(a)A block of coeight W shdes clown an inclinednoite hibričatedy a filIhe film contact area f A and its thickpers is h.Asruming a linear velouty datribution in the film, derusan expression for the terminal (zero accefaration) veloGt,fheW slides down anmof oit, figure below.inclined planealA blockthen4位66ck.Dfind the terminal velocty of He blocek inblock mass Is 6kg, A = 35cn, @ =15° Gnd the film is Immtnk SAE al at 20°C.fry belew, in #eLiqaidofthickiness,hBlock contactarea,A

wieght of block =wAngle of inclination =θContact area = A Film thickness =h FBD of block Since As…

CA Hock of weight W sides down an inclined woite hibrikated by a then film of oil, figure below Ihe film contact k area 4 A andits thickpess is h place a linear velouty datibutien in the film, derive Asuming. an expression for the Ferminal' (zero accebaration) velotity hi block. of Dfind the terminal velocty of Ha blockk in frg belew,in the block masr is 6ky, A = 35cn, @ = 15° and the hlm is Imm thick SAE al at 20°C. %3D Liqaid of thickiness,h Block contact are,A

CA Hock of weight W sides down an inclined woite hibrikated by a then film of oil, figure below Ihe film contact k area 4 A andits thickpess is h place a linear velouty datibutien in the film, derive Asuming. an expression for the Ferminal' (zero accebaration) velotity hi block. of Dfind the terminal velocty of Ha blockk in frg belew,in the block masr is 6ky, A = 35cn, @ = 15° and the hlm is Imm thick SAE al at 20°C. %3D Liqaid of thickiness,h Block contact are,A

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The intesity of shear of an oil having viscosity = 1.2 poise and is used for lubricastion in the clearance between a 10 cm diameter shaft and its jouranl bearing. The clearance is 10 mm and shft rotates at 200 rpm.
06:20 all 29% MENG250 - Chapter.. 4-151. Currently eighty-five percent of all neck injuries are caused by rear-end car collisions. To alleviate this problem, an automobile seat restraint has been developed that provides additional pressure contact with the cranium. During dynamic tests the distribution of load on the cranium has been plotted and shown to be parabolic. Determine the equivalent resultant force and its location, measured from point A. 12 lb/ft 0.5 ft W. w = 12(1 + 2x) lb/ft 18 lb/ft
Using dimensional analysis obtain an expression for nusselt number in terms of Reynolds number and prandtl number
A- Womersley number (a) of a human aorta is 20 and for the rabbit aorta is 17, the blood density is approximately the same across the species. The values of viscosity were 0.0035 Ns/m² for the human and 0.0040 Ns/m² for the rabbit. The diameter of the aorta is 2.0 cm for the man, and 0.7 cm for the rabbit, estimate the heart rate beats per minute (bpm) for both species
The velocity Painciple luid flouing aner a. flat plate ie 4-2,whene U in in inclhes. Find 20 and 1, viscosity ginen by inches nd Shear Strie§ at sespectinely, If the fluid 5) Carbon tetrachloride clu occupies volume of0.001m3 nith a mass of 1.6kgat Defemmine its Density and Spezify yolume A तोe !e m ? ? a temp of2 0c.
A disk of radius R rotates at an angular velocity V inside adisk-shaped container fi lled with oil of viscosity μ , asshown in Fig. Assuming a linear velocity profi le andneglecting shear stress on the outer disk edges, derive aformula for the viscous torque on the disk.
A cylindrical tank shown below has a radius ? and a circular orifice at the bottom of radius ?. At time ? = 0 the liquid level in the tank is ho. (a) Use the Bernoulli equation to determine the relations between the orifice velocity ?o and the free surface velocity ?s (assume the surface velocity is not zero). (b) Use conservation of mass to determine the orifice velocity in terms of the free surface velocity. (c) Use the results in (a) and (b) to derive a differential equation for h(?). Note that ?s = − dh/dt. d) Separate variables and solve the equation for h(?) with the initial condition h(0) = ho (e) Determine how long it will take to empty the tank.
A Plan of sloping roof of a building is 48 m long and 25 m wide. The vertical height of roof is 5m and the intensity of rainfall is 60 mm/hour. Calculate the size of eve gutter, of down pipe, the number of down pipes and the distance between them? (Suppose using 125 mm Ø gutter (1/2 round)) 48m
f jon The pilot of a crippled jet was able to control his plane by throttling the two engines. The plane has a weight of 17000 lb and a radius of gyration of kg = 4.7ft about the mass center G. Originally the plane is flying straight at a speed of 1200 ft/s. Neglect the effects of 5000 lb as shown, determine: drag and the loss of fuel. If the thrust in each engine is altered to T₁ = 800 lb and T₂ Remark: The counterclockwise sense is the positive sense. 1.25 ft T₂ 1.25 ft T₁ 1:21:02 7
Q: Derive an equation for theoritical capillary rise between vertical parallel plates of length (L) and distance between them (w). plot the rise.
Fluid Properties-The difference in pressure between theinside and outside of a soap bubble wasobserved to be 1.6 N/m2. If the surfacetension of the liquid is 40 dyne/cm, what will be the diameter of the bubble in meters?
A cube of side (a) and mass (M) is initially sitting fully submerged at the bottom of a container filled with a liquid of kinematic viscosity v and density p. The container has a square cross-section of side (a+a/5) and the cube is sitting right at the middle of the container base. (a) A force (F) starts pulling the cube up at a constant velocity (U). Develop an expression for the force in terms of (U, M. a. g, p and v). You may assume that the velocity in the gap between the cube's sides and the container walls is linear. The expression for (F) is to be valid as long as the cube remains submerged. (b) After the cube reaches the water surface, it continues to be pulled up by the same force. Develop a differential equation for the variation with time of the fraction of the cube that is submerged in water.