An circular rod loaded with 30,000 lbs. The allowable tensile stress is 10,000 psi, modulus of elasticity of 40x106 psi. If the original length of specimen is 35 inches with elongation not exceeding 0.0015 inch, what diameter of the rod is required? O a. 4.72 in O b. 1.954 in OC.1.215 in O d. 5.923 in

Q: 5. Determine the strength of a % in bolt having a yield stress of 60 ksi and stress area of 0.1134…

A:

Q: a) The stress in the wire. Answer in MPa b) The strain in the wire. c) The increase in the length of…

A:

Q: A two-layered material is made of two metal bars, each with square cross-sectional area t² and…

A: Given: Thickness of each bar is t Increase in the temperature=∆T Let the coefficient of thermal…

Q: A 5-kN tensile load is applied to a test coupon made from 1.6-mm flat steel plate (E = 200 GPa, v =…

A:

Q: Do not round intermediate answers. Give your final answer(s) to three decimal places. Check your…

A:

Q: 6 in 6 in.- 8 in. if e = 5 degrees and AA' is 5 mm, what is the total deformation of member FC'? O…

A:

Q: Part A. if the bolt is subjected to a compressive force of P= 21.3 kN, deteemine the magnitude of…

A: Write the given values along with suitable variables.

Q: A steel bolt has a diameter of 8 mm. The bolt is encased by a bronze tube that has an outer diameter…

A: **Contact me if you have any questions. Most of them are just conversion of units.**Please leave a…

Q: Following plate is connected to the wall using 7 bolts. Cross sectional area of each bolt is A.…

A: Given- Force F is passing through the center of gravity of the plate, so it will be equally…

Q: A 4ft long rod with a 0.29 inch diameter is subjected to a 10,130Ib tensile load. What is the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.