Bilateral tolerance is Total tolerance is in 1 direction only Total tolerance is in both the directions May or may not be in one direction Tolerance provided all over the component body

Q: The term “Poka Yoke” means: Error handling Mistake proofing Confidence level

A: Poka Yoke is the use of any automatic method or device that makes the error immediately obvious when…

Q: There are two different indicated drawings in Fig.1. (1) Judge the tolerance principle they used…

A:

Q: the case where circular runout has been applied to an end face of a shaft, the following is…

A: Since the circular runout provides both concentricity and circularity with inherent influence. It…

Q: On the part shown, specify a paralellism tolerance to make the top surface parallel to datum A…

A:

Q: Which of the following is/are NOT true about strain gauges? Please select all that apply. a. Strain…

A: Given: To determine which of the following statement is NOT correct.

Q: Both bias errors and precision errors can propagate. TRUE OR FLASE

A: Bias errors and precision errors can propagate, meaning they can spread or continue through…

Q: Unilateral Tolerance is Total tolerance is in both the directions May or may not be in any direction…

A: Unilateral tolerance is the type of tolerance in which true profile is only permitted in one…

Q: What is the measurement accuracy AND unity of the instrument in Figure

A: Accuracy of the Bourdon tube pressure gauge

Q: The nominal size of a hole is Dn = 230 mm. The lower limit deviation El = -0.016 mm, and the…

A:

Q: I need help with question number 15 that is pertaining to the print provided.

A: 15.The unidirectional system is used here for the dimension placing. The unidirectional system is…

Q: Which of the following tolerance zones apply to perpendicularly of a surface to a surface?…

A: Given Data⇒Perpendicularly of a surface to a surfaceTolerance ZoneProblem definition⇒Problem says…

Q: (USCS units) A GO/NO-GO plug gage is needed to inspect a 1.000 ± 0.020 in diameter hole. A wear…

A:

Q: Complete an interpretation drawing that shows the required datum and the perpendicularity tolerance…

A: Perpendicularity: In GD&T the Perpendicularity is defined the two different…

Q: If the pin in the drawing below is produced at Ø.498, what is its total positional tolerance? C…

A: Given data as per the question Pin diameter =0.498

Q: Identify the GD&T applicable for the following component assembly. Make a table including Tolerance…

A: Given:To find:Identify the geometric dimensioning and tolerancing (GD&T) applicable.

Limits, Fits, and Tolerances

The maximum or minimum allowable sizes within which the size of component lies are known as limits. The limits are classified into two types: