Assume a system has a Translation Look-aside Buffer (TLB) hit ratio of 95%. It requires 20 nanoseconds to access the TLB, and 80 nanoseconds to access main memory. What is the effective memory access time in nanoseconds for this system? O 90 O 116 O 108 O 104

Assume a system has a Translation Look-aside Buffer (TLB) hit ratio of 95%. It requires 20 nanoseconds to access the TLB, and 80 nanoseconds to access main memory. What is the effective memory access time in nanoseconds for this system? O 90 O 116 O 108 O 104

Name: NOTE: you need to have one piece of blank paper as scrap paper to wor
Uploaded: 2024-03-20T06:51:23.000Z
Channel: Bartleby
Description: NOTE: you need to have one piece of blank paper as scrap paper to workout the questions, as some questions require simple calculations or drato answer the question.DQuestion 30Assume a system has a Translation Look-aside Buffer (TLB) hit ratio of 95

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider a paging system with the page table stored in memory. A. If a memory reference takes 200 nanoseconds, how long does a paged memory reference take? B. If we add associative registers, and 75 percent of all page-table references are found in the associative registers, what is the effective memory reference time? (Assume that finding a page-table entry in the associative registers takes zero time, if the entry is there.)
Assume that a RISC processor executes each instruction in 2 microseconds and that a 1/O device can only wait for an interrupt to be serviced for 1 millisecond before it is serviced. The number of instructions that may be executed when interruptions are deactivated is restricted.
For simplicity, let us assume that each instruction on a RISC processor is executed in 2 microseconds and that an I/O device can only wait for an interrupt to be handled for a maximum of 1 millisecond before it is serviced. The number of instructions that may be executed when interruptions are deactivated is restricted to a certain number.
Consider a system in which the 32kb memory space is implemented using (4 *4 )kb EPROM memory type. the number of device 8. O 16 32 O none of above
Assume that a RISC processor executes each instruction in 2 microseconds and that an 1/0 device can only wait for an interrupt to be served for a maximum of 1 millisecond before it is serviced. The amount of instructions that can be performed with interrupts disabled is limited to a certain quantity.
Assume that a RISC processor executes each instruction in 2 microseconds and that an I/O device can wait no more than 1 millisecond for an interrupt to be handled. There is a limit on the number of instructions that may be executed with interrupts deactivated.
Two distinct kinds of memory addresses exist. Instead of storing all of the data in memory, why not just use it as a temporary holding area to register part of it with the ALU and move the rest of it to the IR?
So let's say that each instruction is executed in about two microseconds by a RISC processor. An /0 device can only wait for about 1 millisecond before its interrupt is handled. When interrupts are turned off, how many instructions can be run?
So let's say that each instruction is executed in about two microseconds by a RISC processor. An I/O device can only wait for about 1 millisecond before its interrupt is handled. When interrupts are turned off, how many instructions can be run?