(b) Determine (i) the pressure gradient, (ii) the shear stress at the two horizontal parallel plates, and (iii) the discharge per meter width for the laminar flow of oil with a maximum velocity of 1.5 m/s between two horizontal parallel fixed plates which are 80 mm apart. Take viscosity of oil as 1.962 Ns/m2.

Q: Water is pumped through a horizontal, smooth circular pipe at a bulk velocity of 0.4 m/s. The pipe…

A:

Q: ron pipes and conducts water at 20 ° C from eservoir "A" to reservoir "B", the levels of which are…

A:

Q: - 1000 kg/m) flows from a large Q6: Water (p tank through a large pipe that splits into two imaller…

A:

Q: If DA = 23cm, DB = 4cm and L = 9m, and if oil is flowing at a rate of 0.01 m/ s, determine the %3D…

A: The volumetric flow of a fluid through a section can be determined as the product of cross sectional…

Q: A non-viscous fluid is flowing through the pipe as shown. At which location is the pressure the…

A:

Q: s relative density is 0.85, its dynamic viscosity is 1.5 Pa.find the pumping power that must be…

A:

Q: Fluic Determine the rate of flow water through a pipe 300 mm dimeter placed in an inclined Position…

A:

Q: Water flowing in a straight cylinder tube with radius of 3mm, has a maximum velocity U0=15cm/s. If…

A:

Q: Oil ( μ = 0.478 Pa.s and ν = 5.3 *10-4 m2/s ) flows downward in a pipe which is ( 3 cm ) in diameter…

A:

Q: True/False: For saturated water with a quality 0 < x < 1, volumetric flow rate can be used to…

A: The process given in the question is accompanied to change of water from saturated water to…

Q: onsider two rectangular tanks having constant flow areas of A1 and A2. The tanks are connected at…

A: Given dataArea of tank 1 = A1Area of tank 2 = A2pipe diameter = dInitial elevation = ho

Q: (a) Prove that the loss of pressure head for the viscous flow through a circular pipe is given by h.…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A 1/4” inside diameter pipe is used to transport SAE 30 motor oil (µ = 0.006266 slug/ft-s and ρ =…

A:

Q: A piston contains a type of fluid that has a S.G of 0.9 and a dynamic viscosity of 0.02 Poise. The…

A:

Q: oil (0.88) ► oil (0.88) Hg (SG=13. 320mm-

A:

Q: Water is carried through two steel horizontal pipes in series. The upstream pipe is 110 mm of 600 mm…

A:

Q: In the system shown, the pipe is commercial steel, the inlet and outlet is sharp edge and the flow…

A: Flow rate, Q = 125 L/s = 0.125 m3/s Pipe diameter, D = 0.3m Pipe length, L = 30 m Elevation…

Q: A nozzle meter, with an orifice diameter of 3 cm, is being used to determine the velocity of ethanol…

A: Write the given data with suitable variables: Do=3 cm=0.03 mSG=0.789μ=0.986×10-3 Pa-s100 cm1 mD1=6…

Q: water 7.5 cm vapor diameter 1. Water is siphoned from the large, open tank as shown. The 9.2 m gas…

A: Solution: Water vapour on top of the barometer balances the liquid column and thus prevents the…

Q: 1. The head loss along the pipe segment 2. Velocity of flow 3. Reynold’s number

A:

Q: Oil ( µ = 0.478 Pa.s and v= 5.3 *10° m²/s ) flows downward in a pipe which is ( 3 cm ) in diameter…

A: B. Th wall shear stress             τ=-dpdxr2=918.5×0.0152=6.88 Nm2

Q: A straight pipe has a daimater of 25 mm, a roughness height of 0.1 mm, and is inclined upward at and…

A: Write the properties of water at 10°C. Draw the diagram of the pipe. From the diagram,

Q: A steel pipe, having diameters of 100 mm, 80 mm, and 60 mm, respectively, each 152 m long, are…

A: Given Data

Q: Verify that the flow of oil is laminar (barely) for an oil gusher that shoots crude oil 25.0 m into…

A: Understand that at the topmost point the velocity of the water stream will be zero and the water…

Q: The observed pressure drop for 40°F water flowing at 16 ft/min in a 4.5-in diameter pipe is 9.68 x…

A:

Q: Q3: The 6-cm-diameter pipe as shown in Figure H.I contains glycerin (p = 1260 %3D kg/m', u= 1.49…

A:

Q: Water flows through the pipe contrac- For the given 0.2-m difference in manometer level, determine…

A:

Q: Calculate the discharge through a 90-mm diameter sharp edged orifice in a closed container with oil…

A:

Q: em 1 Problem 1: Water at 20°C flows at a rate of 10 m³/h from Point A to Point B (Fig. 1) through a…

A:

Q: A pumping system is installed at a location where the reading of barometer is Pa=90kPa and the vapor…

A: Given: The atmospheric pressure, Pa = 90 kPa The vapour pressure, Pv = 3.5 kpa The cavitation number…

Q: A venturi meter is introduced in a 300 mm diameter horizontal pipeline carrying a liquid under a…

A: Given data: D=300 mmd=100 mmP=150 kPaHead loss=3% of differential pressure headhloss=-400 mm Need to…

Q: Determine: The volume per second The velocity at each section The pressure at the lower end

A:

Q: Water at 35 degrees Celsius is flowing through a smooth pipe with a length of 95m and a diameter of…

A: Given data Pipe flow through a smooth pipe.Length = 95 mDiameter = 350 mm = 0.35 mReynold's number =…

Q: A ventury meter used to measure the liquid from the reservoir. The cross-sectional area at the inlet…

A: Given:A1=4.536*10-3 m2A2=1.134*103 m2Q=9167 cm3/sx=266 mms=13.6

Q: A viscous fluid flows in a 0.11-m-diameter pipe such that its velocity measured 0.014 m away from…

A: The diameter of pipe is The velocity at a distance  from pipe wall is