A waste management company handles large dumpsters of construction debris. The sorting process starts by downloading the dumpster from the transport truck and then dumping its contents into a large hopper as shown below. The waste management plant uses a hydraulic cylinder arrangement to tilt the dumpster to the point that the force of gravity will empty the contents. The plant operator activates an electric pump that pumps hydraulic oil into the input piston at an absolute pressure of 3.60  106 Pa and drives the output plunger, which has a radius of 0.120 m. If the design of the dumping arrangement is such that the output plunger remains perpendicular to the floor of the dumpster, determine the torque the plunger creates about an axis at the end of the dumpster.

Q: A sump pump (used to drain water from the basement of houses built below the water table) is…

A: The rate of drain of water by the pump is Q=0.55 L/s=0.55 L/s×1 m31000 L=0.55×10-3 m3/s. The output…

Q: A siphon is used to drain water from a tank as illustrated below. Assume steady flow without…

A: Take the reference level as the level of water in the tank. Let Pl be the pressure at height h (the…

Q: A 0.389 kg metal cylinder is placed inside the top of a plastic tube, the lower end of which is…

A: Given data: Cylinder's mass m = 0.389 kg Inner radius ri = 5.54 mm pressure increasing factor = 1.59…

Q: A garden hose with an internal diameter of 3.1 cm is connected to a (stationary) lawn sprinkler that…

A: Given data: Internal diameter of the garden hose (d1) =  3.1 cm = 3.1×10-2 m.Diameter of the…

Q: While taking a shower, you notice that the shower head is made up of 46 small round openings, each…

A:

Q: A Venturi meter is a device for measuring the speed of a fluid within a pipe. The drawing shows a…

A: In this question we have been given that a Venturi meter is a device for measuring the speed of a…

Q: Unfiltered olive oil must flow at a minimum speed of 3.0 m/s to prevent settling of debris in a…

A: In order to answer this issue, we must determine the oil's portion (a) speed as it leaves the pump.…

Q: You build a pressure gauge as shown in the figure below. The spring has spring constant of 1000 N/m…

A:

Q: The four tires of an automobile are inflated to a gauge pressure of 2.2 105 Pa. Each tire has an…

A:

Q: A plumbing system contains a junction with 4 pipes, as shown in the figure. Each pipe has a…

A: Given data A1=10 cm2A2=20 cm2A3=40 cm2A4=5 cm2 Here, A represents the area of the different sections…

Q: A 1.50 mL syringe has an inner diameter of 5.00 mm, a needle inner diameter of 0.260 mm, and a…

A:

Q: The motor of your "dune buggy" is fueled by a gas line with a radius of 3.40 x 10 m and the fuel…

A:

Q: A long tube with cross sectional area 0.468m² and height 7.21m is standing vertically and filled…

A: We are given the pressure of air inside tube. Since the plunger is at equilibrium, the outside…

Q: A plastic tube has an inner diameter of d = 13.4 mm, and it can withstand a gauge pressure of Pmax =…

A: Here's how to solve it:*  *Step 1: Identify the relevant forces.*There are two main forces acting on…

Q: The drawing shows a cylinder fitted with a piston that has a mass m₁ of 0.850 kg and a radius of…

A: The acceleration of the system is can be found out by using second law off motion as follows: s = ut…

Q: A waste management company handles large dumpsters of construction debris. The sorting process…

A: absolute pressure into the input piston,p=3×106 Paradius of output plunger,r=0.245 m

Q: There is a force exerted on piston A which has a diameter of 0.050 cm. This produces an output force…

A: Given data: Diameter of piston B (dB) = 0.15 cm  Diameter of piston A (dA) = 0.05 cm Force on the…

Q: Two identical cylindrical vessels with their bases at the same level each contain a liquid of…

A: Density of liquid, ρ = 1.18 g/cm3=> ρ ==> ρ = kg/mArea of base, A = 2.91 cm=> A =  m2Height…

Q: Water is stored in a pressurised container at a height ??= 11.2 m. It then moves through a…

A:

Q: 8.36 Water flows downward through a vertical 10-mm-diameter galvanized iron pipe with an average…

A:

Q: 0.5 m 20 kg A B C p= = 1000 kg T 0.15 m A container of water has a cross-sectional area of 0.50 m².…

A:

Q: The drawing shows a hydraulic chamber with a spring (spring constant = 1690 N/m) attached to the…

A: Given data:  Spring constant (k) = 1690 N/m Mass (m) = 45.0 kg Required: The compression in the…

Q: A tank holds a large amount of water. A pipe is connected to the tank at the upper end and is open…

A: The given values are, d1=19.0 cm=0.19 mh1=1.60 md2=6.20 cm=0.062 mh2=0.650 mp1=1.80 atmp2=1.00 atm

Q: A dump truck uses a hydraulic cylinder, as the drawing illustrates. When activated by the operator,…

A:

Q: A 0.435 kg0.435 kg metal cylinder is placed inside the top of a plastic tube, the lower end of which…

A:

Q: 10. In an industrial cooling process, water is circulated through a system. If water is pumped with…

A:

Q: *96. D A log splitter uses a pump with hydraulic oil to push a piston, which is attached to a…

A: The pressure is given by, P=FA Here, F is the force and A is the area of cross-section. Rearranging…

Q: A hand-driven tire pump has a piston with a diameter d and a maximum stroke of 30.0 cm. You Find the…

A:

Q: = Water is stored in a pressurised container at a height HT 9 m. It then moves through a horizontal…

A:

Q: A sealed storage tank contains water to a height of 25 m. The air above the water inside the tank…

A: Given , Height of tank H=25 m gauge pressure P=4.5 Atm

Q: A garden hose is attached to a water faucet on on end and a spray nozzle on the other end. The wat…

A: Solution

Q: A pressurized tank supplies water to a hose. The hose rises h=1.3 m above the tank before spraying…

A:

Q: A water cannon 2.15 m long and with a cross-sectional area of 11.0 cm2 is aimed straight up and…

A: Length of water cannon = 2.15 m A1 = 11 cm2v1 = 8.8 m/s A2  = 46 cm2Using equation of continuity…

Q: Water is flowing without friction through a pipe. At the beginning of the pipe the water is flowing…

A:

Q: The four tires of an automobile are inflated to a gauge pressure of 1.9 x 105 Pa. Each tire has an…

A:

Q: In the calculation of pressures in fire hoses, it is often necessary to take into account the…

A: Given that Consider a horizontal hose of diameter equal to (d) =3.81 cm=0.0381m The length of the…

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.