An oil is in laminar flow in a ½ in ID tube at 6 gal/min. The oil viscosity is 300 centipoise, and its density is 60 lb/ft³. Calculate the velocity at the center of the tube in ft/s

Q: You are given an orifice meter in which the diameter is at 35 mm and the orifice diameter is at 20…

A: Sine you have put a multi-part question, we can provide you the solutions to only the three parts…

Q: 14.2 W³. A lubricating line has an inside diameter of 0.1 in. and is 30 in. long. If the pressure…

A: The flow rate of the oil.Given:The diameter of the pipe is .The length of the pipe is .The pressure…

Q: For a certain value opening in a shut off valve experiment(exercise 1), the water with a velocity of…

A: given data :  u = velocity = 0.65 m/sec dh= diameter of pipe = 24mm= 24*10-3 m. kinematic viscosity…

Q: 1. A pipe of 100 mm internal diameter carries water at 20°C, which has a density of 998 kg/m³ and a…

A:

Q: Corection the following number k=.02625,Kinematic viscosity(fancy v)=16.55*10^-6m^2/s,Pr=.7…

A:

Q: The Hagen-Poiseuille equation for the laminar flow through a circular pipe is: AP = where AP is the…

A:

Q: The differential pressure is 15"WC and the distance between the bubbler tubes is 3". Calculate the…

A: Given data: differential pressure, ΔP = 15" WC distance between the bubbler tubes, L = 3" = 3×0.0254…

Q: Simulation of laminar gas flow in the pipe with Ansys Fluent Task: 1. Calculate velocity…

A:

Q: A petroleum crude oil having a kinematics viscosity 0.0001 m²/s is flowing through the piping…

A: Dear student, we are suppose to solve only 3 subparts. Please post other parts as a separate…

Q: Liquid A(sp gr = 0.95) at a temperature of 29°C is flowing at a rate of 120gal/min in a pipe with an…

A:

Q: Calculate the Reynolds Number for a fluid with a dynamic viscosity of 0.38 N-s/m^2 and a density of…

A:

Q: Consider a flow through a pipe - see Figure 12.29 in your textbook. Not all the fluid moves at the…

A:

Q: In compressible fluids, which is not assumed to simplify calculation  a. Steady flow b.…

A: Compressible fluids are the ones which can be compressed whose volume decreases and density…

Q: A shaft 70.0 mm in diameter is being pushed at speed of 0.4 m/s through a bearing sleeve 70.2 mm in…

A:

Q: 2. Castor oil flows through a pipe that has a cross-section of an equilateral triangle with a side…

A:

Q: Calculate the dynamic viscosity of an oil, which is used for lubrication between square plate of…

A: Write the given data with suitable variables. A=700 mm×700 mm=0.7 m×0.7 m1000 mm1 mθ=45°W=250…

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp flowing at a rate of…

A:

Q: The pressure difference between two points in pipe due to turbulent flow depend on velocity,…

A: ∆P=fV,D,μ,ρ,ε,L

Q: Calculate Reynolds Number for the flow of nitrogen at 1.2 kg/min in a 1 in inside diameter pipe at…

A: Given: mass flow rate of nitrogen,  m = 1.2 kg/minm = (1.2/60) kg/s = 0.02 kg/sdiameter of pipe, d =…

Q: (b) An oil with dynamic viscosity of 0.8 Pa. s and specific gravity of 0.9 is flowing through a…

A: It isn't not difficult to track down a great deal of data on the distinctions among dynamic and…

Q: A 15 m building use cast iron pipes in their piping system. The water tank located on the top of the…

A:

Q: It is desired to have a laminar flow for the piping svstem shown below. The fluid flowing in the…

A: Given that, Temperature of air, T=70 °C,Dia of pipe 1, d1=2 in,Dia of pipe 2, d2=3 in,Dia of pipe 3,…

Q: A Horizontal tube has a diameter of 7 in., in which alcohol (spec. grav. = 0.80) is flowing at the…

A:

Q: Water is pumped through a horizontal, smooth circular pipe at a bulk velocity of 0.4 m/s. The pipe…

A: Given:Bulk velocity of water through the pipe, V=0.4 m/sInternal diameter of the pipe, d=250…

Q: Fluid is moving at rate of 3m/s in a chamber of a 12inch positive displacement flow meter, if the…

A:

Q: quid is flowing in a pipeline 60 mm in diameter at 8.25 m/hr. If the density of fluid 820 kg. per…

A:

Q: A 295.15K fluid with a density of 990 kg/m^3 and a viscosity of 4.6 kg/m. s, passes at a speed of…

A: The given information in the problem is listed in the following attached image:

Q: An 80 mm schedule 40 steel pipe is 1800 m long and carries a lubricating oil between 2 points A and…

A: As per guidelines we need to answer only first question

Q: Constant density and non-viscuous fuid.     turbulent     static     ideal     isothermal

A: given: Constant density and non-viscuous fuid.

Q: Example :- Calculate the power in W/m3 required for mixing an oil of relative density 0.93 and…

A:

Q: 1. Below is a simple setup of measuring flow velocity using a pitot tube. Which height is useful for…

A: 1) From the pressure balance between the 1 and 2, p1-ρgh2+h3=p2-ρgh1+h2+h3p2-p1=ρgh1 From…

Q: Water flows from a pressurized tank (at 150 kPa gauge) to an open tank 15m above. What is the…

A:

Q: 2. In a 0.32 cm diameter pipe, motor oil passes and is released into the atmosphere with a flow rate…

A: The answer to the given question is given in below image

Q: A shaft 70.0 mm diameter is being pushed at speed of 400 mm/s through a bearing sleeve 70.2 mm in…

A:

Q: 3/ Liquid of density 1200 kg/m² throsh a pipe оf бошт нифере intemal dimeter. an orifice, lo mm in…

A:

Q: A liquid having a Reynolds number of 2900 flows thru a 150 mm diameter pipe, 200 m long. The head…

A: