At time ? = 0, the height of water in the tank is ℎ0. Find an expression for the height as a function of time, ℎ(?). As part of a processing of biofuels, water is pumped into a circular tank with a diameter Dt.as shown in Figure Q3. The flowrate into the tank is Q₁ and the flowrate out is Q₂. Whenthe vessel is heated, water evaporates. The average velocity at which the vapour risesacross the entire tank is vevap-You may assume that water has a density of Pw, and vapour has a density of Pv.Acceleration due to gravity is g. 2₁VevapQ₂=>D₂Figure Q3: Water being pumped through a heated evaporation tank.

For solution referbelow images.

Answered: At time ? = 0, the height of water in…

Engineering

Mechanical Engineering

At time ? = 0, the height of water in the tank is ℎ0. Find an expression for the height as a function of time, ℎ(?).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 60 cm above the pipe B. The height of oil in right limb is 50 cm. Also, the mercury level difference is found in right limb as 50 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. The difference of pressure between two pipes (PA- PB) (Unit is in kPa) = Equivalent to Water head in mm =
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 35 cm above the pipe B. The height of oil in right limb is 40 cm. Also, the mercury level difference is found in right limb as 80 cm. Find 1-The difference of pressure between two pipes (PA-PB) (Unit is in kPa) = 2-Equivalent to Water head in mm =
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 65 cm above the pipe B. The height of oil in right limb is 45 cm. Also, the mercury level difference is found in right limb as 60 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. The difference of pressure between two pipes (PA-PB) (Unit is in kPa) = Equivalent to Water head in mm =
Subject: Hydraulics Topic:Accelerated Liquids in Relative Equilibrium A cylindrical bucket, 35 cm deep and 30 cm in diameter contains water to a depth of 30 cm. A man swings this bucket thru a vertical plane, the bottom of the bucket describing a circle having a diameter of 2.15 m. What is the minimum speed of rotation that the bucket can have without permitting water to spill?
1. Find the density of an oil filled in the liquid column as shown in figure. Given that absolute pressure at the bottom is 600 kPa, atmosphere pressure is 1.0132 bar. where X=4m; Y = 4m, Z=1.75m. water oil Y Mercury The density of the oil = (unit in kg/m³) =
A vessel is filled with oil (ρoil = 900 kg/m3) up to 1 m of its height. It is 3m wide, 2m high and 10 m long.Find the following :A. The maximum horizontal acceleration that can be charged to the vessel without spilling anyoil.B. If this vessel is closed and is completely filled with oil and accelerated horizontally at a rate of 3 m /s2 .B.1. The total force acting at the rear wall and at the front wall of the vessel.B.2. The accelerating force on the fluid mass.
A tank of water 5m deep receives a constant upward acceleration az= 4 m2/sec, the gauge pressure at the tank bottom in pascal is: *
In the figure, pressure gauge A shows 1.5 kPa (gauge). Fluids are at 20 ° C. Determine the elevation z in meters of the level at which to find the liquids in tubes B and C.
Find the value of Pressure (MPa), volume (m^3/kg), enthalpy, and internal energy if the T=321 ℃ and s=5.544kJ/(kg-K) (Note: 1. Show the data every table especially if the state of steam is superheated or subcooled)
3. The reading of an automobile gage is proportional to the gage pressure at the bottom of the tank as shown. The tank is 32 cm deep. Unit weight of gasoline is 6670 N/m³ and that of air is 11.8 N/m³. Unit weight of water is 9790 N/m³. Vent Air Gasoline Water a. Determine the gage reading when the tank is full of gasoline. b. How many cm of air remains at the top when the gage indicates full and the tank is contaminated with 3 cm of water? c. Determine the pressure at the interface of the gasoline and water when the gage indicates full.
if air is at pressure of 2200 lb/ft^3, and at a temperature of 800°R, what is the specific volume?
The U-tube of Figure A contains mercury (s 13.6) and given an acceleration of 1.22 m/s to the right What is the depth in AB and the pressures at B. G and D? 8. If the U-tube of Figure A is rotated about an axis through HG so that the linear velocity at B is 3 m/s, find the pressures at B and G. 9. mercury 30 cm 30 cm -30cm FIGURE