emf in coil 1 ( emf1 ) = 2.51 V…

Question

100%

*Chapter 30, Problem 021
In the figure, a stiff wire bent into a semicircle of radius a = 2.7 cm is rotated at constant angular speed
38 rev/s in a uniform 17 mT magnetic fleld. What are the (a) frequency and (b) the amplitude of the emf
induced in volts in the loop?
X X
X X
X xX
(a) Number
Units
(b) Number
•2
Units
X X X

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
A rectangular coil consists of N = 100 closely wrapped turns and has dimensions a = 0.400 m and b = 0.300 m. The coil is hinged along the y axis, and its plane makes an angle = 30.0 with the x axis (Fig. P22.25). (a) What is the magnitude of the torque exerted on the coil by a uniform magnetic field B = 0.800 T directed in the positive x direction when the current is I = 1.20 A in the direction shown? (b) What is the expected direction of rotation of the coil? Figure P22.25
A metal bar of length 25 cm is placed perpendicular to a uniform magnetic field of strength 3 T. (a) Determine the induced emf between the ends of the rod when it is not moving, (b) Determine the emf when the rod is moving perpendicular to its Length and magnetic field with a speed of 50 cm/s.
In Figure P20.65 the rolling axle of length 1.50 m is pushed along horizontal rails at a constant speed v = 3.00 m/s. A resist or R = 0.400 is connected to the rails at points a and b, directly opposite each other. (The wheels make good electrical contact with the rails, so the axle, rails, and R form a closed-loop circuit. The only significant resistance in the circuit is R.) A uniform magnetic field B = 0.800 T is directed vertically downward. (a) Find the induced current I in the resistor. (b) What horizontal force F is required to keep the axle rolling at constant speed? (c) Which end of the resistor, a or b. is at the higher electric potential? (d) Alter the axle rolls past the resistor, does the current in R reverse direction? Explain your answer. Figure P20.65
A rectangular loop has dimensions 0.500 m by 0.300 m. The loop is hinged along the x-axis and lies in the xy-plane (Fig. P19.42). A uniform magnetic field of 1.50 T is directed at an angle of 40.0 with respect to the positive y-axis and lies parallel everywhere to the yz-plane. The loop carries a current of 0.900 A in the direction shown. (Ignore gravitation.) (a) In what direction is magnetic force exerted on wire segment ab? What is the direction of the magnetic torque associated with this force, as computed with respect to the x-axis? (b) What is the direction of the magnetic force exerted on segment cd? What is the direction of the magnetic torque associated with this force, again computed with respect to the x-axis? (c) Can the forces examined in parts (a) and (b) combine to cause the loop to rotate around the x-axis? Can they affect the motion of the loop in any way? Explain. (d) What is the direction (in the yz-plane) of the magnetic force exerted on segment bc? Measuring torques with respect to the x-axis, what is the direction of the torque exerted by the force on segment bc? (e) Looking toward the origin along the positive x-axis. Will the loop rotate clockwise or counterclockwise? (f) Compute the magnitude of the magnetic moment of the loop. (g) What is the angle between the magnetic moment vector and the magnetic field? (h) Compute the torque on the loop using the values found for the magnetic moment and magnetic field. Figure P19.42
A circular coil with 200 turns Las a radius of 2.0 cm. (a) What current through tire coil results in a magnetic dipole moment of 3.0 Am2? (b) What is the maximum torque that the coil will experience in a uniform field of strength 5.0102 ? (c) If tire angle between and B is 45°, what is the magnitude of tire torque on the coil? (d) What is the magnetic potential energy of coil for this orientation?
A small, circular washer of radius a = 0.500 cm is held directly below a long, straight wire carrying a current of I = 10.0 A. The washer is located h = 0.500 m above the top of a table (Fig. P31.69). Assume the magnetic Held is nearly constant over the area of the washer and equal to the magnetic field at the center of the washer. (a) If the washer is dropped from rest, what is the magnitude of the average induced emf in the washer over the time interval between its release and the moment it hits the tabletop? (b) What is the direction of the induced current in the washer?
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
A proton moving horizontally enters a region where a uniform magnetic field is directed perpendicular to the proton's velocity as shown in Figure OQ29.4. After the proton enters the field, does it (a) deflect downward, with its speed remaining constant; (b) deflect upward, moving in a semicircular path with constant speed, and exit the field moving to the left; (c) continue to move in the horizontal direction with constant velocity; (d) move in a circular orbit and become trapped by the field; or (e) deflect out of the plane of the paper?
Review. A rod of mass m and radius R rests on two parallel rails (Fig. P28.23) that are a distance d apart and have a length L. The rod carries a current I in the direction shown and rolls along the rails without slipping. A uniform magnetic field B is directed perpendicular to the rod and the rails. If it starts from rest, what is the speed of the rod as it leaves the rails?
A circular loop of wire with a radius of 4.0 cm is in a uniform magnetic field of magnitude 0.060 T. The plane of the loop is perpendicular to the direction of the magnetic field. In a time interval of 0.50 s, the magnetic field changes to the opposite direction with a magnitude of 0.040 T. What is the magnitude of the average emf induced in the loop? (a) 0.20 V (b) 0.025 V (c) 5.0 mV (d) 1.0 mV (e) 0.20 mV
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ23.9. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative.