Calculate the percentage elongation from the length of the steel bar is 20 cm, and the extension is 3 mm. O a. 0.015 Ob.0.005 Oc.0.15 Od 1.5

Q: The channel shape cross-section and the rectangular cross-section shown in the Figure Q4 are made of…

A: The solution is provided below

Q: 2.70- 7120 -2x.625 1.25 .75 325 1.95 2x R.375 -R.75 75 S.00 .75 6.0 BRACKET MATERIAL -MILD STEEL

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional.…

Q: The channel shape cross-section and the rectangular cross-section shown in the Figure Q4 are made of…

A: Given parameter,Yield stress for channel shaped section,           Yield stress for the rectangular…

Q: 2. Assume that axial deformation of Member EF is caused mainly by its reaction to external forces on…

A:

Q: A 4ft long rod with a 0.29 inch diameter is subjected to a 10,130lb tensile load. What is the…

A:

Q: The bellcrank is in equilibrium a) determine the diameter of the bar DE if the normal stress is…

A: GIVEN: Load W= 30KN length of road BC:LBC=0.2m length of road CD:LCD=0.3m  thickness of plate C: t=…

Q: erial when longitudinal strain is 0.12mm/mm and transverse strain is -0.03

A: Given data  Longitudinal strain=0.12mm/mm  Transverse strain=-0.0396mm/mm

Q: If a 12-ft long portion of the bar in Question 23 is elongated 0.064 in. by the pull, the unit…

A:

Q: a) The stress in the wire. Answer in MPa b) The strain in the wire. c) The increase in the length of…

A:

Q: Find the volume of the wheel. Assume IPS units. Hold Ctrl and scroll on your mouse to zoom in on the…

A: Given Data A=6.99 B=0.52 Find Find the volume of the wheel.

Q: A wire with a Young’s Modulus, E, of 8.5 x 106 N/m2 and an original length of 1.5 m is under…

A: Calculate the strain in the wire. ε=δll Here, l is the original length of the wire, δl is the change…

Q: Determine the largest shear force V that the member can sustain if the allowable shear stress is…

A:

Q: determine the diameter of the bar DE if the normal stress is limited to 100MN/m2. b) Determine the…

A: Given DataP1=30kN θ=30° {taken}

Q: An circular rod loaded with 30,000 lbs. The allowable tensile stress is 10,000 psi, modulus of…

A:

Q: The aluminum block has a rectangular cross section and is subjected to an axial compressive force of…

A: if you have any doubt comment

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.