c) Consider a U-tube whose arms are open to the atmosphere. Now equal volumes of water and light oil (density=49.3 kg/m³) are poured from different arms. Air Oil Water 30 in A person blows from the oil side of the U-tube until the contact surface of the two fluids moves to the bottom of the U-tube, and thus the liquid levels in the two arms are the same. If the fluid height in each arm is 30 in, determine the gage pressure the person exerts on the oil by blowing.

c) Consider a U-tube whose arms are open to the atmosphere. Now equal volumes of water and light oil (density=49.3 kg/m³) are poured from different arms. Air Oil Water 30 in A person blows from the oil side of the U-tube until the contact surface of the two fluids moves to the bottom of the U-tube, and thus the liquid levels in the two arms are the same. If the fluid height in each arm is 30 in, determine the gage pressure the person exerts on the oil by blowing.

Name: c) Consider a U-tube whose arms are open to the atmosphere. Now equal
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: c) Consider a U-tube whose arms are open to the atmosphere. Now equal volumes of water andlight oil (density=49.3 kg/m³) are poured from different arms.AirOilWater30 inA person blows from the oil side of the U-tube until the contact surface of the t

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Because of a break in a buried oil storage tank, ground water has leaked into the tank to the depth L'= 2 ft. The densities of the water and oil are, respectively, 62 and 55, each in Ib/ft3. Standpipe open to atmosphere Oil L' Water Determine the pressure at the oil-water interface and at the bottom of the tank, each in Ibf/in². (gage). Assume L = 17 ft. Let g = 32.2 ft/s?. Determine the pressure at the oil-water interface, in Ibf/in?. (gage). Palgage) = Ibf/in?.
(e) The piston of a cylinder-piston device has a mass of 72 kg and a cross- sectional area of 0.06 m², as shown in Figure Q1(e). The depth of the liquid in the cylinder is 2.4 m and has a density of 1660 kg/m³. The local atmospheric pressure is 1.25 bar, and the gravitational acceleration is 9.8 m/s?. Determine the pressure at the bottom of the cylinder.
Q3.1. A two-fluid manometer is used to measure the pressure difference for flowing blood in a laboratory experiment as shown in Figure 3.1. Calculate the pressure difference between points A and B in the fluid. Assume that the density of blood is 1050 kg/m3 and the density of water is 1000 kg/m3. Water d2 = 190 mm d, = 500 mm d3 = 275 mm A Blood Figure 3.1
b. Two cylinders are filled with liquid water (p = 998 kg/m³), and connected by a pipe line with a closed valve. Cylinders A (inside diameter = 42.75 cm) and B (inside diameter = 55 cm) contain 125 kg and 450 kg of water, respectively. The height h as indicated in Fig. 3 is 0.85 m. Determine the pressure (in kPa) of cylinder A and cylinder B on either side of the valve. If the valve is opened such that water flows to an equilibrium between the two cylinders, find the final pressure (in atm) at the valve location. Assume Po= 100 kPa. k Po B g Figure 3 Po A
Q2. Design and plot a hydraulic system for drive and control aircraft flap to overcome 500 N aerodynamic forces with the following specifications:- The actuator single acting cylinder with bore diameter 25 cm , smooth pipes line has diameter and total length 15 mm and 12 m respectively, six elbows (K = 0.9), if average velocity of the oil in the pipes 20 m/s and total pressure losses across control valves and other accessories 1.4 bar. Determine total pressure pump required for hydraulic circuit. (Note:- poil =880 kg/m², voil= 64.2 mm/s)
EX.4: A vacuum gage connected to a tank reads 30 kPa at a location where the atmospheric pressure is 98 kPa. What is the absolute pressure in the tank?
An open vessel of water accelerates downward a 35-degree plane at 7 ft/s2. What is the angle in degrees that the water surface makes with the horizontal?
Home work/1: A fan with 24-in-diameter blades moves 2000 cfm (cubic feet per minute) of air at 70°F at sea level. Determine (a) the force required to hold the fan and (b) the minimum power input required for the fan. Choose a control volume sufficiently large to contain the fan, with the inlet sufficiently far upstream so that the gage pressure at the inlet is nearly zero. Assume air approaches the fan through a large area with negligible velocity and air exits the fan with a uniform velocity at atmospheric pressure through an imaginary cylinder whose diameter is the fan blade diameter?
Water is contained in both sides of the cylinder system shown below and the valve is closed. If the pressure on the right hand side of the valve is 119.6 kPa, what is the height in tank B, i.e. what is hp 1? Assume that the atmospheric pressure is 100 kPa, the acceleration due to gravity is 9.807 m/s² and the density of water is 1000 kg/m³. A Po B ha,1=1.5 m Water Water hg,1 1.0 m 0.5 m Pval,left Pyal,right A) 1.0 m B) 1.5 m C) 2.0 m D) 2.5 m
You turned on the tape and fill you bath tub withwater running at 0.5 liter/s. While doing that thephone rang and you were talking away. The drainhole was not plugged. It drained at a rate of 0.4liters/s.How long could you talk before the tuboverflowed?
3.13 Determine the gage pressure in kPa at point a, if liquid A has 5S SG =1.20 and liquid B has SG=0.75. The liquid surrounding point a is water, and the tank on the left is open to the atmosphere. Liquid A 0.9m 0.25 m Water 0.125 m Jo.4r - Liquid P3.13
A differential manometer is connected at the two points A and B as shown. At B air pressure is 9.84 N/cm2 (abs), find the absolute pressure at A using the following data. - Specific Gravity of oil as 0.89; - Distance, C = 22 cm; - Distance, D = 104 mm; Distance, E = 0.76 m. AIR WATER :A E OIL D MERCURY Sp. gr. = 13.6 רנ ווא ודצד