An unbalanced three-phase wye-connected and grounded load is connected to a balanced three- phase four-wire source. The load impedances Z, Z, and Z, are given as 70 430°, 85-40°, and 50 235° Q/phase, respectively, and the phase a line voltage has an effective value of 13.8 kV: use the line-to-neutral voltage of phase a as the reference and determine the following: The line and neutral currents.

An unbalanced three-phase wye-connected and grounded load is connected to a balanced three- phase four-wire source. The load impedances Z, Z, and Z, are given as 70 430°, 85-40°, and 50 235° Q/phase, respectively, and the phase a line voltage has an effective value of 13.8 kV: use the line-to-neutral voltage of phase a as the reference and determine the following: The line and neutral currents.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The Figure shows a balanced Y-A 3Ø circuit. The phase voltages of the Y-connected source are V, = 11020°, V, = 1102 - 120° and V. = 1102120°, Volts. The line impdedances are Z,=10+j5 Q each. The impedances of the A-connected load are ZA = 75+j255 N each. Determine: Line Currents, Phase Currents (load), Power drawn by the load. Ve ZA Vb
This question in (three phase) subject.. I want the the correct answer from choices ..
A three-phase substation bus supplies a wye and a delta connected constant impedance loads. The loads are connected in parallel. A three-phase feeder with an impedance per phase of Z = 0.6+j1.8 Q connects the loads to a source as shown in the one- line diagram of Figure below. The loads draw the following three-phase power: P1 = 35 kW S2 = 30 kVA pfi = 0.90 (leading) pf2 = 0.85 (lagging) wye connected delta connected The line-to-line load voltage is 480 V. Detemine: (a) the impedance of each load per phase, (b) the total line current flowing through the feeder, (c) the line-to-line voltage at the substation bus, and (d) the total three-phase real and reactive power supplied by the bus. Zfeed Vbus
In a single phase equivalent circuit, the current in the a-phase conductor line is simply the voltage generated in the a-phase winding of the generator divided by the total impedance in the a-phase of the circuit. Select one: O True O False
18. A 415 V, 50 Hz, 3-phase supply of phase sequence RYB is connected to a delta connected load in which branch RY consists of R, = 100. branch YB conists of R₂ = 20 2 in series with X₂ = 60 Q and branch BR consists of a capacitor C= 30 uF. Take Vy as the reference and calculate the line currents. Draw the complete phasor diagrams. (Elect. Machines, A.M.I.E. Sec. B. 1989) 14.54, 1, 10.66 2172,92, 14.46 2-471 (1 = 7.78
Draw a 3-phase wye-connected generator with transmission lines connected to a 3-phase delta-connected load. Assume the lines connecting them have an inductance of j5 per phase. The generated voltages are 120 Vrms with phase 'a' having a phase angle of 0°. The loads are 10 Ohm resistors per phase. When drawing, make sure to label all 3 phases with voltage phasors, line inductances, and load resistances.
Three single-phase transformers are connected Star-delta to step down a line voltage of 221 kV to 35 kV to supply a load of 26 MW at a lagging power factor of 0.89. Calculate the line current in the primary side, IL p. in ampers ILp
The one line diagram of a three phase power system is as shown in Figure 7 Impedances are marked in per unit on a 100 MVA, 400 kV base The load at bus 2 is S2 15.93 MW - j 33.4 MVar, and at bus 3 is S3 77 MW + j 14 MVar It is required to hold the voltage at bus 3 at 400 kV Working in per unit, determine the voltage at buses 2 and 1
(c) In the Y-A system shown in Figure Q2(c), the source is a positive sequence with VRN = 24020° V and phase impedance, Zp = (2 – j3) N. Determine; VRN R Zp VYN Y N Zp ZP VBN B Figure Q2(c) (i) All line voltages, VRY, VYB, and VBr-. (ii) All line currents, IR, Iy and Ig. (iii) Total real power absorbs by the loads.
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020º, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.3322-120° A (C) 0.9962-120º A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
Please Answer My Questions in 30 minutes i'm very needed... Please thank u...
The nature of the characteristic impedance of the line is: a. inductive b. could be any one of these c. resistive d. capacitive