Between RD and RC 1. Create a GRE interface Tunnel 0 on both routers: • RC Serial 0/0/0: 172.19.0.1 • RD Serial 0/0/0: 172.19.0.2 RC Tunnel 0: 11.0.0.1/30 RD Tunnel 0: 11.0.0.2/30

Q: . What is the main feature of Time Division Multiplexing? a. simple and easy to implement b. fair…

A: Synchronous TDM does not require identity bits to be included in a message since the receiving…

Q: urrent RTT is 10ms and the , then, use Basic algorith ? (Assume that, a = 0.5).

A:

Q: à Can a switching table in a virtual-circuit network have two entries with the same input port…

A:

Q: Give disadvantage of added MSRN opposed to addresses of VLR and HLR

A: disadvantage of added MSRN opposed to addresses of VLR and HLR.

Q: With the help of diagram show Interfacing of a SSD (common Anode) with 8085 with port address 12H.…

A:

Q: Switch Configuration Sw-1 e0/0 e1/0 eo/1 eo 2 e0/3 Mgmt-PC VPCS VPCS VPCS VPCS PC1 PC2 PC3 PC4…

A: Given:

Q: True or False: One drawback of circuit switching is that resources may be allocated for a connection…

A: True

Q: You are asked to design a MAC protocol for an access network where N nodes generate data…

A: answer :  According to above scenario, the point must be noted as, 1. each node transmit at constant…

Q: the pulse duration t = 0.1Ts . find the required bandwidth of PAM?

A: Given, Pulse duration τ = 0.1 TS We need to find the required bandwidth of PAM

Q: What is the range of addresses for jump and jump and link in MIPS (M 1024K)?1. Addresses between 0…

A: A jump instruction, like "jmp", just switches the CPU to execute a different piece of code within a…

Q: P(yl) =0.45 and P(y2) = 0.55. P(Y/X)-08 02 [0.2 0.8] lo.8 0.2

A: Hey there , I hope my solution is helpful to you. Question is easy, you just have to apply the…

Q: 3. Token-Ring because it currently can run at both 4Mbps and 16Mbps. This means that it can be used…

A: given data Token-Ring because it currently can run at both 4Mbps and 16Mbps. This means that it can…

Q: Time (RTT) is currently 20 r 25, 30, 28 ms respectively. using Basic Algorithm (Assu

A:

Q: . Suppose hosts A and B are connected by a link. Host A continuously transmits the current time from…

A:

Q: Write program to send 44H to ports P1 and P2, using (a) their addresses (b) their name

A: Below program to send 44H to ports p1 and p2

Q: Quèstion 4 Retransmissions in TCP reliable data transfer triggered by O A Timeout events OB.…

A: Retransmission in TCP is caused by:

Q: Question no 1 Draw Gantt chart and find Average waiting time by FCFS and SRTN. Process P11 Arrival…

A: Introduction of CPU Scheduling: CPU Scheduling is the process in which one process uses the CPU and…

Q: With the help of diagram ddress 12H. Connect a,b,c,d lines of SSD with DD,D, and D, lines of 8085.…

A: It is defined as seven-segment LED is a digital display module specialized to display numerical…

Q: Use React Router Use state to track if a user as logged in or not Hide Registration page/link, Login…

A: The objective of the question is to create a React application that uses React Router for navigation…

Q: Write a program using Arduino IDE to read the value of water level sensor connected to pin A0, then…

A: The program written using Arduino IDE is  int red = 2;int green = 3; void setup () {  pinMode (red,…

Q: For the dynamic channel allocation protocols of the datalink layer, discuss the difference between…

A: 1-persistent CSMA :  In 1-persistent CSMA, station consistently faculties channel to check its state…

Q: Hamminng code and Cyclic Redundancy Check techniques.

A: According to the question we need to find the solution for: A. Differentiate between Hamming code…

Q: Example 3: Write a piece of code to send 55H to output port device which its address is F300H.

A: The OUT instruction copies a byte from AL or a word from AX to the specified port. The OUT…

Q: Write a protocol where you will use RTD with a Wheatstone bridge to measure temperature and…

A: Given: Write a protocol where you will use RTD with a Wheatstone bridge to measure temperature and…

Q: MIMO and frame aggregation are techniques used in recent Wi-Fi standards for increasing capacity.…

A: A wireless access point is an essential component of a Wi-Fi ad-hoc network.(TRUE) Because the…

Q: Consider sender 1 is sending data bit -1 with CDMA code (1, 1, 1, -1, 1, -1, -1, -1) and sender 2 is…

A: The CDMA code sent by the Sender1 is (1, 1, 1, -1, 1, -1, -1, -1) and The CDMA code sent by the…

Q: In a broadcast Ethernet frame, state the destinatiog Media AccessControl (MAC) address?

A: Broadcast Ethernet frameThe Radio Frame includes an FF-FF-FF-FF-FF-FF-FF-FF hexadecimal MAC address,…

Q: Take use of the additional MSRN in comparison to VLR and HLR addresses.

A:

Q: On Cisco Packet Tracer, please design the following networks: An office with 4 printers and 2…

A: Thе quеstion is asking for thе dеsign of thrее nеtworks: an officе nеtwork, a sеcond facility…

Q: Suppose a switch is built using a computer workstation and that it can forward packets at a rate of…

A: Introduction

Q: What is the address of port C of the PPI in the figure below?

A: The PPI 8255 is used to connect CPU with other devices.  We can programme it to respond to the given…

Q: On Cisco Packet Tracer, please design the following networks: An office with three printers and one…

A: An introduction to Cisco Packet Tracer and network design would cover the basics of what Cisco…

Q: A CSMA/CD LAN has minimum frame size 100 bytes and is running at 100 Mbps. The signal speed in the…

A:

Q: 500-24 24 Instruction: 1. Configure OSPF routing protocol on the network given above 2. Subnet the…

A: Here is the complete table above the problem. See below steps.

Q: Give the value of the IP, auxiliary flag, zero flag, the carry flag, the sign flag, the overflow…

A: Flag Register: D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0         O D I T S Z   AC…

Q: PC-PT PC-PT PC3 PCI 192.168.10/30 192.168.20/26 2950-24 Switch2 1841 1841 2950-2 Router1 Router2…

A:

Q: (0) IPv6 default route using the next hop ipv6 address in the respective router for communications…

A: Introduction:- Network switches can be used in this network and it is easy to configure in this…