Calculate non-zero stress components (normal and shear) at points A, B and C. Point C is located at the center of the cross section attached to the wall. Calculate non-zero strain components at point B. Neglect shear stress due to shear force. Given: loading F = 400 N, P-2000 N, and T = 75 N·m, Young's modulus E = 70 GPa, Poisson's ratio v = 0.25 15-mm D. -100 mm

Q: A prismatic steel bar of square cross section 3 in. x 3 in. is subjected to a tensile load P = 135…

A: Solution: Given Data: P=135 kipsAn=6 in2θ=45o

Q: A flexible connection consisting of rubber pads(thickness t =9 mm) bonded to steel plates is shown…

A: Given   Force P =16 kN Shear modulus for the rubber is G = 1250 kPa Thickness t =9 mm Find…

Q: The state of strain at the point has components of €, = 180(10 6) €y = -100(10-6) and All attempts…

A:

Q: For the vertical flexural member shown, determine the maximum shear stress in MPa at section K, as…

A:

Q: 1- The two uniform linearly elastic rods shown below are welded together at B, and the resulting…

A:

Q: Find the value of the spring constant k. The amplitude of the driving force is 0.505 N ar force is…

A: At resonance, frequency of oscillation becomes equal to natural frequency.

Q: e state of stress at a point in a circular bar under pure torsion is given by T xy = T yx= t and…

A:

Q: 1. Strain Gage Rosettes & Principal Stresses-The Cantilever Beam A strain gage experiment was…

A: (a) Write the given data. εA=50×10-6εB=300×10-6εC=172×10-6 It can be seen that the angle between two…

Q: A roadway sign weighs 5 kN and is supported by a structural pipe that has an outside diameter of 295…

A:

Q: A thin metal alloy plate is loaded by biaxial stress (2 directions) given by 8000 psi in the x…

A:

Q: = A machine component is fabricated from a bent tube as shown below. One part of the tube lies along…

A: Outside diameter, d0=122 mmInside diameter, di=108 mmForce F=8.5 kNLengths,L1=258 mmL2=118 mmL3=281…

Q: The two bars shown in the figure are used to support a load P. When unloaded, joint B has…

A: The dimension are

Q: 2- For the truss structure shown, use symmetry to determine the displacements of the nodes and the…

A:

Q: Parvinbhai

A: Step 1: Step 2: Step 3: Step 4:

Q: (1) In the figure below, the cross section areas of rods AB and BC are A1, A2, and the Young's…

A:

Q: 3. A force P is applied to the rigid lever arm ABC as shown. The arm rotates counterclockwise about…

A: An axially loaded bar undergoes change in length, becoming longer when in tension and shorter when…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.