8:34 PM Fri 5 MayK0019CAPE10...0..(b)Lo(i)(ii)X19CAPE10200...X1.82×1018CAPE10200...-3-19CAPE102002s2 ✓X18CAPE10200.. XT@***Answers to th..O0·013x =XLecture 1X田How long will it take until 99% of the reactant have reacted?36%CAPE 1020 En.= 0'14x fac2600 s after initiation of a first order reaction 48.5% of the initial reactantconcentration remains present. What is the rate constant for this reaction?

(b) (i) The time, t = 600 s The final concnetration, CA = 0.485CA0 The order of the reaction is 1.

Answered: (b) (i) (ii) 600 s after initiation of…

Introduction to Chemical Engineering Thermodynamics

8th Edition

ISBN:9781259696527

Author:J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Publisher:J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Chapter1: Introduction

Section: Chapter Questions

Problem 1.1P

See similar textbooks

Similar questions

2. What will be the effects of each of the following changes in the reaction conditions in this experiment, assuming all other conditions remain the same. Explain your answers.a. increasing the amount of glacial acetic acid from 10 mL to 20 mL.b. increase the amount of nitric acid from 3.5 mL to 7.0 mL.c. decrease the amount of sulfuric acid from 1.5 mL to 5 mL.d. allow the temperature of the reaction mixture to remain at 40°C during the addition of the HNO3-H2SO4 solution.3. Write chemical equations for the hydrolysis of p-nitroacetanilide in (a) aqueous acid; (b) aqueous hydroxide.4. Predict what would happen during the recrystallization of p-nitroacetanilide in 95% ethanol if all of the acidic material had not been previously neutralized. Use an equation in your answer.
The overall reactions A --> D occurs via the following mechanism with the given reaction energies and barriers for each step Using the graph with Arrhenius axes provided, roughly shoe which of these reactions is most sensitive to temperature
The reaction of CO(g) with NO2 (9) is second-order in NO2 and zero-order in CO at temperatures less than 500 K. a. Write the rate law for the reaction. (Rate expressions take the general form: rate = k[H2][C12].) rate b. How will the reaction rate change if the NO2 concentration is tripled? The reaction rate will be the original value. c. How will the reaction rate change if the concentration of CO is tripled? The reaction rate will be the original value.
1. Consider the following unbalanced reaction, Cl2(g) + NO(g) ---> NOCl(g) a). Suppose that 150.0 g of NO is allowed to react with 220.0 g of Cl2. What is the largest amount of NOCl that could be formed in this reaction? b) What was the yield if only 31.5 g was actually formed? (corresponds to part a) 2.Draw a diagram of y against r for a 3s. What 2 features does it imply that do not make much sense? How can these problems be avoided? Give and explanation and diagrams/graphs
An organic chemistry student graphed the data from an oxidation "breathalyzer" analysis. Determine the rate constant and half-life for this reaction from the above information. Assume that the x-axis units are in minutes. Chromic Acid Oxidation of 2-Propanol 2.50 y = 0.3426x + 0.4566 R? = 0.9793 2.00 1.50 1.00 0.50 0.00 1 2 3 4 7 Time - In Absorbance
I would appreciate some help in how to solve those problems... thanks
AB3 + 3D2 --> AD3 + 3DB ΔrH° = 23.20 kJ/mol The displayed reaction has an equilibrium constant with a value of 10.70, when the reaction is run at a temperature of 29.00° C. Assuming that ΔrH° is constant over the temperature range of 25-150° C, what is the value of the equilibrium constant when this reaction is run at 55° C.
B- The isomerization of butane C,H10-C,H0 was carried out in the liquid phase. The data for this reversible reaction are given in Table below. 0.0 0.2 0.4 0.6 0.65 A (kmol/m'.h) This reaction has been done in three different reactors as shown below: 39 53 59 38 25 X;= 0.1 X 0.5 X- 0.6 Calculate the volume of cach of the reactors for an entering molar flow rate of n-butane of 52 kmol/hr.
Consider a second order reaction where ? → ?. The reaction is performed in a batch reactorwhere the concentration of component A decreases from CA0=2.03 mol/L to CA=1.97 mol/L inone minute. What is the reaction constant of this second order reaction
I want you to give me step by step solution and describe everything.
What is the concentration of A after 20.5 minutes for the reaction A → Products when the initial concentration of A is 0.800 M? (k = 0.00651 M/min)
J 5 Figure 5.1 shows the experimental observation for ethane (A) cracking to produce gas products ethylene (E) and hydrogen (H). Based on Figure 5.1, propose both reaction mechanism and rate-limiting step for this reaction.

SEE MORE QUESTIONS

Recommended textbooks for you

Introduction to Chemical Engineering Thermodynami…

Chemical Engineering

ISBN:

9781259696527

Author:

J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Publisher:

McGraw-Hill Education

Elementary Principles of Chemical Processes, Bind…

Chemical Engineering

ISBN:

9781118431221

Author:

Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard

Publisher:

WILEY

Elements of Chemical Reaction Engineering (5th Ed…

Chemical Engineering

ISBN:

9780133887518

Author:

H. Scott Fogler

Publisher:

Prentice Hall

Introduction to Chemical Engineering Thermodynami…

Chemical Engineering

ISBN:

9781259696527

Author:

J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Publisher:

McGraw-Hill Education

Elementary Principles of Chemical Processes, Bind…

Chemical Engineering

ISBN:

9781118431221

Author:

Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard

Publisher:

WILEY

Elements of Chemical Reaction Engineering (5th Ed…

Chemical Engineering

ISBN:

9780133887518

Author:

H. Scott Fogler

Publisher:

Prentice Hall

Process Dynamics and Control, 4e

Chemical Engineering

ISBN:

9781119285915

Author:

Seborg

Publisher:

WILEY

Industrial Plastics: Theory and Applications

Chemical Engineering

ISBN:

9781285061238

Author:

Lokensgard, Erik

Publisher:

Delmar Cengage Learning

Unit Operations of Chemical Engineering

Chemical Engineering

ISBN:

9780072848236

Author:

Warren McCabe, Julian C. Smith, Peter Harriott

Publisher:

McGraw-Hill Companies, The

SEE MORE TEXTBOOKS

(b) (i) (ii) 600 s after initiation of a first order reaction 48.5% of the initial reactant concentration remains present. What is the rate constant for this reaction? How long will it take until 99% of the reactant have reacted?