c. A deep-water wave of period 8.5 sec and a height of 5m is travelling to the shoreline over a sandy seabed of slope 1:100. Assuming that the seabed contours are parallel, find the height and depth of the wave when it breaks. At the break point, KR is expected to be 0.88. Only carry out one iteration.

c. A deep-water wave of period 8.5 sec and a height of 5m is travelling to the shoreline over a sandy seabed of slope 1:100. Assuming that the seabed contours are parallel, find the height and depth of the wave when it breaks. At the break point, KR is expected to be 0.88. Only carry out one iteration.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q3/ The curved hard submerged surface ab shown in Figure No. (3). 1- Find the value of pressure at each of the points a, b, c and d. 2-Draw the pressure distribution diagram on the horizontal submerged surface ca. Mention what is its SHAPE. P=100(KN/m²) water h2=8m hi =10m a Fig.(3)
Irrigation Engineering A gravity dam 95 m high with a free board of 1 m and the upstream face slope is 0.20 : 1. Determine the hydrodynamic earthquake pressure and its moment at a joint situated at 45 m below the maximum water surface. Taking the earthquake coefficient as 0.10
Stress Analysis of Trusses using method of sections. pls answer within 30 mins
Explain Snell’s law with respect to seismic waves. For figure 3. Find out θ2, θ3, θ4 and θ5, for the given velocity model.
For a reservoir having fetch of 36 km and wind velocity of 16 km/hr, the height of wave from top of crest to bottom of trough (in m) will be
NEED FAST
Describe the construction process for over-excavation of a building:
3. Three concurrent and coplanar forces in equilibrium is as shown in the figure. a. What is the value of the angle 0? b. What is the value of the angle a? c. What is the value of the horizontal component of the 94.5 KN force? 50 KN Ө a 94.5 KN 60 KN
It is proposed to design a ship. The proposed ship (prototype) is has a length of 150 m and wetted surface area of 2000 m² with a speed of 40 km/hr. A model of 1:20 is to be tested in the laboratory at a velocity corresponding to the wave resistance. The total drag on the model is 50 N. Determine the following (1) Wave resistance drag of the model. 0.074 Given friction drag, F, C, PAV², C.- = for R 2 × 10¹ Pmode = 1000 kg/m³, Pr = 1020 kg/m³, prototype V, 1.125 x 10 m²/sec, v = 1.11 x 10 m²/sec. m
For an earthquake of magnitude M=7.0 and depth 25 km, calculate the peak ground acceleration at a site 50 km from the epicentre using the attenuation relationships for Europe, Japan, and western North America (randomly- oriented horizontal components). The fault mechanism is normal and the seismic waves travel through a thick layer of rock (v=780 m/sec). Compare the results with the prediction of the world-wide attenuation relationship. Plot the curve of the above attenuation relationships for M=7 and comment on the plots.
Wave runup on sloping sandy beaches A section of the Shell Beach area, known for its beauty and turtle nesting, has a slope of 5.71 degrees. The unrefracted deepwater wave height in the area is 1.85 m. The water depth at the toe of the slope is 5.50 m. The wave period has been determined to be 4 seconds. Determine the runup on the beach face.
What is the height of wave which is likely to be generated by a wind of 62.5 km/hr in a reservoir having a fetch of 40 km? A 1.68 m B 1.60 m C 1.58 m D 1.50 m