Please answer all the questions. And please i need short answers, thanks. 01 2BUILDING UNDERSTANDINGS11. How many protons and electrons does oxygen have? What about hydrogen? (Draw amodel of each atom if that helps you think about the differences between them.)12. What have we figured out about attractions between oppositely charged particles?13. If we put these ideas together, how can we explain the partial negative charge on oxygenand the partial positive charge on hydrogen?14. How do partial charges affect attractions between water molecules? Draw several watermolecules, and use dotted lines to draw where one molecule is attracted to anothermolecule. (You can either insert a Google Doc Drawing or you can draw it on either paper oryour whiteboard, take a picture, and then insert into the blue box below.)Insert Drawing Here15. How does this help us explain why water molecules stek together?BACK TO THE SIMULATION (Check out mineral oil, again in "opaque" surface view.)16. Is mineral oil a symmetrical molecule? Does it have partial charges?17. Think back to lesson 3 and when we put drops of liquids on pennies. Could we get manydrops of oil to stick on a penny? What can we infer about attractions between mineral oilmolecules? Do we think it is a polar molecule?

Note: According to our guidelines we are supposed to answer only one question. Kindly repost other…

Answered: BUILDING UNDERSTANDINGS 11. How many…

BUILDING UNDERSTANDINGS 11. How many protons and electrons does oxygen have? What about hydrogen? (Draw a model of each atom if that helps you think about the differences between them.) 12 What b

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A 0.1 g amine-containing compound is dissolved in water then diluted to 100 mL. To get the concentration of amine in this compound, you subject it to spectroscopic analysis. So, you get 1 mL of the previously diluted sample then dilute it again to 250 mL for measurement. Then, you fill 3/4 of a 1-cm cuvette with this diluted sample then you run an analysis using an AAS. The recorded absorbance is 0.545 at 410 nm. Solve for the molecular weight of the compound. The molar absorptivity is 1.23 x 104 cm-1 mol-1 L.
Part A transcript When glucose (C6H12O6 (s)) is consumed, it reacts with O₂ gas in the body to produce gaseous carbon dioxide and liquid water. Enter the balanced chemical equation for the reaction. Express your answer as a chemical equation including phases. 0 ΑΣΦ ? A chemical reaction does not occur for this question. Submit Previous Answers Request Answer
STANDARD SAMPLE PREPARATIONS FOR ABSORBANCE & CONCENTRATION DATA Concentration of stock nickel sulfate hexahydrate solution = .400 Molarity Sample Volume Absorbance Concentration (In Molarity) a 5 mL .179 10 mL .329 15 mL .588 20 mL .760 25 mL .939 Reference Blank = 0 Please show how to find Molarity, please show steps. Thank you and stay safe.
11 of 11 I Review | Constants Periodic Table Suppose that you want to construct a line with slope m = 3 that passes through the point (2, 1). You would begin by setting up the equation y = 3x +b If you plug in the coordinates for any point on that line, the two sides of the equation will be equal. Once you've done this, you can solve for b. What is the value of b? Express your answer as an integer. > View Available Hint(s) 8:59 PM 41% 67°F x口ツ 8/31/2021
The protein concentration of a protein isolate was determined using the Bradford assay. Five dilution of bovine serum albumin (BSA) were prepared from a 5.00 mg/mL BSA stock solution. To these dilutions, 100 µl of Bradford reagent were added. After 5 minutes, the absorbance was taken at 595 nm. Standard # BSA, in mg/mL Volume of Bradford reagent, A595 in mL 1 5.0 0.000 1.00 5.0 0.134 3 2.00 5.0 0.265 4 3.00 5.0 0.388 4.00 5.0 0.497 The supernatant dilution was prepared by mixing 49 µL of the protein isolate with 16 µL water. The absorbance was taken 5 minutes after addition of 100 mL Bradford reagent. Calculate the protein concentration (in mg/mL) of the original isolate if the absorbance at 595 nm was 0.413. Note: Final answer format must be x.xxx (three decimal places). Round off only in the final answer. Do not round off in the middle of calculation.
Please answer questions 3 and 4 and show work please. Thank you
Which of the following describes a gradient elution process? stationary phase has varying concentration stationary phase has static concentration mobile phase has varying concentration mobile phase has static concentration
question help please
please i really need your help with this
7. Chemical Formula: C3H7NO₂ 1H, broad 12 10 2H, broad Final Answer 8 PPM 6 1H q A- 3H d 2 0
Glucose levels are routinely monitored in patients suffering from diabetes. The glucose concentrations in a patient with mildly elevated glucose levels were determined in different months by a spectrophotometric analytical method. What is the mode of the glucose concentration on Month 2? Time Glucose Concentration (mg/mL) 1108, 1122, 1075, 1099, 1115, Month 1 1083, 1100 Month2 992, 975, 1022, 1001, 991 Month 3 788, 805, 779, 822, 800 Month 4 799, 745, 750, 774, 777, 800, 758 992 mg/L 996 mg/L 101 mg/L O None of these
q41 IF YOU DO NOT KNOW THE ANSWER PLEASE DO NOT REJECT IT please calculate the unknown concentration of the protein D wih an absorbance value of A412 given the standard curve indicated in the table. write your answers in numbers only with 2 decimals. protein concentration (ug/ml) absorbance 0 0.000 0.02 0.161 0.04 0.284 0.06 0.438 0.08 0.572 0.10 0.762