Calculate the monthly average evaporation from the open water surface using the Penman method according to the following July (31 days) Oh Latitude monthly average temperature Actual daylight hours (n) Sunny hours of the day, E (July, 25 Degrees North Wind speed Reflection coefficient of the water surface Relative gender (%) RA (July, 25 Degrees North O psychrometer constant Saturated vapor pressure at 22 degrees Saturated vapor pressure at 22.1 degrees 25 Degrees North at 22 degrees 115 sec 13.5 sec 1.8 m/sn 0.07 70 920 gr*cal/cm²/gun 117.74*10-9 (gr*cal/cm²/gun) 0.66 mb/C° 19.82 mmHg 19.94 mmHg

Calculate the monthly average evaporation from the open water surface using the Penman method according to the following July (31 days) Oh Latitude monthly average temperature Actual daylight hours (n) Sunny hours of the day, E (July, 25 Degrees North Wind speed Reflection coefficient of the water surface Relative gender (%) RA (July, 25 Degrees North O psychrometer constant Saturated vapor pressure at 22 degrees Saturated vapor pressure at 22.1 degrees 25 Degrees North at 22 degrees 115 sec 13.5 sec 1.8 m/sn 0.07 70 920 grcal/cm²/gun 117.7410-9 (gr*cal/cm²/gun) 0.66 mb/C° 19.82 mmHg 19.94 mmHg

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Hydrology Problem: A reservoir is being planned for Albuquerque, NM. The design evaporation is set as the critical period of July. Compute evaporation depth during July using the Penman method. The net radiation is 361 ly/day with a pressure of 838 mb. Max Temperature: 92°FMax Wind Speed: 7.3 mphRelative Humidity: 31%
2- A 25 ml water sample is placed in a dish that wt. 50g, after evaporation and drying at 103°C, and cooling in desiccator, the dish wt. 50.02g. Then the dish is fired at 5500 C for one hour, after which it weight 50.005g. Estimate in (mg/l): volatile solids (VS) and fixed solids (FS) of the water sample.
The following data are from infiltration test: 10 50 100 240 15 34 52 93 Time (min) Depth (mm) If the infiltration equation is D-Cr" +Pt where D in (mm) and P is (12mm/hr) and t in (min). Find the infiltration rate after two hours.
A reservoir with average surface spread of 4.8 km2 in the first week of October has the water surface temperature of 30°C and relative humidity of 40%. Wind velocity measured at 3.0 m above the ground is 18 km/h. The mean barometer reading is 760 mm of Hg. Use Meyer's equation. Take saturation vapour pressure at 30°C as 31.81 mm of Hg. Meyer's coefficient Km = 0.4 for large, deep water reservoir. The volume of evaporation loss in the first week of October is
Determine the lake evaporation for a month in which the average water temperature is 22.5 degree celsius and average wind speed at 10m is 14.5 kph at a relative humidity of 40 percent. Subject: Hydrolody
part 2. 1 kindly help me please need it BEFORE 9:10 pm i need the answer pleasee. THANK YOU SO MUCH! <3 -Derive the relationship between moisture content wet-basis and dry-basis
A monomedia anthracite filter is designed with the following specifications: effective size 1.1 mm, uniformity coefficient 1.4, and density 1650 kg/m³. Calculate the backwash rate required to get 25 percent bed expansion at the design summer temperature of 22 C (p = 998.7 kg/m³, μ = 9.55 x 10-4 kg/m-s). Use the midpoint Ergun parameters for anthracite: ky = 228, ki = 4.4, &f = 50%.
Please help me, i need the answer as soon as possible
Derive the Evapotranspiration (ET) in equivalent depth of water from a potted plant for a given time period under field conditions. The pot made of plastic is cylindrical of diameter D. During this period rain (R) occurred and was measured by the raingage installed nearby Percolation (P) was also measured in volume through the bottom of the pot. The pot and the plant was weighed at the beginning of the period as W1 and weighed again at the end of the period as W2. Using the water balance approach express ET as a function R, P, W1, W2 and D for the Day
Saturated Surface Dry Weight = 3650.3 g Oven Dry Weight = 3625.5 g Submerged Weight = 2293.0 g. Compute the Absorption Capacity in %.
Calculate the latent heat of vaporization(J/kg) from an open water surface with air temperature 22°C, relative humidity is 40% and wind speed is 3 m/s, all measured at height 2 m above the water surface. Assume a roughness height of 0.03 cm. The net radiation is 200 W/m^2.
11. Change 15°F to degree kelvin Complete FBD, FORMULA, AND SOLUTION