caliculate the torque and rotation speed at the input pulley if output pulley needs to rotate at 100rpm and produce a torque of 500 in lb. assume that there is no stretching and slippage. attached figure: A pulley driven mechanism. the diameters of pulleys D1,D2,D3,D4 are 1",2",3"and 5", respectively.

Q: Find the Grashof condition, any limit positions, and the extreme values of the transmission angle…

A: Given:

Q: = 3. The following data apply to a four-bar linkage similar to the one illustrated in Fig. 3: RA02…

A:

Q: mechanism like this one, if it is known the length of O2A (link 2) is 5 cm (link 3) is 4 cm (link 3)…

A:

Q: A motor with a power rating of 1800 Watts is coupled to the input shaft of the pinion (or driver),…

A: Given: NA=650rpmZA=22teethZB=48teethZC=30teethZD=70teethPower (P)=1800W

Q: 03/ The manually - operated hoist shown in figure (13) is based on an epicyclic gear train. The sun…

A: Given: The number of teeth on annulus, Za = 90 The tangential force on handle = 25 x load lifted

Q: For the mechanisms pictured below: perform displacement analysis both graphically and analytically:

A:

Q: For the given RRRR mechanism, if an external torque is applied at O2, calculate the torque required…

A: It is asked to find the torque acting on link 4 based on the input torque on link 2

Q: Q4/A single V belt is to be selected to deliver engine power to the wheel-drive transmission of a…

A:

Q: For the Finishing Mill of a hot strip mill, the input shaft of several different gearboxes are each…

A: The objective of the question is to analyze the capabilities of a gearbox in a hot strip mill. This…

Q: Imagine two gears in mesh, the pinion is rotating clockwise, what is the force analysis for such a…

A: Explanation: The pinion is rotating clockwise and connected with the gear. Assume the gear us spur…