Answered: Calculate the power of a motor needed… | bartleby

Related questions

Question

Calculate the power of a motor needed for driving a coal mine elevator of 50 [ton] at the velocity of
10 [m/s]. Calculate the energy in [kWh] needed for transporting the elevator cage from 1500 [feets] to
the ground level. Calculate kinetic energy in [kWh] of the cage at its full speed.

Expert Solution

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Suppose the mass of a loaded elevator is 1700 kg.What force, in newtons, must be supplied by the elevator's cable to produce an acceleration of 0.82 m/s2 upwards against a 205-N frictional force? How much work, in joules, is done by the cable in lifting the elevator 22 m? What is the final speed, in meters per second, of the elevator if it starts from rest? How much work, in kilojoules, went into thermal energy produced by friction?
A 23.0-kg file cabinet of is sliding down a frictionless ramp for a distance of 5.00 m as shown. Use g = 10.0 m/s2. Assuming the system is cabinet+earth+ramp, match the answers with questions. AK + AUg + AUsp + AEth + AECH = Wexternal 5.0 m 15.0° v What is the change in gravitational potential energy (AUg)? (Hint: what is Ay?) A. OJ v What is the change in thermal energy (AE+H)? B. 298 J v What is the change in kinetic energy (AK)? C. -298 J D. -230 J E. 1150 J F. none of the given G.-1150 J
A 5.56 kg object falls freely (ignore air resistance), after being dropped from rest. Determine the initial kinetic energy (in J), the final kinetic energy (in J), and the change in kinetic energy (in J) for the following. (a) the first meter of the fall initial kinetic energy ____J final kinetic energy _____J change in kinetic energy ____J (b) the second meter of the fall initial kinetic energy ____J final kinetic energy _____J change in kinetic energy _____J
A child on a swing is released from rest at an angle of 60º from vertical. At the low point (0º from vertical), the swing and child together are 2 meters below the bar that the swing is attached to. Neglecting friction, use the energy approach to find the speed of the child at the low point. b) Suppose the 25 kg child’s speed is actually 3 m/s at the low point. How much energy was lost (work done by nonconservative forces) in this process?
A ball is thrown upward in the air. Neglect air resistance. As it travels upward, a) Both its kinetic energy and potential energy increase. b) Its kinetic energy increases and potential energy decreases. c) Its kinetic energy decreases and potential energy increases. d) Both its kinetic energy and potential energy decreases.
Calculate the kinetic energy of a Boeing 767 that is 350,000lbm and travels at 400mph. Would I use the kinectic enrgy formula? Or the translation formula since it's in english units?
How much work is done by gravity when dead lifting a 100.0 kg barbell 64.11 cm from the floor to hip level [round your final answer to zero decimal places]?
E21) a)Write the work done by a conservative force in terms of its potential energy. b)In what direction are forces pointing to be considered centripetal? c)In a system of interacting particles, what conservation law results when ∑Fiext=? d)Anobjectexperiencingseveralforcesresultinginsomedisplacement.What is the net work done by these forces equal to If the work of one of these forces is path-dependent, then what is not conserved? e) If a frictional force causes the total mechanical energy of a system to decrease, then I) what happens to the system’s total internal energy? ii) what is truly conserved?
If a 100 W electric motor has an efficiency of 68%, how long will it take to lift a 40kg object to a height of 8m?