Answered: An open tank contains water at a depth…

An open tank contains water at a depth of 3m and 0.8m of oil (SG=0.8). if the tank is accelerated upward at 2.5m/s2, find at the bottom of the tank. a. 55.6 c.48.4 b. 36.4 d.44.8

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 1.) The total depth of water in a tank is 6.7 m. Under a constant head of 3 m, a jet is issued from…

A: Objective: To determine- a.) maximum height to which the jet will rise b.) point which the jet…

Q: SITUATION. A closed cylinder of radius 10 cm, height of 30 cm is filled with water. If the cylinder…

Q: 5 m When theta =-20 degrees, determine (a) the force exerted at B by the hydraulic cylinder BD. (b)…

Q: determine the vertical reaction at point A. 42.5 kips A k 17k/ft 10' B 8.5 k/ft 10'

A: Given, A overhanging beam,

Q: 5 KN 2m 10 KNJ -2m- -4 m Given the geometry in the figure. F1 = 5 kN, F2 = 10 kN a. What is the…

Q: A 8m w = 40kN/m B 10m 100 kN 5m 3m D

A: To find the support reactions at A, B, C and D (We will use moment distribution table)

Q: negligible. The water density is constant. Write the linear momentum equation for the control volume…

Q: SET 3: 100 kN w = 40KN/m С 5m 3m Зт р A 8m Ов OB 10т THREE MOMENT EQUATION METHOD 8) What is the…

Q: 6.68 Water at 20°C is to be pumped through 600 m of pipe from reservoir 1 to 2 at a rate of 0.08…

A: Given, H = 36 mQ = 0.08 m3/sL = 600 md = 15 cmη = 0.75Density of waterρ =9.81 kN/m3

Q: Calculate the reactions at point A,B and C of a figure given below. show your complete solutions.

Q: Starting from rest, a rocket is launched upward (a= 4.20 m/s2). At t= 6.85 sec, the motor shuts off…

Q: The opne-top and completely full cylindirical tank is rotated with a constant angulat velocity…

Q: Calculate the diameter of vertical pipe needed for flow of liquid at R = 1800 when the pressure…

A: Consider the given data

Q: 1. Analyze the frame. 1m 2W(kN/m) 3m 1.5W(kN/m) 2m 3110 60°

A: Given data:

Q: 12 KN/m 10KN/m A 8 m 7 m

Q: 3.5) A 1.44 m diameter circular opening in the side of a vertical tank wall is closed by a circular…

Q: 16 kN 8 kN 24 kN/m 16 kN/m A D 20 kNm 3 m 5 m 2 m

A: Shear force : Clockwise : +ve Anticlockwise : -ve Bending moment : Clockwise : negative…

Q: The 2-meter-high pressure tank below contains gas with internal pressure of 2 MPa. It is subjected…

A: Data given Height of the pressure tank = 2 m = 2000 mm Internal pressure, P = 2 MPa = 2 N/mm2…

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: V A₂=0.02 m² 30° 60° A=0.01 m² This planar water (p = 1000 kg/m³) jet is deflected by a fixed vane.…

Q: For the beam shown in TOS-002, calculate the magnitude of the moment at the midspan in kN-m if the…

A: Given: Total length of beam = 9m Required: Moment at midspan

Q: A vertical rectangular plate is submerged half in oil (s = 0.8) and half in %3D water such that its…

Q: 12m 4.5m 4m 8m

A: Types of forces acting on the dam are- -Weight of the dam (W1+W2+W3) -uplift force(Pu) -Vertical…

Q: A closed tank 2m high and 1m in diameter contains 1.5 m water. The air in the space above water is…

A: Following are the given information. Closed tank height =2 m Closed tank diameter =1.0 m Height of…

Q: 120 kN 40 KN 30 KN 6 m 15 kN 6 m 2 6 8 m-16m 2@ 8m 16m Solve for the vertical reaction at A and B.

A: At hinge joint , Moment will be zero. therefore take moment about the hinge joint (A) zero ..

Q: A light rod which is suspended by a rope as shown in the figure. The ends of the rod are in contact…

A: LET REACTION AT E=RE REACTION AT A=RA THESE REACTION will cause couple whic equal to couple caused…

Q: A quarter circular gate, 4 meters long (perpendicular to paper) hinge about its upper edge, controls…

A: To Determine Horizontal and vertical forces acting on the curved surface.

Q: The tank contains water, oil (S=0.8) and the pressure of the air with (90Kpa), the mass of the ate…

Q: Water flows through an orifice at the vertical side of a large tank under a constant head of 2.2.…

A: Head, H=2.2 m y=1.5 m Assume coefficient of velocity, Cv=0.98

Q: If the pressure in the tank of oil (sp gr 0.80) is 60 psi, what is the equivalent head in feet of…

A: Note... 1 psi= 6894.757 N/m2 1 m = 3.28084 ft.

Q: A 200-mm diameter pipe 810m long supplies water at a velocity of 2.60 m/s and a pressure of 380kPa.…

A: Bernoulli’s equation formula is a relation between pressure, kinetic energy, and gravitational…

Q: The uniform beam has a mass of 60 kg per meter of length. Compute the reactions at the support O.…

A: 1.Draw FBD ; To find : All reactions at support O ( Ox , Oy and Mo )

Q: Determine the maximum height (y) to which the jet will rise above the orifice.

Q: Determine support reaction

A: Given data : Point load=16.2 KNPoint load=16.2 KNUniformly distributed load=10.2 KN/mTo find…

Q: 5.48 Water is sprayed radially outward over 180° as indicated in Fig. P5.48. The jet sheet is in the…

A: Given data:- Water is sprayed radially outward 180° The given jet velocity at the nozzle exit is, 30…

Q: Refer to Fig. 1214. The 3′′diameter orifice has coefficients of velocity and contraction of 0.950…

Q: 5.24 Water enters the horizontal, circular cross-sectional, sudden- contraction nozzle sketched in…

A: Given data in question Velocity 25 ft/s at section 1 Velocity 100 ft/s at section 2…

Question

100%

An open tank contains water at a depth of 3m and 0.8m of oil (SG=0.8). if the tank is accelerated upward at 2.5m/s², find at the bottom of the tank.

a. 55.6 c.48.4
b. 36.4 d.44.8

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

calculate support reaction
11.7 (A/B). A solid shaft carrying a flywheel of mass 100 kg and radius of gyration 0.4m rotates at a uniform speed of 75 rev/min. During service, a bearing 3 m from the flywheel suddenly seizes producing a fixation of the shaft at this point. Neglecting the inertia of the shaft itself determine the necessary shaft diameter if the instantaneous shear stress produced in the shaft does not exceed 180 MN/m². For the shaft material G= 80 GN/m². Assume all kinetic energy of the shaft is taken up as strain energy without any losses. [22.7 mm.]
35 kN/m - 200| Nos. 19 -20: Refer to figure 8. Solutions can be written here on the blank space 19. What is the vertical reaction at A in KN? b) 350 20. What is the reaction at B in KN? b) 350 15 m a) 475 c) 200 d) 125 a) 475 c) 200 d) 125 A B 10 m-
QUESTION 4) Calculate the 12kN/m support reactions and hinge force in the system shown in figure. 6771 H 3m B 3m OG 10kN 4 5kNm A
Reaction at support?
A water siphon having a constant inside diameter of 3 in. is arranged as shown in Fig. P5.105. If the friction loss between A and B is 0.9v2/2 where V is the velocity of flow in the siphon, determine the flowrate involved. Figure P5.105 Q= 3in. 4ft 4ft ft³/s 12ft
A 4m long, 2m wide, and 3m high tank is completely filled with water. Solve the resultant hydrostatic force at the base. 294.2kN O 235.4kN O 197.7kN O 258.9kN
Water flows through an orifice at the vertical side of a large tank under a constant head of 3.4 m. How far horizontally from the vena contracta will the jet strikes the ground 1.6 m below the orifice. Assume cy=0.97 and c=0.66
Situation 4: An open horizontal tank 2 m high, 2m wide and 4mlong is full of water. Determine the amount of water spilled out when the tank is accelerated horizontally at 2.45 m/s in a direction parallel with its longest side in m?. Find the force acting on the side with the greatest depth in kN. 9. 10.
Fluid 5
5-91 Determine the magnitude and locate the line of action of the resultant force R exerted by the water (y = 62.4 lb/ft) pressure on a 5-ft length of the dam shown in Fig. P5-91. 24 ft