Answered: An EDFA amplifier has a rating of 20… | bartleby

Related questions

Question

Written response
Question 17
An EDFA amplifier has a rating of 20 dBm. However, when using an optical power meter only mW is
offered. What reading should you expect on the optical power meter? (round to two decimal places)
Submit Response

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Prior to the switch to digital television broadcasting, and to the popularity of cable television, many homes had outdoor TV antennas. TV-reception antennas for VHF (channels 2 through 13) were constructed with cross wires supported at their centers, as shown in the figure below. The ideal length for the cross wires is one-half the wavelength to be received, with the more expensive antennas having one for each channel. Suppose you measure the lengths of the wires for channels 12 and 6 and find them to be 0.208 m and 0.958 m long, respectively. What is the frequency for channel 12?Hz What is the frequency for channel 6?Hz
h) The difference in arrival time between wave-packets with centre frequencies of ω1 and ω2 is Δt. What is DM in terms of Δt ?
TV-reception antennas for VHF are constructed with cross wires supported at their centers, as shown. The ideal length for the cross wires is one-half the wavelength to be received, with the more expensive antennas having one for each channel. Suppose you measure the lengths of the wires for particular channels and find them to be 1.94 and 0.753 m long, respectively. What are the frequencies for these channels?
An interference filter has a dielectric layer (refractive index 1.34) with a thickness of 0.805 μm. If the determination is to be based on the first-order interference, calculate the wavelength (nm) can be transmitted?
A wire loop 22 cm high is dipped in a soap solution (n = 1.33) and then held vertically. It produces a film whose thickness varies from essentially zero at the top to 1.024 μm at the bottom. The film is illuminated with 517 nm light. How far down the loop (as measured from the top) does the bright band number 3 appear?