Answered: An L-C circuit is constructed using a… | bartleby

Related questions

Question

An L-C circuit is constructed using a 722-nF capacitor and 504-mH inductor. At t = 0, the current is
zero and one capacitor plate holds 27 nC of charge. How long elapses (in ms) until the first moment
when that charge is reduced to 31% of its initial value?
ms

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

LC circuit consists of a 20.0 mH inductor and a 0.600 µF capacitor. If the maximum instantaneous current is 0.400 A, what is the greatest potential difference across the capacitor?
A series LC circuit contains a 1000 mH inductor, a 36.0 mF capacitor, and a 12 V battery. The period of electromagnetic oscillations in the circuit is
An LC circuit like the one in the figure below contains an 75.0 mH inductor and a 30.0 uF capacitor that initially carries a 190 uC charge. The switch is open for t<0 and is then thrown closed at t = 0. Qmax (a) Find the frequency (in hertz) of the resulting oscillations. Hz (b) At t = 1.00 ms, find the charge on the capacitor. (c) At t = 1.00 ms, find the current in the circuit. (d) What If? What are the first three times (in ms), after t = 0, when the capacitor is fully charged again? smallest value ms ms largest value ms ell
A 7.2-mH inductor is connected to a current. What is the magnitude of the voltage in the inductor at time t = 3.0 s if the current is I(t) = 5 + 7t -2t2? (Assume two significant digits for each number.)
The voltage across an inductor is proportional to the inductor and the derivative of the current that flow through it. Is it True or False?
A series circuit consists of a resistor with R=2 Q, an inductor with L= 0.05 H, a capacitor with C=0.01 F, and a generator producing a voltage of E(t) = 0.05sin10t. The initial charge and current are both 0. Find the charge and current at time t.
A capacitor with 4.0x 10-6 F and initial charge Q=6.0x10-3 C is connected to an inductor that has L= 2.0H and negligible resistance. During the current oscillations, what is the current in the inductor when the charge on the capacitor is q=-3.0x 10-3 C
A 12.0-V battery is connected in series to a 25.0-Ohm resistor and a 5.00-H inductor. How much energy in Joules is stored in the inductor when the current is changing at a rate of 1.00 A/s?
A series RLC circuit with consists of a 35 2 resistor, a 125 mH inductor, and a 125 µC driven by a 120 V rms, 60 Hz, potential difference. What is the maximum current in the circuit? O 2.8 A O 3.4 A F3 3 O 3.9 A O 4.8 A O 1.9 A F4 $ Q Search F5 % 5 F6 6 F7 & 7 8 h F8 (DELL) * 00 8 F9 prt sc ( 9 F10 d W home ) F11 0 end F12 insert + 11 9:31 PM 8/9/2023 delete
A student builds a series circuit using a 1.20 mH inductor and an initially uncharged 1.20 µF capacitor. The current in the circuit increases linearly in time as i = 19.0t, where i is in amperes and t is in seconds. (Note: For parts (a) and (b), if the voltage is in the same direction as the emf of the battery that supplies the current, express it as a positive voltage. If the voltage opposes the emf of the battery, express it as a negative voltage.) (a) Determine the voltage across the inductor as a function of time. (Use the following as necessary: t. Assume E, is in mV and t is in seconds. Do not include units in your answer.) E, = |-22.8 (b) Determine the voltage across the capacitor as a function of time. (Use the following as necessary: t. Assume AV, is in MV and t is in seconds. Do not include units in your answer.) AVc = (c) Determine the time (in µs) when the energy stored in the capacitor first exceeds that in the inductor. us
You have a series RL Circuit hooked up to a battery ('charging'). This means that the inductor is able to store energy it gains from the battery over time. The inductor has a value of L = 31.000 mH while the resistor has a value of R = 34.00 Ohms. The battery they are hooked up to has a value of EMF = 3.00 V. You can assume that at t = 0 s there is no current in the system and the inductor has no energy stored across it. At time t = 1.250 time constants, what is the current in the circuit? Your Answer: Answer units
An 8.0 mH inductor and a 2.0 Ω resistor are wired in series to an ideal battery. A switch in the circuit is closed at time t = 0, at which time the current is zero. The current reaches half its final value at time: 3 ms 2.8 ms 170 ms 4 ms 250 ms

SEE MORE QUESTIONS