A three phase bank of three 75-kVA single phase transfogmers steps the three-phase primary feeder voltage from 1247 kV to 208/120 V and is connected as shown below. The three-phase bank is supplying a thrée-phase wye-connected induction rhotor load operating at 0.75_power factor, 90 kW Tagging output power and 80% efficiency. a. Draw two phasor diagrams for the primary and secondary voltages. b. Determine the phase difference between VAB and Vab. c. Determine the line current (magnitude and angle) flowing into each secondary-phase conductor, the current (magnitude and angle) flowing in each primary winding, and the line current (magnitude and angle flowing in each phase of the primary feeder. ine inpur

A three phase bank of three 75-kVA single phase transfogmers steps the three-phase primary feeder voltage from 1247 kV to 208/120 V and is connected as shown below. The three-phase bank is supplying a thrée-phase wye-connected induction rhotor load operating at 0.75_power factor, 90 kW Tagging output power and 80% efficiency. a. Draw two phasor diagrams for the primary and secondary voltages. b. Determine the phase difference between VAB and Vab. c. Determine the line current (magnitude and angle) flowing into each secondary-phase conductor, the current (magnitude and angle) flowing in each primary winding, and the line current (magnitude and angle flowing in each phase of the primary feeder. ine inpur

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

design 800v to 14.5v isolated bi-directional dcdc conveter a. choose the converter type with reason b. design each components with safety margin 30% (equations) c. calculate the efficiency (equations)
1- define A. Microgrid B. Distributed generation C. Discuss the advantages and disadvantages of microgrid systems over conventional power systems
Explain the concept of distributed generation and its potential impact on traditional power systems.
QUESTION 3 а) Describe a static energy component in power electronics fundamental. A single-phase full-wave ac voltage controller working on the ON-OFF control technique b) has a supply voltage of 230 V (RMS) 50 Hz with a purely resistive load that is connected in series as of 35 N and 10 Q. The controller is set to ON-mode for 40 cycles and off for 20 cycles. i) Justify whether the converter is operating at the optimum duty cycle (k) of> 50%. ii) Analyse the capability of the converter in supplying the load at 180 V (RMS).
Q6) A three-phase to single-phase, three-pulse cycloconverter delivers power to a load rated at 100 V, 30 A, 25 Hz with power factor 0.8 lagging. a) Draw & derive the output voltage if the ap-60° b) Estimate the necessary input voltage and power factor. c) Draw the mean output voltage if the input frequency is 200Hz. M
A three-phase, fully-controlled thyristor bridge converter is used as line commutated inverter to feed 50 kW power at 420 V dc to a three-phase, 415V (line), 50 Hz ac mains. Consider de link current to be constant. The RMS Current of the thyristor is (a) 119.05 A (b) 79.37 A (c) 68.73 A (d) 39.68 A
A.C. distribution calculationg differ from of d.c. distribation power factor, vectorially calculations, load O power factor only O load only,
Discuss the Power transmission from home to powerplants and provide a picture
Don't copy from Chegg and other websites. Please explain in detail.