(c) A 5O0KVA. 1100v. SOHZ. star connected. three- phase synchronous generator has per phase values in ohms for armature resistance and synchronous reactance as 1.0 and 1.5 respectively. () Determine the armature current (i) Determine the voltage regulation for a 0.9 lagging power factor. (i) Determine the voltage regulation for 0.8 leading power factor. (d) Discuss TWo advantages and TWo disadvantages of a permanent. magnet synchronous generator oer an electrically excited synchronous ncrator

(c) A 5O0KVA. 1100v. SOHZ. star connected. three- phase synchronous generator has per phase values in ohms for armature resistance and synchronous reactance as 1.0 and 1.5 respectively. () Determine the armature current (i) Determine the voltage regulation for a 0.9 lagging power factor. (i) Determine the voltage regulation for 0.8 leading power factor. (d) Discuss TWo advantages and TWo disadvantages of a permanent. magnet synchronous generator oer an electrically excited synchronous ncrator

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A synchronous generator having no-load frequency of 51HZ and droop constant of 0.5Hz/MW is…

Q: What is the efficiency of the generator at these conditions?

A: It is given that: VL=13.8 kVMVA=50cosϕ=0.9f=60 HzXs=2.5 ΩRa=0.2 ΩPF&W=120 VPcore=1.5 MWPstray=0…

Q: A 3-phase, Y-connected synchronous generatorisrated 15 MVA, 13.8 kV. Its resistance is negligible,…

A: An alternator/Synchronous generator is a type of electrical machine that converts mechanical energy…

Q: A 3-phase, Y-connected synchronous generatorisrated 15 MVA, 13.8 kV. Its resistance is negligible,…

A: An alternator/Synchronous generator is a type of electrical machine that converts mechanical energy…

Q: determine (a) bus frequency (b) load on each machine.

Q: The sum of the armature reactance and.............reactance is the reactance of the synchronous…

A: ARMATURE REACTANCE AND LEAKAGE REACTANCE The armature reaction reactance and the leakage reactance…

Q: A: A synchronous generator of supplies a motor of 50 MVA, 22 kV, and 0.2 pu transient reactance. The…

A: A synchronous generator of 100 MVA, 22 kV, and 0.25 pu transient reactance supplies a motor of 50…

Q: The reactance's of the alternator during the periods of the subtransient, transient and steady state…

A: As damper winding time constant is very less so damper winding is out of circuit at the end of the…

Q: 5) The method (s) to improve the Power Factor: a. Use of synchronous motors. b. Use of synchronous…

A: The explanation is as follows.

Q: A 50HZ, synchronous generator is connected to infinite bus through a transmission line. The pu…

Q: Problem 3: An alternator and a synchronous mo- tor each rated for 80 MVA, having sub-transient…

A: Synchronous Motor: It is an electric motor in which RMF of stator and RMF of rotor get locked and…

Q: Q6) A three-phase synchronous generator 4.6-KV and 500-KVA and 60-HZ and 4 poles with star…

A: Given:3-phase synchronous generator, 4.6 kV, 500 kVA, 60 Hz, 4 poles, star connection, synchronous…

Q: 7) A 2-pole three-phase 50Hz 36 stator slots synchronous generator where the coil spans for 0.8889…

A: In this question, we need to choose the correct optiondetermine the coil pitch and winding…

Q: A 760-kVA, 2300-V, three-phase, Y-connected, synchronous generator is operated at its rated speed to…

A: For given generator S=VA rating =760 ×103 V =…

Q: synchronous machine is

A: According to company policy expert can solve only 3 subparts, other subparts u need to again summit…

Q: A 50HZ, synchronous generator is connected to infinite bus through a transmission line. The pu…

A: Given internal voltage = 1.2 P.u. Terminal voltage = 1p.u. Total reactance = 0.6 p.u.

Q: 2 What is the efficiency of the generator at these conditions? * Your answer

A: ##2) The Efficiency of the synchronous generator can be obtained as follows

Q: A 3-phase, star- connected alternator is rated at 15000KVA, 11LV. The armature resistance is 1.5…

Q: The motor draws no-load Current of (8A) with A Three- phase, 600 V, 50 Hz, De lta Conneeted SCIM,…

Q: Write a report on test Zero Power factor characteristics and loss measurement of Synchronous…

A: consider the given question;

Q: Explain the Brush less excitation scheme of Synchronous generator with Pilote excitor. Also identify…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: A star connected 3 phase wound field synchronous generator with a synchronous reactance of 20 Q is…

Q: A 50 kVA, 500 V, single phase alternator gives 700 V on open circuit at the field current of 15 A.…

Q: Outline with the aid of a suitable diagram the necessary power conversion stages required to…

A: b) Power conversion stages in PM synchronous generator Permanent magnet synchronous generator can…

Q: ABB company manufactures three phase, 10 kVA, 240 V, 60HZ, 6 pole wye connected synchronous…

Q: The symmetrical fault occurs in the terminals of the synchronous generator. Find the direct axis…

A: When a symmetrical fault occurs in the terminals of a synchronous generator, then during the…

Concept explainers

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.

Question

(c) A 500KVA, 1100V, 50HZ, star connected, three-phase synchronous
generator has per phase values in ohms for armature resistance and
synchronous reactance as 1.0 and 1.5 respectively.
(i)
Determine the armature current
(ii)
Determine the voltage regulation for a 0.9 lagging power factor.
(iii)
Determine the voltage regulation for 0.8 leading power factor.
(d) Discuss TwO advantages and TWO disadvantages of a permanent
magnet synchronous generator over an electrically excited synchronous
generator.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Under short circuit, the reactance's of the synchronous generator during the steady state condition are following, Leakage reactance(X)= 0.15 ohm and Armature reactance (Xad) = 0.68 ohm The direct axis synchronous (steady state) reactance (Xa) is
A 600 KVA generator with X"a = 0.22 per unit is connected to a bus through a circuit breaker, as shown in the following figure. Connected through circuit breakers to the same bus are three synchronous motors rated 200 KVA, 2.5 KV, 1.0 power factor, with X"a = 0.15 per unit. The motors are operating at full load, unity power factor and rated voltage, with the load equally divided among the machines. (a) Find the rated symmetrical short-circuit current in Amperes, which must be interrupting breakers A and B for a fault at point P. Simplify the calculations by neglecting the Prefault current. M. GHA B
Differentiate between a cumulative compound DC generator and a differential compound DC generator.
A cylindrical rotor generator delivers 0.5 pu power in the steady-state to an infinite bus through a transmission line of reactance 0.5 pu. The generator no-load voltage is 1.5 pu and the infinite bus voltage is 1 pu. The inertia constant of the generator is 5 MW-s/MVA and the generator reactance is 1 pu. The critical clearing angle, in degrees, for a three-phase dead short circuit fault at the generator terminal is
5) The method (s) to improve the Power Factor: a. Use of synchronous motors. b. Use of synchronous condensers. c. Connect capacitors with the load. d. All of the above.
Energy Question-1) Three identical synchronous generators were connected in parallel and the idle frequency values of each generator were set to 54 Hz. The frequency - power characteristic slopes of the first and second generators are 5.3 MW/Hz and the slope of the third generator is 3.9 MW/Hz. When these three identical synchronous generators feed a load together, the system frequency becomes f=51.7 Hz. According to this;a-) Calculate the active power value that the first generator will provide to the load.b-) Find the active power that the second generator will provide to the load.c-) Find the active power that the third generator will provide to the load.d-) Calculate the power of the load.(All values in options a, b, c, and d in this Question will be entered as two digits after the comma.) NOTE: If the information in the text and the photo is different, please solve the question using the information given in the photo. Help me please... Thank you so much.
' A three phase, star connected, round rotor synchronous generator is rated 250 MW, 0.85 lagging power factor, 10.8 kV 50 Hz, and 1600 rpm. Each winding has an armature resistance of 1.5 mOHM and a synchronous reactance of 0.5 OHM 1)Determine the induced voltage for the condition of rated load and 0.85 power factor lagging. 2) Draw the phasor diagram with calculated values. 3) Determine the values of theta, gamma, delta, and torque angle
Electrical machines
A synchronous generator is connected through a transformer and a transmission line to synchronous motor. The rated voltage and apparent power of the generator serve as the base quantities for this power system. On the system base, the per-unit sub transient reactance of the generator and the motor are 0.15 and 0.40 respectively, the series reactance of the transformer is 0.10, and the series reactance of the transmission line is 0.20. All resistances may be ignored. The generator is supplying rated apparent power and voltage at a power factor of 0.85 lagging when a three-phase synchronous fault occurs at the terminals of the motor. Find the per-unit sub transient current at the fault, in the generator, and in the motor.