) Calculate the discharge from a tubewell of 20-cm diameter penetrating fully into a confined aquifer of 20-m thick and having a permeability of 40 m/day. The drawdown in the well is 3 m and zero drawdown at 300 m from the well. If the diameter of the well is doubled, find the percentage increase in the yield, the other conditions remaining the same. State the assumntions in the formula vou use (1303 7 1nm)

) Calculate the discharge from a tubewell of 20-cm diameter penetrating fully into a confined aquifer of 20-m thick and having a permeability of 40 m/day. The drawdown in the well is 3 m and zero drawdown at 300 m from the well. If the diameter of the well is doubled, find the percentage increase in the yield, the other conditions remaining the same. State the assumntions in the formula vou use (1303 7 1nm)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Yuri wants to determine the permeability of an aquifer. The aquifer has a test well 300-mm in diameter with two observation wells. A pumping test was conducted for 24 hours with the discharge being held constant at 5,896.3 m^3/day. The first one, 82.87 meters from the test well, has a draw-down of 0.86 meters. The second one, 44 meters from the test well, has a draw-down of 1.21 meters.The static water table penetrates the well to a depth of 28 meters. Determine the radius of influence of the aquifer in meters. Round off to three decimal places.
31 Yuri wants to determine the permeability of an aquifer. The aquifer has a test well 300-mm in diameter with two observation wells. A pumping test was conducted for 24 hours with the discharge being held constant at 5,721.4 m^3/day. The first one, 81.07 meters from the test well, has a draw-down of 0.6 meters. The second one, 40 meters from the test well, has a draw-down of 1.43 meters.The static water table penetrates the well to a depth of 25 meters. Determine the radius of influence of the aquifer in meters. Round off to three decimal places.
3. Determine the resultant of the three forces acting on the dam shown in the figure and locate its intersection with the base AB. Required: Resultant and its intersection with the base AB Solution: P-10,000 lb -24,000 f F-6000 tb
Question 1 The discharge from a fully penetrating well under steady state pumping in a confined aquifer is (1000 two wells located at 6 and 12 meters from the well are 3.0 m and 2.0 m respectively. Čalculate the permeability of the aquifer. Show the data on the neat sketch. liters per minutes. The aquifer has a thickness of 20 m. The drawdowns observed at
Yuri wants to determine the permeability of an aquifer The aquifer has a test well 300-mm in diameter with two observation wells A pumping test was conducted for 24 hours with the discharge being held constant at 5,608.7 m^3/day. The first one, 86 59 meters from the test well, has a draw-down of 0.81 meters. The second one, 48 meters from the test well, has a draw-down of 1.13 meters. The static water table penetrates the well to a depth of 28 meters. Determine the radius of influence of the aquifer in meters Round off to three decimal places. Activate Windows A Moving to another question will save this response. Go to Settings to actiyate Windows Question 8 of 20 ASUS W R] 7T U K
i need the answer quickly
9.An unconfined aquifer with K-30 m/day is bounded by a stream on one side as shown in Figure 2, At a distance of 80 m from the stream, a well of 0.4 m diameter is pumped at rate of 3000 m³/day. What is the drawdown in the well? Q=3000 m³/day 20 m m 801 Figure 2 C C d=0.4 m K=30 m/day Impermeable Layer m³ / day
QI. s) Q1: A 1 m diameter well penetrates vertically through a confined aquifer (30 m) thick. When the well is pumped at (2712 m³/day), the drawdown in a well 15 m away from pumped well is 1.8 m; while the drawdown in another well 50 m away from pumped well is 0.5 m. Take the maximum head is 40 m. 1- Determine the transmissivity. 2- What is the approximate head in the first well? 3- What is the approximate head in the second well? 4- What is the approximate head in the pumped well for steady-state conditions? 5- What is the approximate drawdown in the pumped well?
Refer to the cross section of the earth dam shown in the figure. Calculate the rate of seepage through the dam (q in m^3 / min / m) using L. Casagrande’s method
DETERMINE: a. Rate of seepage into the well during pumping
Environmental Enginee... During a recuperative test, the water is pumped out 2.8 m initially and allowed to recuperate. It was observed that the water level rises by 1.45m in 80 minutes. If the diameter of the well is 3.45m, determine by what amount the diameter need to be increased to get a yield of 5 litre per sec under a depression head of 1.65m.