The cylindrical buoy floats in salt water (density 1030 kg/m³) and has a mass of 780 kg with a low center of mass to keep it stable in theupright position. Determine the frequency f, of vertical oscillation of the buoy. Assume that the water level remains undisturbedadjacent to the buoy.0.79 mAnswer: fn =Hz

Answered: Image /qna-images/answer/3d498576-243d-46f8-9881-274b42cd8c79.jpg

Answered: he cylindrical buoy floats in salt…

he cylindrical buoy floats in salt water (density 1030 kg/m³) a right position. Determine the frequency f of vertical oscillat jacent to the buoy. 0.79 m nswer: fn = Hz

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: R: Derive an equation for thearitical capillary rise between vertical parallel plates of length (L)…

A: as drive the expression of the capillary tension the equilibrium between tension force and weight if…

Q: Problem # 8: The five forces acting at the end of the boom satisfy the condition of equilibrium.…

Q: A Rectangular channel (n = 0:011) 18 m oide to carry wwater at The slope d the channel s 0.00078 (9)…

Q: A 1.5-kg slender rod rotates freely about point O. The ased from rest when the rod is in the…

Q: For each of the three floating bodies, determine the buoyant force (kN) exerted by the liquid. Each…

A: Given Data Specific gravity of liquid = 0.8 Depth of submergence (h) = 1.5m Find Buoyant force…

Q: The system is released from rest in the position shown with the spring unstretched. The collar A…

A: Given:displacement of collar Ax=0.62 mspring constantk=885.25 N/mmass of collar Ama=48 kgmass of box…

Q: A 6-cm-diameter horizontal stationary water jet having a velocity of 40 m/s strikes a vertical…

Q: A closed cylindrical tank 1.845m high and 0.945m in diameter contains water of height 1.35m. When…

Q: The 2.0-kg collar is at rest in position A when the constant force Pis applied as shown. Determine…

A: Given, Mass of the collar, say M = 2 kg Force applied on the collar, P = 33 N Vertical distance…

Q: For the built-up tee-shape (Ex= 350 MPa) shown: a). determine the yield moment My with respect to…

Q: Problem03. The beam supports a load varying uniformly distributed from an intensity of w lb/ft at…

A: Given data:

Q: Consider a thin, flat, uniform, homogeneous rectangular plate of sides 1200 x 1500 mm, and mass 5…

A: Given Rectangular Plate of, Length, L = 1200 mm Breadth, B = 1500 mm Mass, M = 5 Kg

Q: Determine the natural frequency of the system shown in the figure.

A: Given data: M = 25 kg E = 200 GPa I = 5x10-7m4 k = 5 kN/m ΕΙ = 4 m

Q: A vertical conduit is carrying oil (S = 0.95). A differential mercury manometer is tapped into the…

A: Given: The specific gravity of the oil is 0.95. Consider the figure,

Q: Q3) A closed 0.4 m diameter cylindrical tank completely filled with oil (SG=0.9) rotates about its…

A: D = 0.4 m SG = 0.90 = 40 rad/s

Q: C hinge SALT WATER WATER 4m 60° A Gate 5m

A: Given Data:Specific Weight = 24kN/cu.mSGw=1.03Inclined Angle = 60°L=2.5m

Q: Determine the magnitude of F so that the resultant couple acting on the beam is 1.5 kNm clockwise F4…

A: as per our guidelines we are suppose to solve only one question prepost . if multiple question are…

Q: B 12 m No. 3 Please note, this is an Equilibrium problem. 8 m 10 m 1.2 m A O C 200kg P 2 m SAMPLE…

A: m=200kgtwo cables AB and ACFINDmagnitude of P and the tension in each cable

Q: A cylindrical gate with surface XY is supported by a hinge at point 1. The length of the gate…

A: Find horizontal component of force,Fx=?

Q: A velocity field is given ty V = axi-ayi , a= _(a) Detemine The eqiuation for Streamline passmg…

A: Velocity Field The velocity field is explained as the distribution of velocity in a given space.…

Q: 2. 2. A rectangular pontoon 10 m by 4 m in plan, weighs 280 KN and floats in sea water of density…

A: Procedure to find the metacentric height: Find the weight of water displaced. Calculate the volume…

Q: d otch-yoke o reciprocating motion of the Rod BC. If OA is rotating at 5 rad/s and has an angular…

Q: Problem 2: The 2-kg collar is released from rest at A and slides down the inclined fixed rod in the…

A: Solution-The given values are as follows Collar Mass=2kgCoefficient of kinetic friction=0.4To…

Q: For the structure shown below, if E is constant, what is the distribution factor at ?joint B (DFBA)…

A: Finding out distribution factor.

Q: Q.17 For a liquid velocity u varies with y as follows U = 3y - 6y² 2 U = m/s and y is in meter for Y…

A: Given data- Velocity variation- U=3y-6y2, Viscosity- μ=1 poise, To Find- The shear stress in the…

Q: Example 37: Replace the force and couple moment system acting on the beam in Figure (a) by an…

A: Solution Given that

Q: A cylindrical caisson having an outside diameter of 7m floats in sea water sg=1.03 with its axis…

A: Given, Outer diameter of caisson (D) = 7m Specific gravity of sea water= 1.03 h= 6m Our aim is to…

Q: a) L Question 7: A massless beam ABC of span L and con- stant flexural rigidity EI is simply…

Q: Problem (2) A uniform slender rod of mass m is released from rest when 0 = 0°. Determine the…

A: Free body diagram

Q: l-and-socket connection in the horizonta ate the magnitudes of the forces P ar e ball end B of the…

A: Find…

Q: In the cage system below; It is under the effect of a P-150 kN load acting at an angle of 0=75 °…

Q: A figure shows a differential manometer connected at 2 points A and B. At A pressure is 100 kn/m^2.…

Q: The cross-sectional area of each clamp forming a fixed-supported cage system from points C and D…

Q: Q.134 The figure shows a cylinder of 4 m diameter in equilibrium. Calculate the resultant pressure…

A: The given figure consist of only water Since γw = 10 KN/m3 So, S = 1 for water ABCD part is…

Q: The system is released from rest in the position shown with the spring unstretched. The collar A…

A: Given:Mass of the box B, mb=68 kgmass of the collar A, ma=48 kgspring constant, k=885.25 N/m

Q: Estimate the fundamental frequency of the lateral vibration of a shaft carrying 3 rotors (masses),…

A: The given figure is shown below:

Q: Show that the motion of a critically damped system due to initial displacement u(0) and nitial…

A: Introduction- Damping is an impact inside or on an oscillating system and reduce or prevents its…

Q: the equilibrium position, the 30 kg cylinder causes a static deflection of 50 mm in the coiled…

Q: What weight Wg will cause the system to be in equilibrium? Neglect all friction, and state any other…

Q: A closed cylindrical tank 1.845m high and 0.945m in diameter contains water of height 1.35m. When…

Q: A mass of 8 kg is dropped onto the middle of a pinned-pinned beam with a velocity of V-1m/s, as…

A: mass m= 8kg velocity x= 1 m/s E= 213x109 N/m2 L=2.6m I=3.6x10-6

Question

The cylindrical buoy floats in salt water (density 1030 kg/m³) and has a mass of 780 kg with a low center of mass to keep it stable in the
upright position. Determine the frequency f, of vertical oscillation of the buoy. Assume that the water level remains undisturbed
adjacent to the buoy.
0.79 m
Answer: fn =
Hz

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the frequency

VIEW

Step 2: Determine the frequency

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The five forces acting at the end of the boom satisfy the condition of equilibrium. Determine the values of T1 and T2. 4 m_C 6m T2 iB T1 30°f A 58 kN y T3 D 25 kN 8 m
11.7 (A/B). A solid shaft carrying a flywheel of mass 100 kg and radius of gyration 0.4m rotates at a uniform speed of 75 rev/min. During service, a bearing 3 m from the flywheel suddenly seizes producing a fixation of the shaft at this point. Neglecting the inertia of the shaft itself determine the necessary shaft diameter if the instantaneous shear stress produced in the shaft does not exceed 180 MN/m². For the shaft material G= 80 GN/m². Assume all kinetic energy of the shaft is taken up as strain energy without any losses. [22.7 mm.]
ASAP
50 N Fig 1 4m 20 N/m 10 m ). Determine 2). Determine the value oF 0). Max the valwe of R1 A1 82 B2 value oF Shear 4). Max Value OF Moment Đ). Deplection at point 8
SITUATION IV (9-10) The beam AB shown in the figure supports a uniform load of intensity 3000N/m acting all over half the length of the beam. The beam rests on a foundation that produces a uniformly distributed load W over the entire length. A ㅏ Option 1 0.80 m 2000 N 9. Compute the value of Vato be in equilibrium. 1500 N 1250 N 3000 N/m 1750 N W 1.60 m +0.80 m they 0987 BERNABANDER B
1.) The ordinates of an influence line for reaction of a simply supported beam will exceed 1.0 ... Explain your answer why TRUE or why FALSE Choices: a. TRUE b. FALSE 2.) When Plotting an influence line, what is the abscissa?Choices: a.) Reaction Values b.) Moment Values c.) shear Values d.) x distance from origin Thank yoouu!!
Problem 5: (a) Replace the loading acting on the beam by an equivalent resultant force FR and couple moment (MR)B at point C. (b) This time replace the loading on the beam by an equivalent resultant force only (FR =?) and specify where this force acts, measured from C (x' = ? ). (Note: Ignore the depth of the beam) 15 kN 10 kN/m 30 kNm В C D -2.0 m- 2.0 m 2.0 m 1.0 m'
3.58 As shown, a round viewing window of diameter D = 0.8 m is situated in a large tank of seawater (S = 1.03). The top of the window is 1.2 m below the water surface, and the window is an- gled at 60° with respect to the horizontal. Find the hydrostatic force acting on the window and locate the corresponding CP. Sea water h 60° PROBLEM 3.58 Window
SITUATION 3: Open cylindrical tank 1 m in diameter and 2.5 m high is three-fifth full of water. If the tank is rotated about its vertical axis, 6. Which of the following gives the angular velocity in rpm so water will not spill out? а. 105 С. 120 7. Which of the following gives the angular velocity in rpm so that the depth of water at the center is zero? а. 134 C. 138 8. Find the angular velocity in rpm so that water at the bottom is 20 cm away b. 145 d. 130 b. 125 d. 149 from the center. а. 155 C. 146 b. 160 d. 140
6/47 A block of mass mo is placed between the vertical wall and the upper end A of the uniform slender bar of mass m. If the coefficient of static friction is µg be- tween the block and the wall and also between the block and the bar, determine a general expression for the minimum value 0min Oof the angle 0 for which the block will remain in equilibrium. Evaluate your expression for the conditions µ = 0.5 and %3D т (a) mo 0.1, m (b) mo 1, and m (c) mo 10. %3D For each case, state the minimum coefficient of sta- tic friction (u)B necessary to prevent slippage at B. Ans. (a) 0min = 61.2°, (µ,)B = 1.667 (unusual!) (b) 0min = 45°, (µ)B = 0.667 (c) 0min = 10.30°, (µ,)B = 0.0952 %3D %3D %3D %3D %3D mo m (Ha)B Problem 6/47
Deflection at Q if the float at Q is eliminated and the reaction at Q if the float is placed back to its original position, are respectively P 0.379 m and 45.30 KN 0.781 m and 45.30 KN 0.651 m and 43.60 KN P = 80 KN 0.272 m and 43.60 KN Q+ Pontoons 15 m² each 8 mi 8m. w = 9.81 KN/m³ EI 180000 KN.m² R