Calculate molality, AT bp, and i for each trial and record in a data table that you make below. The AT bp is the change between the boiling point of the water with no solute AND the boiling point with solute. Then use this calculation and your molality to calculate i. Show your calculations.

Calculate molality, AT bp, and i for each trial and record in a data table that you make below. The AT bp is the change between the boiling point of the water with no solute AND the boiling point with solute. Then use this calculation and your molality to calculate i. Show your calculations.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Which of the following statements is considered true? a. For common liquids, the normal freezing points and normal boiling points are constant b. the molal boiling point elevation and freezing point depression constants for a given solvent carry the unit of measurement of degrees C/molarity c. A and B are correct d. A and B are incorrect
A certain liquid x has a normal freezing point of 1.30 °C and a freezing point depression constant K,- 3.30 °C-kg'mol!. A solution is prepared by dissolving some glycine (c,H,NO,) in 850. g of x. This solution freezes at - 2.2 °C. Calculate the mass of c,H,NO, that was dissolved. Be sure your answer is rounded to the correct number of significiant digits. ?
A solution contains 3.86g of magnesium chloride and 250g of water. Compute for thefreezing point depression of the solution. (K, water: 1.86 °C/m)A. 0.16 ACB. 0.25 PCC. -0.25 PCD. -0.90 °0 Assume that a 1-L solution contains 35g of potassium chloride (MM: 74.6 g/mol).Compute for the osmotic pressure ifthe solution is at 298 K. (R=0.08206 L-atm/mol-K)A. 22.95 atmB. 24.50 atmC. 11.47 atmD. -11.47 atm Suppose that a 1 m sugar-water solution raises the boiling point of water by 0.51 °C.How much will the boiling point of water increase if the sugar-water solution amounts to 3 m?A. 0.51 °CB. 1.02 °CC. 1 53 POD. 101.53 °C
An experiment was conducted to determine the effect of glucose on the freezing point of water. Experimental data showed thatthe freezing point depression of water in solution was –2.6°C when 1.0 g of glucose was dissolved in 10g of solvent. Calculatethe expected freezing point for such solution and compare the expected freezing point to the value found experimentally. Give aplausible explanation for any discrepancies. (M.W. of glucose= 180.16g/mol; i=1). Show all your work.
9.)Moles of solute (mol)Use the molality to convert kg of solvent to moles of solute. 10.)Molar mass of the solute (g/mol)Use the mass of solute you weighed out in the simulation and moles of solute calculated in the previous step. 11.)Percent error for the molar mass of the solute % error=∣∣∣true value−experiment valuetrue value∣∣∣×100% error=|true value-experiment valuetrue value|×100 The true value for the molar mass of NaCl is 58.44 g/mol. Information found so far: Mass NaCl (g) 5.8871 Vol of water mL 100.0 Mass ice (g) 51.5023 Freezing point of solution (C) -2.85 Predicted value of i for NaCl is 2 Molarity of solution (m) 0.76612903225806 Mass of solvent in grams 151.5g Mass of solvent in kg 0.1515kg
A mixture of 20 mL of isoamyl acetate (MW=130.2 g/mol and density= 0.88 g/mL) and 20 mL of methyl benzoate (MW= 136.2 g/mol and density =1.09 g/mL) is distilled. Calculate the mole percent for each component. Use these mole percents and the figure below to answer the following questions.a. What is the initial boiling point of this mixture?b. What is the composition of the vapor in equilibrium with the liquid? Is this composition the same as the composition of the initial condensate from simple distillation?c. Instead of a simple distillation, you decide to use fractional distillation. Assuming two theoretical plates, what is the composition of the first fraction collected?
II. A Study of Intermolecular Forces of Attraction Anna Divi, a young and ambitious researcher, is planning to put up her very own research laboratory. However, she does not have the funds for this to happen. She then approached Alan Read, CEO of a well-known funding agency, to help her pursue her dream laboratory. Before Alan considers Anna's proposal, Anna must perform an experiment on determining the melting point of solutions. She must have an accurate result with a percent error not greater than 3%. The data on the experiment is given below. Help Anna achieve her goals by performing the necessary calculations below. Table 1. Data on the determination of the melting point of the solution. Parameters Values Theoretical freezing point of solvent, °C 65.8 Freezing point depression constant (ke) 2.49 of solvent, 'C m1 0.250 mass of solute, g mass of solvent, g 2.100 molar mass of solute, g 148.21 mol
A student dissolves 13. g of glucose (C6H12O6) in 425. mL of a solvent with a density of 1.09 g/mL. The student notices that the volume of the solvent does not change when the glucose dissolves in it. Calculate the molarity and molality of the student's solution. Round both to 2 significant digits. Please help, thank you.
D. Freezing Point Calculation Directions: Study the sample problem and do the task given. Sample problem with solution, Task to do Ethylene glycol (C2H6O2) is a molecular compound Calculate the freezing point of a solution that is used in many commercial anti-freezes. An aqueous solution of ethylene glycol is used in. vehicle radiators to prevent the water in the radiator from freezing by lowering its freezing point. Calculate the freezing point of a solution of 400. g of ethylene glycol in 500.g of water. repared by dissolving 27.56 g of glucose (C6H1206) into 125 g of water. Step 1: List the known quantities and plan the problem. Step 1: Kf (H2O) = -1.86 °C/m %3D Known: mass of C2H6O2 = 400. g molar mass of C2H6O2 = 62.08 g/mol mass of H20 = 500. g = 0.500 kg Kf (H20) = -1.86 °C/m *Kf- is the constant freezing point %3D %3D %3D %3DD ni noiulge Unknown: Tf of solution = ? °C *Tf- is the total freezing point This is a three-step problem. First, calculate the moles of ethylene glycol.…
d.Under what temperature and pressure (high / low) conditions do real gases behave ideally? Explain your answer. e. If you had two solutions, and you added equal molar amounts of NaCl to one and CaCl2 to the other, which of these two solutions had the greatest freezing point depression? What if instead of NaCl we used KCl, would that change the result? Explain your answer. f. Explain the hydrophobic effect. (0.5 Bonus: which thermodynamic property is at the origin of this effect) SHORT ANSWER PLEASE
Match the following. Drag the terms on the left to the appropriate blanks on the right. Reset Help 0.020 MNH4 Cl solution that is most strongly dependent upon pressure 1. 0.0050 MCO2 2. - highest boiling point 0.050 MC6H12O6 (aqueous) 3. - solution of ionic compound with highest freezing point 0.010 mAl(NO3)3 0.050 mNaCi 4. - solution with AT, 0.026° C 5. - largest van't Hoff factor
4-6: A solution contains 45.0 g of methanol, CH;OH, dissolved in sufficient water to give a total mass of 210.6 g. 4. Compute for the number of moles of the solute present in the given solution. 5. What is the mass (in kg) of water used to dissolve the solute from the given problem? 6. Determine the molal concentration of the said solution.