Answer only last two parts. c,d A force sensor has a mass of 0.5 kg, stiffness of 200 N/m and adamping constant of 6.0 N s m".Calculate the steady-state sensitivity, natural frequency anddamping ratio for the sensor.b. Calculate the displacement of the sensor for a steady inputforce of 2 N.c. If the input force is suddenly increased from 2 N to 3 N,derive an expression for the resulting displacement of thesensor. Assume that the sudden change is being modeledusing step-function.d. Estimate the values of maximum overshoot (in %) andsettling time (in s).

Given, m = 0.5 kg Stiffness k = 200 N/m damping constant λ = 6 N s m-1 Step Height = 1 ( change in…

c. If the input force is suddenly increased from 2 N to 3 N, derive an expression for the resulting displacement of the sensor. Assume that the sudden change is being modeled using step-function. d. Estimate the values of maximum overshoot (in %) and settling time (in s).

c. If the input force is suddenly increased from 2 N to 3 N, derive an expression for the resulting displacement of the sensor. Assume that the sudden change is being modeled using step-function. d. Estimate the values of maximum overshoot (in %) and settling time (in s).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A4C) Concurrent forces .. O a. act on the same line. O b. None of the these O C. act on the same plane O d. pass through same point. a DI
Solve erf only
Each cylinder of six cylinder internal combustion engine has a diameter of 60 mm and a stroke length of 400 mm. What is the engine capacity in litres? Give your answer to 2 decimal places.
4. What is the cost of 23' of cable if 34' costs $76.00? (round to nearest dollar)
*NOTE ON INSTRTUCTUONS AND HINTS
Fluid Force. A swimming pool is filled with fresh water to a depth of 7 feet measured at the deep end. There is not enough water in the pool to reach the shallow end. Assume that the pool is constucted using right angles, except where the bottom of the pool meets the end walls. Use Ah for the height of a typical strip across the face of the wall. 6. The weight density of water is 62.4 lb/ Your anwers should have units: pounds. 4 ft 18 ft 24 ft Declare your variable(s) here. Show your reasoning below: a) find the force on the typical horizontal strip (red) ? b) write an integral for the total force on the (left) wall of the pool
A D P L3 E B to L1 L2
(b) A plastic rod AB of length L = 510 mm has a diameter d, = 30 mm as shown in Figure Q2(b). A plastic sleeve CD of length c = 300 mm and outer diameter d2 = 45 mm is securely bonded to the rod so that no slippage can occur between the rod and the sleeve. The rod is made of an acrylic with modulus of elasticity E1 = 3.1GPA and the sleeve is made of a polyamide with E2 = 2.5GP . (i) Calculate the elongation & of the rod when it is pulled by axial forces P=15KN . (ii) If the sleeve is extended for the full length of the rod, what is the elongation? (iii) If the sleeve is removed, what is the elongation?
I need the answer as soon as possible