Help on this question please? CALCULATE THE INDUCTANCE AND THE REACTANCE PER LENGTH UNIT AT60 HZ OF THIS MONOPHASIC LINE SHOWN BELOW. VERIFY THAT THEGMR IS ALMOST EQUAL TO THE DISTANCE BETWEEN BOTH PHASESCENTERS WHEN THEY ARE MUCH BIGGER THAN THE DISTANCE BETWEENTHE CONDUCTOR OF A SAME PHASE. ALSO, CONSIDER THAT THEDIAMETER OF EACH CONDUCTOR (A, B, C AND D) HAVE THE SAMEVALUE, WHICH IS 5 CM.ALSO, CONSIDER THIS FORMULA WHEN CALCULATINGTHE INDUCTANCE FOR EACH PHASE.DmLx=2.107Ds, xDmLy=2.107Ds, y45 cma○ bSIDE X12 m5 cmсо○ dSIDE Y

Step 1: Step 2: Step 3: Step 4:

Answered: CALCULATE THE INDUCTANCE AND THE…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.23P

See similar textbooks

Similar questions

Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an insulator string having two identical porcelain insulators. The self-capacitance of the insulator is 5 times the shunt capacitance between link and ground. Find the voltages across two insulators.
GMR calculate
2.5 A 3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontal spacing with 6.1 m between the centre lines of adjacent phases. The distance between the sub- conductors of each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find the inductance per phase per km. [0.988 mH]
12. There are 6 conductors in a double circuit line. Each conductor has a radius of 12 mm. The 6conductors are arranged horizontally. The center to center distance between the conductor is 2m. The sequence of conductors are from left to right as follows: a,b.c,a', b', c'. Calculate the inductance per km per phase of system. the a' 2 m 2 m 2 m 2 m 2 m
I need the answer as soon as possible
Please provide Handwritten answer
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.
The number of disc insulators used in a suspension insulator setup with string efficiency 80 %, phase voltage 33 kV, and the voltage across insulator nearest to conductor 11 kV is .......................... Complete the answer.
A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
Schering Bridge is used to find ____________. a. capacitance b. pressure c. inductance d. frequency
Subject - Design electrical circuits for single phase AC networks Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and series AC circuits on voltage resistance and impedance.

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning