Aspartame was measured in 3 diet sodas using RP-HPLC: Sample Soda A Soda B Soda C Peak Area 7.86 4.34 6.61 Plot of Peak Area vs Concentration: y=0.02696x - 0.405 Calculate amount of aspartame in mg/100 mL of Soda A f 100 μL of sample diluted 2 fold was used for analysis

Aspartame was measured in 3 diet sodas using RP-HPLC: Sample Soda A Soda B Soda C Peak Area 7.86 4.34 6.61 Plot of Peak Area vs Concentration: y=0.02696x - 0.405 Calculate amount of aspartame in mg/100 mL of Soda A f 100 μL of sample diluted 2 fold was used for analysis

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: A mixture of the two compounds shown below is dissolved in ether. Using the information given in the…

A: Compound X is a carboxylic acid and compound Y is a tertiary amine. Both X and Y are soluble in…

Q: 2. How can a sample's melting point indicate the presence of an organic impurity? 2. When performing…

A: 2) In case of the synthesis of organic compounds we check the purity of the product by melting…

Q: Some procedures include the addition of sodium carbonate before liquid-liquid extraction. What is…

A: Liquid-liquid extraction: It is a separation process consisting of the transfer of a solute from one…

Q: which of the following froactions is equivalent to 55% 13/25, 11/20/, 9/20, 12/25

A: Given, 13/25, 11/20, 9/20, 12/25

Q: What is the function of the sulfuric acid in the dehydration of alcohols to form alkenes

Q: particular extraction proceeds with a distribution coefficient of 6. The system consists of 3.5 g of…

A: Fraction extracted and fraction remains in aqueous layer formula is W1= W0 × (V1/KpV2+V1)^n W0=…

Q: Would it be easy to determine the molecular weight of starch by measuring the freezing point…

A: Introduction A polymeric carbohydrate known as starch or amylum is made up of many glucose units…

Q: Caffeine has a pure melting point listed as 235-238 °C. Several students isolated a white solid,…

Q: What is the effect of weighing a recrystallized organic solid which is not completely dried to the…

A: Percentage yield is calculated by dividing actual yield to theoretical yield and multiplying it by…

Q: Hazards of this experiment include Melting point apparatuses that will be very hot Reagents that…

A: The Hazards of the experiment include the following things

Q: In which option is the order showing whether the questions given below are true or false? () If the…

A: The statement first is incorrect because complete purification through distillation is not possible…

Q: Sometimes, the melting point range of a sample does not correspond exactly to that recorded in the…

A: Definition: The melting point of solid is defined as the temperature at which the solid exists in…

Q: How was the precipitate obtained after filtration? By scraping from the filter paper and…

A: Filtration is used to separate an insoluble solid from a pure liquid or a solution

Q: The question is: A student preforms a crystallization on an impure sample of biphenyl. The sample…

A: Benzene is a very bad solvent to use to recrystallize biphenyl.If the solubility properties of two…

Q: Twenty grams of tea leaves was extracted with 250.0 mL water. The aqueous extract was then subjected…

A: Part a. The distribution coefficient of caffeine between dichloromethane and water (Kd) = 8.35 Now,…

Q: 6. If more polar impurities are desired to be eluted first and then analyte, then at which stage do…

A: 6. If more polar impurities are desired to be eluted first and then analyte, then at step (c) i.e.…

Q: 12. Which compound will have the smallest Rf on a TLC plate using silica gel (SiO₂) as the…

A: This problem is based on Chromatography. Here retention factor or Rf is needed to be found.

Q: Lactic acid Salicylic acid Trichloroacetic acid Flexible collodion qs ad Sig: wart remover. Use as…

A: a) Given that- Mass percentage of camphor (20 % w/w)This means, 100 grams solution = 20 grams…

Q: t was calculated that there was 0.00427 mmol/mL of 4-methoxyphenyl acetate. The experimental mass…

A: The concentration of 4-methoxyphenyl acetate is given in the question from which the total mass of…

Q: is 77.18%. The melting point range of crude benzoic acid = 112-119°C and the melting point range of…

A: The question is based on the results obtained after recrystallizing benzoic acid. the yields and…

Q: When the compounds analyzed by Robrob were passed on to the next test, another scientist, Kikoko,…

A: Given: Concentration of 20 % (w/w) solid active compound (M1) = ? Volume of 20 % (w/w) solid active…

Q: Compare and contrast the amount of caffeine you obtained from the single vs multipleextractions with…

A: Approach to solving the question:Understanding the Experiment Setup: Firstly, it's essential to…

Q: 2) What’s the principle of extraction and recrystallization ? 2) What’s the best method to separate…

A: Given:Principles of extraction and recrystallizationIdentify the best method to separate compounds.A…

Q: Three sample, X (neutral), Y (basic), and Z (acidic), were mixed and dissolved together in…

A: Dissolve the mixture in dichloromethane and separate the organic and aqueous layer using liquid…

Q: Explain melting point determination as a characterization technique.

Q: Name of experiment : Gas Chromatography (GC);Separation of alcohols Q1:Purpose of experiment…

A: Ans. Gas chromatography: Gas chromatography (GC): Separation of alcohols (1) Purpose of experiment:…

Q: 0.155 g of Acyclovir cream was mixed with 50 mL of 0.5M Sulphuric acid and extracted with 50 mL of…

A: To determine the concentration of Acyclovir in a cream sample, a detailed analytical procedure was…

Q: Diethyl ether and methylene chloride are generally not suitable for use in recrystallization, but…

A: Recrystallization is a technique used to purify chemicals. By dissolving a mixture of a compound and…

Q: A. The Cannabis Gummies were illegally shipped into the country but were intercepted at NAIA upon…

A: As per the Bartley expert guidelines, I am allowed to answer first one question at a time. Please…

Q: Nitric acid samples were prepared by diluting the 68 w/v% high purity-grade or 61 w/v% electronic…

A: 68 % w/v means 68 g of HNO3 is present in 100 mL solution. Determination of no. of mol. of HNO3:…

Q: Given 60.00 g of the compound in 60.00 mL water. Calculate amount extracted using multiple (2 x…

A: Concept- In a multiple extraction procedure, a quantity of solvent is used to extract one layer…

Q: Which of the following could DECREASE the amount of the recovered crystals in the purification by…

Q: Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected…

A: Melting point of crystal depends on arrangement of lattice

Q: Calculate the theoretical performance and yield percentage of methyl m-nitrobenzoate Amount of…

A: Given: Volume of methyl benzoate taken = 2.00 mL Mass of purified methyl m-nitrobenzoate produced…

Q: 4. When performing a melting point on solid compound using a melting point apparatus, two melting…

Q: ann performed a sample analysis for potassiom content where the results are the following: 14.92%,…

A: We have to predict whether acquired values are accurate or precise.

Q: How will you increase the measured yield of recrystallized benzoic acid? The receiving flask from…

A: Recrystallization can be defined as a process which is used for purification of impure compounds.…

Q: Forty grams of powdered banana pulp was mixed with 80.00 mL of cold Tris-HCl extracting buffer to…

A: 1. The original concentration of standard solution is 2 mg/mL.

Q: ed: Increase in weight Decrease in weight| Increase in weight :

A: 1. Deliquescence is the phenomenon where a salt absorbs moisture from the atmosphere and dissolves…

Q: Why was n-octanol chosen as a surrogate for natural organic phases? Why not another solvent such as…

A: A question based on introduction to organic chemistry that is to be accomplished.

Q: A bottle of Na2EDTA.2H2O is labeled with an assay of 100.5%, what is this implied? What is the…

Q: What do you notice about the compounds under the melting point column that have negative values?

A: We are given the melting and boiling point of different compounds in the table.

Q: purification of egg yolk vitelline 1) Measure the volumes of 3 egg yolks and mix by adding an equal…

A: The vitelline membrane is the transparent casing that encloses the yolk of the hen's egg and…

Question

Take into account the sample was DILUTED TWO FOLD.

Aspartame was measured in 3 diet sodas using RP-HPLC:
Sample
Soda A
Soda B
Soda C
Peak Area
7.86
4.34
6.61
Plot of Peak Area vs Concentration:
y=0.02696x - 0.405
Calculate amount of aspartame in mg/100 mL of Soda A
if 100 µL of sample diluted 2 fold was used for analysis

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

2. Is it possible to purify a compound by recrystallization using a mixture of solvents? Why or why not?
How do you obtain napthalene,napthol and benzoic acid from a sample using recrystallization?
4. In a distillation of a mixture of acetone (bp. 56°C and dichloromethane bp. 40°C), a fraction averaging 48°C was collected that never exhibited a plateau temperature. Show using temperature as an indicator of purity what the % of acetone is in this fraction. (Hint: this is similar to the question of refractive index in the last assignment) Please answer very soon will give rating surely
Please give handwritten
Calculate the amount of phycocyanin in Sample 1 in mg where A620=0.233 and A650=0.061, using a dilution factor of 100, and a total volume of extract as 45 mL. Note your answer to 2 decimal places.
Based on the melting point of your impure solid, you look at the given samples and believe you havecompound A. Compound A is recrystallized using a mixed solvent system of ethanol and water. You add1 ml of hot ethanol to your sample and it doesn’t completely dissolve. You continue to add hot ethanolbut there isn’t any change. Some solid remains. What should you do next?
For each of the following statements, answer True or False and explain your answer briefly. It is preferred to apply colour tests, as a screening test, over microcrystalline tests in drug analysis.
Calculate the amount of phycocyanin in Sample 1 in mg where A620=0.211 and A650=0.086, taking into account the dilution factor as per question 6 (100ul), and the total volume of extract as per question 4 (140ml) . Note your answer to 2 decimal places
What process is required to purify the ethanol from the fermented broth? Extraction Distillation Chromatography Recrystallization
it was calculated that there was 0.00427 mmol/mL of 4-methoxyphenyl acetate. The experimental mass obtained was 4.34g. The percentage yield was 32.12%. Calculate the percentage recovery
Why is 95% alcohol a good solvent for extraction?
13.) A mixture containing 50% mole of A is distilled at a temperature T, what is the distillate to residue ratio? А. 1.5 B. 0.33 C. 0.67 D. 2.0 E. 0.50 30 50 60 Mole 5k of A