Awaste management company handles large dumpsters of construction debris. The sorting process starts by downloading he dumpster from the transport truck and then dumping its contents into a large hopper as shown below. The waste nanagement plant uses a hydraulic cylinder arrangement to tilt the dumpster to the point that the force of gravity will mpty the contents. The plant operator activates an electric pump that pumps hydraulic oil into the input piston at an bsolute pressure of 3.40 x 10° Pa and drives the output plunger, which has a radius of 0.195 m. If the design of the lumping arrangement is such that the output plunger remains perpendicular to the floor of the dumpster, determine the orque the plunger creates about an axis at the end of the dumpster.

Awaste management company handles large dumpsters of construction debris. The sorting process starts by downloading he dumpster from the transport truck and then dumping its contents into a large hopper as shown below. The waste nanagement plant uses a hydraulic cylinder arrangement to tilt the dumpster to the point that the force of gravity will mpty the contents. The plant operator activates an electric pump that pumps hydraulic oil into the input piston at an bsolute pressure of 3.40 x 10° Pa and drives the output plunger, which has a radius of 0.195 m. If the design of the lumping arrangement is such that the output plunger remains perpendicular to the floor of the dumpster, determine the orque the plunger creates about an axis at the end of the dumpster.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A room has a width of 14.1 feet, a length of 15.5 feet, and a ceiling height of 12.0 ft. The average flow rate for this room's air conditioning unit is 3.07 m^3/s. How many SECONDS will it take for the air conditioner to cycle the volume of air in the room?
A tank in the shape of an inverted cone has a height of 20 meters and a base radius of 11 meters and is filled with liquid to a depth of 16 meters. Determine the amount of work needed to pump all of the liquid to a point 1m from to the top of the tank. Assume that the density of the liquid is 793 kg/m 3
Pressure cookers have been around for more than 300 years, although their use has strongly declined in recent years (early models had a nasty habit of exploding). How much force must the latches holding the lid onto a pressure cooker be able to withstand if the circular lid is 25.0 cm in diameter and the gauge pressure inside is 300 atm? Neglectn the weight of the lid.
A sump pump (used to drain water from the basement of houses built below the water table) is draining a flooded basement at the rate of 0.700 L/s, with an output pressure of 2.00 x 105 N/m². You may neglect frictional losses in both parts of this problem. (a) The water enters a hose with a 3.00 cm inside diameter and rises 3.00 m above the pump. What is its pressure (in N/m²) at this point? N/m² (b) The hose goes over the foundation wall, losing 1.70 m in height, and widens to 4.00 cm diameter. What is the pressure now (in N/m²)? N/m²
Please don't provide handwritten solution .....
Assume that a raindrop has a volume of 0.05 cm^3 and you need an Avogadro's number of raindrops to fill up the cubic water tank. What is the length of the edge of the tank?
A dump truck uses a hydraulic cylinder, as the drawing illustrates, to raise the trailer. A pump injects hydraulic oil into the cylinder (r = 15 cm) at an absolute pressure of 4 million Pascals. Initially as it starts to raise the trailer, what is the largest mass that could be lifted by this system? Assume atmospheric pressure = 1.01 x10^5 Pa
the water faucent for a garden hose is tuned on, but with the nozzle turned off the owner of the garden assumes that the water cannot exit the hose. however , even through the hose lies horizonatlly on the ground, the owner notice a stream of water spraying vertically out a small leak in the hose. to a height of 0.75 m. what must be the pressure of the water inside the hose 1) 7.9 kpa 2) 8.8 kpa 3) 7.4 kpa 4) 101.3 pka
While taking a shower, you notice that the shower head is made up of 36 small round openings, each with a radius of 2.00 mm. You also determine that it takes 2.00 s for the shower to completely fi a 1.00-liter container you hold in the water stream. The water for the shower is pumped by a pump that is 5.60 m below the level of the shower head. The pump maintains an absolute pressure of 1.50 atm. Use g = 10 m/s?, and assume that 1 atmosphere is 1.0 x 105 Pa. (a) At what speed does the water emerge from the shower head? 1.105 m/s (b) What is the speed of the water in the pipe connected to the pump? m/s (c) What is the cross-sectional area of the pipe connected to the pump? m2
A company needs to pump coconut oil (den: 924 kg/m^3) from the import truck to its holding tank 17 meters above the ground. If the pump that is used is able to create 3 ATM of pressure, what will be the velocity of the oil as it enters the tank?
A phonograph needle has a point with a radius of 8.00 x 10-5 m. The record exerts a force of 0.180 N on the needle. Find the pressure exerted on the record. This is the answer: 1.00 x 104 kPa Can you solve the process? Thank you
A 14,912-N car is raised using a hydraulic lift, which consists of a U-tube with arms of unequal areas, filled with incompressible oil and capped at both ends with tight-fitting pistons. The wider arm of the U-tube has a radius of 16 cm and the narrower arm has a radius of 8 cm. The car rests on the piston on the wider arm of the U-tube. The pistons are initially at the same level. What is the initial force in N that must be applied to the smaller piston in order to start lifting the car? (For purposes of this problem, you can neglect the weight of the pistons.) Express answer as a whole number.