C t V sine R2 Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and reactance of the inductor j2 ohm. The supply RMS value is 196 volt and phase is 30 degree. Let lc be the current through the capacitor from left to right and V₁ be the voltage across the inductor from top to bottom. RMS value of lc = ampere Phase angle of lc = RMS value of V₁ = volt Phase Angle of VL = degree (normalized to lie in range [-180,+180] degree only) R1 degree

C t V sine R2 Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and reactance of the inductor j2 ohm. The supply RMS value is 196 volt and phase is 30 degree. Let lc be the current through the capacitor from left to right and V₁ be the voltage across the inductor from top to bottom. RMS value of lc = ampere Phase angle of lc = RMS value of V₁ = volt Phase Angle of VL = degree (normalized to lie in range [-180,+180] degree only) R1 degree

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A 120-V rms 60- Hz source supplies two loads connected in parallel, as shown in the figure. a) Find…

A: We are given,a) calculate power factor of parallel combinationb) calculate capacitance connected in…

Q: An inductor has an inductive reactance of 250 V when connected to a 60 Hz line.What will ba the…

A: The property of a conductor by which it opposes the change in electric current flowing through it is…

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

A: Given, Capacitance, C=10 μF. Supply voltage, V=110 V. Frequency, f = 50 Hz.

Q: 10. What is the result of decreasing the capacitance of a capacitor? A. Decreased capacitive…

A: In this question we need to select a correct option

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: A 60 Hz sinusoidal voltage with an RMS value of 440 V is applied to a TRIAC voltage regulator. The…

A: it is asked to find the output DC voltage of given TRIAC voltage regulator

Q: Determine the value of its capacitance.

Q: An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is…

A: Given V=12VC1=7.3 nCd1=8 cmd2=3 cm

Q: Draw rough sketches showing the following: a. A current which lags the voltage by 60°. b. A current…

A: Phasors rotates in anti clockwise. Current lags the voltage means current comes after voltage.

Q: An inductor is connected in parallel with a 6540 resistor and a function generator. The applied…

A: Let current through the resistor be IR and current through the inductor is IL and I be total source…

Q: 6. The root mean-square(effective) voltage V. =√√√√²& 2 dt rms . Find the value of rms if where T is…

Q: Determine the total parallel inductance for the following coils in parallel: 75 μH, 50 μΗ, 25 μΗ,…

Q: The reactance of an inductor is 550 ohm and the frequency of input ac is 50 Hz. What will be the…

A: If XL represents the reactance of an inductor and if f represents the frequency of the input ac,…

Q: b) Determine the voltage ??(??) and current ??(??) sinusoidal forms. Sketch one cycle of the…

A: Given;I=100∠-20°mAVs=120∠30°Vf=60 HzC=35μFDetermine;voltage=?current=?sinusoidal wave form

Q: QUESTION 8 Ten volt (10V) magnitude sinusoidal voltage of frequency 1MHz is applied across a 100 Ohm…

A: In this question, we need to choose the correct option. What is voltage across the capacitor.

Q: coil of power factor 0.4 is in series with a 50-μF capacitor. The p.d. across the coil is equa to…

Q: A 60 Hz sinusoidal voltage with an RMS value of 240 V is applied to a TRIAC voltage regulator. The…

A: Given, TRIAC voltage regulator having RMS value of input signal, Vrms = 240V Frequency, f = 60Hz…

Question

C
V
R2
sine
Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and reactance of the inductor j2 ohm. The supply RMS value is 196 volt
and phase is 30 degree. Let Iç be the current through the capacitor from left to right and V₁ be the voltage across the inductor from top
to bottom.
RMS value of lc =
ampere
Phase angle of lc =
RMS value of V₁ =
volt
Phase Angle of VL =
degree (normalized to lie in range [-180, +180] degree only)
R1
ww
degree

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the values of resistance R and inductance L. need help on question C ，urgent
3- Please I want answer of this Electrical Principles question. Thanks
A voltage wave of 250 kHz has a Vmax-5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This voltage waveform has been applied across a 2.5 µH inductor for a very long time so that steady state has been achieved. Diagrams of the wave parameters and circuit are shown in this figure: L What is the average voltage of this wave? Average voltage = 35 V Voltage (arb, unit) 1.25 Minimum current: -3.5€ Amps 1 0.75 0.5 0.25 0 4.25 05 Have you integrated the wave over full cycle? 4.75 4 -1.25 Vmax 0.5 Vmin What is the average current flowing through the inductor? Average current = 3.56 A 15 Period/s On average, there is no power consumed by the inductor. Have you considered this? What are the maximum and minimum currents that flow through the inductor? Maximum current: 0.50 Amps D= 25 TH TH Have you used the relationship for current and voltage in an inductor? Have you considered the slope of the current wave?
Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:
b) Determine the voltage ?(?) and current ?(?) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors ?L, ?r and ?c. e) Sketch the phasor diagram showing ?s, ?r, ?r, ?c and ?.
A 90 kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 30 mV . When this voltage is applied across the terminals of a capacitor, the resulting steady-state current has a maximum amplitude of 629.60 μA . Pt A. What is the frequency of the current in radians per second? Pt B. What is the phase angle of the current? Pt C. What is the capacitive reactance of the capacitor?
Find the equivalent capacitance for the following circuit. Round the final answer to the nearest tenth of a decimal point. Example 12.4uF or 2.7pF. 16uF 20uF 4uF 4uF 10UF 10UF
An inductor has an inductive reactance of 250 V when connected to a 60-Hz line. What will be the inductive reactance if the inductor is connected to a 400-Hz line?
Question in the attachment
A 240 volt 60 Hz voltage source is connected to an RLC parallel circuit, the true power is 260 watts. The inductor has a reactive power of 760 VARs, and the capacitor has a reactive power of 360 VARs. a. Find the power factor for this circuit. b. Calculate the capacitance of the capacitor.
58. Two capacitors, a 20 µF and a 30 µF, are connected in series to a 60-Hz source. What is the total capacitive reactance? a. 117.96 N b. 221.04 N c. 253.05 N d. 333.16 N