Analysis 3: Based on the design of the antennas, the Standard Absorption Rate (SAR) of RF power by thepatient tissue is expected to be as follows:SAR(t) = 2t + e0.1t+2 where, t is time in seconds.2. Plot the SAR function for the first 80 seconds.

The SAR function equation is given as, SAR(t)=2t+e0.1t+2. The time for calculated SAR function is…

Answered: antennas, thne Standard Absorption…

antennas, thne Standard Absorption power by patient tissue is expected to be as follows: SAR(t) = v2t + e0.1e+2 where, t is time in seconds. 2. Plot the SAR function for the first 80 seconds.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: (b) The reverberation time of a hall is Twhen an object made of certain material is placed inside a…

A: Let T1 be the reverberation time with object and T2 be the reverberation time on removing the object…

Q: Question 2 C (A) m k O greater than O equal to O less than (B) m www. The natural frequency of (C)…

A: For solution refer below images.

Q: A ship, travelling at 12 knots, has an autopilot system with a time and gain constants of 107 s and…

Q: ID: BME Find CT the frequency of 1 m ³k = 1 kN/m. Mpod = 2 kg I pod = 2m the followin syster…

Q: for the moments is there not 3 ? please refer to the image attached. have i gone wrong somewhere?

Q: Two identical sinusoidal waves, each of amplitude A, and differing by their phase constant,…

A: An angular measurement on the plane surface which is calculated from the subtended circle's center…

Q: |G(w) 3 dB 1/√√2 u(t) y(t) 20 dB/decade 1+ jan 1 + jωτ 1/τ W Figure 3: Bode plot of a low-pass…

A: cascaded low-pass filter. [Image of Bode plot of a low-pass filter] **Transfer function of the…

Q: The theoretcial resolution of a TEM operating at 83 kV is givens as 0.0323 nm. Calculate the half…

A: Given Accelerating voltage = V = 83 KV = 83000V d is resolution in nm = d =0.0323nm a is half…

Q: 9. A commercial linear analog sensor is used to measure measurable quantity x. To cal linear voltage…

A: A sensor, in its widest sense, is a device, module, machine, or subsystem that detects events or…

Q: A helical compression spring has a scale of 400 lbs/inch, an inside diameter of 2.5 inches, a free…

A: Given that, δ=1 in, for load=400 lb,W=750 lb,Inside diameter, Di=2.5 in,L=8 in, Let the working…

Q: When a system is expanding and doing work, part of the work done is used to overcome the atmospheric…

A: If a gas is expanding in a piston cylinder arrangement( closed system),it is doing work(W).Work is…

Q: Write down about the HEPA and ULPA filters. Also explain the working of any type of HEPA filter.

A: Given Data⇒HEPA FiltersULPA FiltersProblem definition⇒Problem says Write down about the HEPA and…

Q: B. EIL in the Use the adjacent figure to lidentify the type of emlesions. 1. Arrow (A) represents…

A: Radioactivity is the phenomenon of heavy elements emitting radiations spontaneously. The elements…

Q: Problem 9. In order to achieve a BER ≤ 1e-6 in a linear AWGN channel with a non- coherent FSK…

A: Here we will use formula for binary non coherent frequency-shift keying.

Q: Devise a model for the automobile antenna of Fig. 1.67.

A: It is asked to devise a model for the automobile antenna shown below

Q: Q) Find rate of information transmission over a discrete channel (Dt) for: When P (x1) - P(x2) –…

Q: Determine if the following AR processes are stationary. Assume that ɛ ~ WN (0,0²), where WN denotes…

A: Given the following three AR processes (a) Xt=2+0.2Xt-1+εt (b) Xt=3+0.2Xt-1+0.7Xt-2+εt (c)…

Q: For the system illustrated in the figure, determine the value of "h" that puts the system un…

A: Find the value of h to system in un equilibrium.

Q: How did the length of the tube affect the amount of standing waves?

A: A standing wave, also known as a stationary wave in physics, is a wave that oscillates in time…

Q: The source sent an ultrasonic signal of the frequency of 5 MHz and received two echo-signals with a…

A: Assuming 60ms= 60 micro second Thickness of organ = 4.35 cm Absorption coefficient = 1.614 per cm

Q: Calculate the sampling frequency for a 4.5 KHz audio signal if it is sampled at a rate of i. 15 %…

Q: 15. Find the value of R, that will produce the indicated closed-loop gain in each amplifier in…

A: The all four parts of the question are solved one by one below.

Q: c(t) and m(t) are used to generate an AM signal. The modulation index of the generated AM signal is…

A: Write the given values along with suitable variables.

Q: R1 ww 11) Consider the following circuit. An ammeter with internal resistance Ri is inserted between…

A: Step 1:Step 2:Step 3:Step 4: Verification for part (a) using simulatorVerification of part (b)…

Q: Which of the following is the Vpp in a CRO waveform if the Vrms value is measured as 2.5 V? О а.…

Q: fine the ratio of impedances for reflected and transmitted for a 10 MHz soundwave propagating from…

A: Given Impedance for fat, Zf = 1.94 GPa Impedance for skull bone, Zs = 31.9 GPa…

Q: The tendency of higher frequency source harmonics of a complex sound to drop off in power relative…

A: Given: Higher frequency source

Q: 41. Find the average value of the periodic waveform of Fig. 94 over one full cycle.

Q: Compute for A • B: A = 7i - 2j B = 7i+ 3j - 4k Select the correct response: О о O 1 unit O 49 units…

Q: how can the spectrum scarcity problem be resolved using cognitive radios? exaplin in detail

A: spectrum scarcity problem be resolved using cognitive radios

Q: The Fourier series for a periodical square wave is O sin (wt) + = sin(3wt) + ½ sin(5wt) + O sin (wt)…

A: The Fourier series of a periodic square wave can be represented as an infinite sum of sine and…

Q: An electric pole of circular cross section, with a bending stiffness &-5500 Nm and a damping ratio…

A: Solution: Given Data: k=5500 N/mξ=0.1m=280 kg To Find: (a) Maximum relative displacement of the…

Q: Select from then list below the equation which represents application of vɛ = VA + VB/A %3D

A: Given data as per question The velocity of A =3 m/s VA=−3j^ (downward…

Q: A sensor is housed in a vacuum chamber with its wall cooled to -150oC. The sensor is heated with…

A: GivenT1=-150oC=-150+273=123KQ=0.5Wε=0.8A=100 cm2=100×10-4 m2

Q: Q1/ Estimate the hot junction temperature for a cooper wires are used in the micro thermopile show…

A: Given dataCold junction Temperature = Room temperature = 25°C = 298 KHot junction Temperature =…

Q: A sinusoidal wave on a string is described by the wave function y(x,t)=0.02sin(30x-400t). If the…

Q: Establish the average and rms values for the following signal function over the time period 0 to 2s:…

Q: 2k m Pw 3m FIGURE P6.1

Q: From the graph shown below, determine the approximate values of tr, tr, tw and amplitude. t;: rise…

A: In a steady state response system, the rise time(tr) is defined as the time taken by response to…

Q: A vertically polarized EM wave impinges on an ideal polarization filter, whose polarization axis is…

A: Given Data Polarization axis, θ=45° Apply the law of Malus The intensity of transmitted is directly…

Q: please help me with my homework. please provide brief explination , many thanks for your time

A: Using formula for Cn we can obtain the required expression and draw spectrumExplanation:Step 1:Step…

Concept explainers

Radiation

Radiation can be described as the energy in the form of a particular matter or electromagnetic waves traveling in the air and can be in the form of light, sound, and heat. Radiation can be detected through special instruments like X-rays. The radiation from a cooler object is less intense as compared to the radiation from hot objects.

Question

Analysis 3: Based on the design of the antennas, the Standard Absorption Rate (SAR) of RF power by the
patient tissue is expected to be as follows:
SAR(t) = 2t + e0.1t+2 where, t is time in seconds.
2. Plot the SAR function for the first 80 seconds.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given data

VIEW

Step 2 Calculation

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How long would it have to be in order for a soundwave traveling at 343 m/s to resonate at 440Hz in this cavity?
Not 12031475@students.liu.edu.lb? Switch account 15 MCQS A standing wave on a string of length L = 3 m is described by the following equation: y(x,t) = 0.08 sin(2Ttx) cos(300t). The fundamental frequency, f1, is: O 25 Hz O 150 Hz 50 Hz 300 Hz 75 Hz
Subject: Mechanical Measurements
this is a text book example NOT for grading, how do they determine k
number of closed loops and forward paths in the signal flow graph shown below is. and
A musical note on a piano has a frequency of 45 Hz. If the tension in the 2-m string is 308 N, and one-half wavelength occupies the string, what is the mass of the wire? O 0.024 kg 0.047 kg O 0.031 kg O 0.040 kg 0.019 kg The wavefunction of a mechanical wave on a string is described by. y(X,t) =D 0.012sin(Ttx-100Tt+2Tt/3). vwhere x and y are in meters and tis in seconds. The transverse velocity of an element on the string at the left end (x=0), at timet=D0
The octave band levels measured by an instrument with perfectly flat frequency response are 78,76,78,82,81,80,80,73, and 65 dB re 20 pPa for the octave bands centered at 31.5,63,125,250,500,1000,2000,4000, and 8000 Hz respectively. Calculate the band levels that would be measured by a sound level meter set to (a) C-weighted and (b) A-weighted
A 15.0 kHz a spherically diverging wave in water with SPL ound pressure (ms) level of 181 d8 re 1microPa at 1m from the source in sea water. a. What is the SPL at 10m. b. What is the pressure ampitude at 1 and 10m. c. What is the acoustic velocity and phase between the pressure and Velocity at 1m and 10m? d. What is the acoustic displacement amplitude and the phase between Pressure and displacement? . What is the Acoustio Power radiated in Watts at 10m?
Consider the solution of the following template 1-D wave equation: +c =0 Using a modified FTCS scheme, in which the term u for time discretization is expressed du du Ət dx as u = (1+1), where the index 'i' represents spatial discretization where as the superscript 'n' represents temporal discretization. Examine the numerical stability of this scheme using von- Neumann stability analysis.
7) A standing wave pattern consisting of seven loops is observed on a 2.1 m long string fixed at both ends. The wavelength, 2, is equal to: (a) 0.6 m (b)0.3 m (c) 0.7 m (d)0.35 m 8) Two strings, A and B, have respective mass densities µa and ug respectively. The linear mass density, Ha, of string-B is nine times that of string-A (Hg = 9µa). If both strings have the same fundamental frequency when kept at the same tension, then the ratio of their lengths LA/Lg is equal to: (a)9 (b)3 (c) 1/3 (d) 1/9
Consider a cylindrical specimen of a steel alloy 8.3 mm (0.3268 in.) in diameter and 84 mm (3.307 in.) long that is pulled in tension. Determine its elongation when a load of 21640 N (4865 lb;) is applied. The tensile stress-strain behavior for this steel alloy is shown in the Animated Figure 6.22. i mm