An I-section has the dimensions shown in Fig. Q4 and is subjected to an axial torque, T = 5000 N.m A) Determine the maximum value of the shear stress (Tmax) in the material. B) Find the twist angle per meter length, (0/L). Assume the modulus of rigidity G for the material is 82 GN/m2.

Q: For the truss in figure below, the cross-sectional area of the truss members is A = 500 mm² and…

A: For the truss in figure below, the cross-sectional area of the truss members is A = 500 mm²…

Q: A 100 mm long solid cylindrical part shown here has 15 mm diameter. The loads on the part are: 10 kN…

A:

Q: Suppose that the following rod system is subjected to a specific amount of load that makes the…

A: Given the displacement of node 2 and 3.  Required: Stress at node 1.

Q: 5. A solid steel disk E-200x10^9 N/m^2 start rotation from the rest with constant acceleration. When…

A: given,  Radius R =2 m Final angular velocity , ω0 =2500 rad/s Young's modulus of aluminum  , EAl =…

Q: Why isn’t the force in “CE”= 10root5, because 10^2+20^2=10root5 and not 10root2.

A: Given: find the force in member CE.

Q: a. Determine the ditribution of shear stress in the following circular shafts that are subject to a…

A: Given : The outer radius is The inner radius is The torque is The modulus of rigidity is The length…

Q: The composite shaft, consisting of aluminum, copper, and steel sections, is subjected to the loading…

A:

Q: A 9 cm diameter solid aluminum post is subjected to a horizontal force of V= 8.4 kN and a…

A: Given : The horizontal force is The concentric torque is The yield strenght of aluminum is The…

Q: A 50-mm diameter cylinder is made of a brass for which the stress-strain diagram is as shown. The…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.