An isothermal continuous flow reactor is needed to carry out the decomposition of ethanal to produce methane and carbon monoxide. The process takes place in the presence of nitrogen at 595 K and 1.5 bar as shown below: CH3CHO → CH4 + CO The reactor used is a plug flow reactor. 1) Detailed sketch of the reactor. 2) Mechanical design

Q: Heat Transfer For a food processing you are diluting 500 kg of juice (cp 3.5 kJkg- 1K- 1) at 70° C…

A: According to heat transfer rate the amount of heat loss in hot fluid = amount of heat gain in cold…

Q: 1. Reverse feed double-effect evaporator is used to concentrate a feed of 10% solids to 20%. The…

A:

Q: Problem 5. A cylinder fitted with a piston contains 2.8 kg of wet steam at 100 kPa and 63% quality.…

A:

Q: Ethylene glycol flowing at a rate of 4.00 kg/s (Cp = 2.650 kJ/kg-°C) is cooled from 100°C to 60°C in…

A: Assumption: steady conditions apply taken as counter current flow. Given: mass flow rate of…

Q: Consider the evaporation of 10% concentrated orange juice flowing at a rate of 2000kg/hr to 50%…

A:

Q: 1. Saturated liquid feed of F = 40 mol/hr, containing 50 mol% A(1)/B(2), is supplied to the…

A: Given data: Molar flow rate of feed = 40 mol/h Composition of feed is, A = 0.5 B = 0.5 Reflux ratio…

Q: crude oil is heated from 295°K by using a residue of distillation unit which to 330°K is to be…

A: GIven: Crude oil is heated from a temperature of Tc1 = 295 oK to Tc2 = 330 oK in a 1-2 pass Shell…

Q: 4. A heat exchanger is to be designed to raise the temperature of 10 kmol/hr of ammonia from 300K to…

A: Given, molar flow rate , n=10 kmol/hr=10×1000 mol3600 s=2.78 mols  Initial Temperature, T1=300 K…

Q: A feed containing 3 wt.% dissolved organic solids in water is fed to a double effect  evaporator…

A: Given that-In double effect evaporator,Solid in feed= 3 % =0.03Concentrated solid= 20%=0.2Enter…

Q: Which of the following statements is not true? 1. The calculation pathway for the overall heat of…

A: The statement which is not true is to be identified.

Q: 1. A triple effect evaporator system connected for backward feeding is used to concentrate a…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: b) Due to hydraulic shock, the pipe ruptured resulting in release of liquid ammonia into the…

A: Given: The Ambient temperature, The atmospheric pressure, fluid pressure inside the pipe, The…

Q: A process stream consisting of benzene vapor at 500oC  and 2 bar is to be cooled to 200oC by…

A: Assume that the given system loop is not adiabatic.   For the given process, label the given flow…

Q: 0% conversion of substance A is obtained by reaction. A and B substances are fed to the reactor at…

A: heat of reaction∆HRX = - 30000 J / mol  Conversion = 0.8 fA0 = 2 mol/secfb0 = 4 mol/sec U = 300 J…

Q: A feed solution of 4000 kg/hr at 45 °C containing MgS04 is cooled to 50 °C to produce manganese…

A: Given, Flow rate of feed solution, F = 4000 kg/hr Initial temperature, T0 = 45 °C Final temperature,…

Q: The elementary liquid phase reaction A + B C +D is carried out adiabatically in a series of tubular…

A: From the above given data; A+B ↔ C+D FA0 = FB0 =10 mol/min Given data; ∆HR =-30 Kcal/molCp = 25…

Q: Sol. Since AU = 0, then the heat on segment ab is QH = TH In | The heat on segment cd is QC = - TC…

A: A Carnot heat engine is a theoretical engine that operates on the Carnot cycle. This system may be…

Q: A batch adiabatic reactor at an initial temperature of 373°K is being used for the reaction, A  B.…

A: The temperature rise after a conversion of 0.5 is 18°C.a thorough description of how the temperature…

Q: The latent heat of fusion and vaporization of water is 333.6 J/g and 2256.7 J/g respectively at the…

A: All the processes  occurring in open environment are constant pressure processes. The constant…

Q: Q2: a) Gaseous ethanol is burned with (k) percentage excess air at the following conditions: The…

A:

Q: 3. Air expands from 200 to 1000 cm3 in a cylinder while the pressure is held constant at 600 kPa. If…

A: Given that V1  = 200 cm3V2    = 1000 cm3constant pressure P = 600 KPaT1 = 20 C = 20 +273.15 =293.15…

Q: A wet copper concentrate initially at 35 °C consists of chalcopyrite with wH20 = 0.095. It is to be…

A:

Q: A triple effect evaporator is evaporating a sugar solution with negligible boiling point rise  (less…

A: The following procedures may be used to determine the surface area of each effect, the steam rate,…

Q: A chemical engineer is studying the two reactions shown in the table below. In each case, he fills a…

A:

Q: 1.) An Engine operating using the ideal Otto Cycle receives air at 15 psia and 75 F, then compresses…

A: Given:Initial pressure,  The compression ratio, The temperature, The heat added,

Q: Hot waters enters a radiator at a rate of 0.5 kg/s, losing heat from 100°C to 75°C. Air flows across…

A: Given: Number of Tubes(N)=50 tubes Inner diameter of tube(di)=5mm=0.005 m Length  of…

Q: . There is a very hot (600 °C) stream of oil exiting a reactor at 100 3. 1 kg/min that must be…

A: Initial oil temperature, Toil(1) = 600°C = 873 K Initial water temperature, Twater(1) = 75°F =…

Q: Ethylene gas and steam at 400 degree C and 1 atm are feed to a reaction process as an…

A:

Q: Cooling a Gas Mixture. It is required to cool a gas mixture composed of 75 mol % N₂, 15 mol% CO₂ and…

A: A mixture of gases is cooled in a heat exchanger.

Q: Steam at 350 kPa and 220°C is fed to a heat exchanger 100 kg/hr of liquid benzene that enters the…

A:

Q: 450 g of water at temperature of 22 °C is being heated until all of it is converted into steam.…

A: Weight of water = 450g = 0.45 kg Initial temperature = 22°c Final temperature = 100°c Specific heat…

Q: Consider a double tube heat exchanger used to cool 3000 kg/h of a solution (Cp = 0.45 Kcal/Kg oC)…

A: Given data: Mass flow rate of a solution = 3000 kg/h Specific heat of solution = 0.45 kcal/kg.0C…

Q: 1. A single effect evaporator is concentrating a feed solution of organic solids from 5 to 40 wt.%.…

A:

Q: Example: A biomass pyrolysis reactor produces a pyrolysis vapor, which is a complex mixture of…

A: According to conservation of energy Heat loss by the system is equal to Heat gain by the surrounding…

Q: 1. Consider the Scherer coal fired power plant in the state of Georgia. It was built in the 1980's.…

A: Hello!  Since you have posted a question with multiple sub-parts, we will solve first three…

Q: 10 kg of H2O is stored in an icebox at - 13.7 C. After a few days, the temperature is measured at…

A:

Q: Q1/ It is desired to produce 0.045 mol/liter of C from the following exothermic reaction liquid…

A: Given data: Feed temperature = 77 0C UA = 1200 J/min.K k at 0 0C = 0.02 m3/kmol.min Activation…

Q: Nitrogen is to be liquefied in a simple Linde process. The feed and recycle are mixed, compressed to…

A: Drawing of the process:

Q: 1-kg/s Glycerin (C₂=2200 J/kg.K) is to be heated from 20°C to 60°C using 2-kg/s Ethylene Glycol (Cp…

A:

Q: Liquid helium and liquid nitrogen are both used as coolants; He(e) boils at 4.21 K, and N2(e) boils…

A: The question deals with discussion of which liquid is the better coolant (on a per-gram basis) near…

Q: What amount of heat is required to convert 10.0 g of water at 80.0 °C to steam at 100.0 °C? (heat…

A: Given: Mass of water (m)=10.0 g Initial temperature of water ( T1 ) = 80 °C=(273+80) K= 353 K Final…

Q: This is an open system with constant height and velocity. Put 100 kmol/s of H2 (H = 5141 kJ/kg) and…

A: Consider an open system with constant height and constant velocity in which following reaction is…

Q: 2. 1 toluene. Entering the process is 0.5126 m³ of toluene (C,Hs) vapor at 124 °C. The liquid…

A: Given: A toluene-water system enters a heat exchanger For toluene: Volume V = 0.5126 m3 and; Let the…