an AUDIO tutorial is available for this problem. Species of arsenic found in drinking water include Aso33- (arsenite), AsO43- (arsenate), (CH3)2ASO2" (dimethylarsinate), and CH3)ASO32- (methylarsonate). Pure water containing no arsenic was spiked with 0.40 µg arsenate/L. Seven replicate determinations gave 0.37, 0.38, 0.35, 0.39, 0.39, 0.35, nd 0.38 ug/L. (a) Find the mean. 4.0 pg/L Find the standard deviation. 4.0 ug/L Find the mean percent recovery of the spike. 4.0 % (b) Find the concentration detection limit. 4.0 ug/L

an AUDIO tutorial is available for this problem. Species of arsenic found in drinking water include Aso33- (arsenite), AsO43- (arsenate), (CH3)2ASO2" (dimethylarsinate), and CH3)ASO32- (methylarsonate). Pure water containing no arsenic was spiked with 0.40 µg arsenate/L. Seven replicate determinations gave 0.37, 0.38, 0.35, 0.39, 0.39, 0.35, nd 0.38 ug/L. (a) Find the mean. 4.0 pg/L Find the standard deviation. 4.0 ug/L Find the mean percent recovery of the spike. 4.0 % (b) Find the concentration detection limit. 4.0 ug/L

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Based on the solubility data which solvent(s) used in this experiment would be an effective grease remover? Why is it so effective? Test tube Solvent Solubility (S or I) Solvent (P or NP) 1 Deionized water (H2O) I P 2 Ethanol (CH3CH2OH) I P 3 Hexane (CH3CH2CH2CH2CH2CH3) S NP 4 Dichloromethane (CH2Cl2) S NP
-The density of aluminum is 2.70 g/cm'. Calculate the thickness of a rectangular sheetof aluminum foil with a width of 11.5 cm, a length of 14.0 cm, and a mass of 2.04 g. -Examine your results from your data table in Part 3. Do you have any values for thedensity of the salt solution that lie OUTSIDE the range (& 2s)? If so, list them here: Recalculate & by omitting values that lie OUTSIDE the range. This is the density valueyou should use to determine your experimental % NaCl. part 3 data table included
In the acetic acid determination in vinegar experiment; NaOH was standardized with 0.35 g KHP (molar mass = 204.22 g/mol). The KHP was dissolved in 75.0 mL distilled water in a 250 mL Erlenmeyer flask and titrated to the endpoint colour by dispensing 11.40 mL of NaOH from the burette. Calculate the molarity of NaOH. a. 0.10 М b. 0.15 M с. 0.20 М d. 0.35 M e. 0.25 М
5. please answer a and b
Introductlon In Part (a) of this experiment you will prepare a primary standard. Potassium hydrogen phthalate (KHP) is a monoprotic acid with the formula KHC,H.O. In this experiment KHP is used as the primary standard. A standard solution is one whose solute concentration is accurately known. If a solute can be obtained in a very pure, stable, weighable form, a primary standard solution of it can be prepared directly. You will then use the standardized sodium hydroxide solution to determine the acetic acid content of a dilute unknown solution. Procedure (0) Preparation of a Primory Standard Potassium hydrogen phthalate (KHP) is a primary standard. Weigh accurately by difference, approximately 0.8 g of KHP in a clean, dry weighing bottle and transfer it into a 250 ml conical flask. Add 75 ml of distilled water. Swirl gently. Cover the flask and leave to dissolve, swirling periodicaly. Cautlon: KHP is not highly soluble and care must be taken to ensure it is all dissolved before you…
Is the chart correct?
1)A bottle of concentrated aqueous sulfuric acid, labeled 95.00 wt% H2SO4, has a concentration of 16.5 M. Calculate the density of 95.00 wt% H2SO4. 2)Ascorbic acid in 5 vitamin C tablets was measured by a titration against (100 ± 0.002 M) NaOH solution. It required 10.00 ± 0.05 mL NaOH solution to reach the equivalent point. What is the average quantity of ascorbic acid per vitamin tablet?
SELECT correct responses only 1) Volume percent (v/v%) is temperature-independent. 2) There are three major approaches to expressing solution concentration in terms of percent concentration: weight percent, volume percent, and weight/volume percent. 3) Weight/volume percent (w/v%) is a unit-less quantity. 4) The term 'percent' refers to 'parts per thousand'. 5)A standard solution is a reagent of known concentration that is used to carry out a volumetric titration. 6) The endpoint of a titration is the theoretical point reached when the amount of added titrant is chemically equivalent to the amount of analyte in a sample. 7) A substance that changes color in response to chemical equivalence is known as an indicator. 8) Given a sufficiently diligent and experienced experimenter, it is sometimes possible to reach a titration volume error value of 0.
Consider Table 1, which lists the volumes of the Fe3+ and SCN- solutions used for the continuous variation method. Note that each of the stock solutions is 0.002 M before mixing. What are the initial concentrations of Fe3+ and SCN- for solution 4, where the volumes are both 5 mL? [Initial meaning after they are mixed, but before]they reach equilibrium)
What mass of MgCl₂ 6H₂O is required to make a 0.200 dm³ stock solution containing 25.0 ppm Mg(II)? What volumes of this stock solution are required to make 10.0 cm³ standard solutions containing 5.00, 1.00 and 0.10 ppm Mg(II)?
5. Which term is INCORRECTLY defined? a. linear range - the range over which the response of an analytical method is proportional to analyte concentration b. dynamic range concentration range over which there is a measurable response to analyte, though the response is not linear c. blank solution - a solution containing all reagents and solvents used in the analysis to which no analyte is deliberately added d. standard solutions - solutions for which the standard deviation is known - 6. True or False: Internal standards correct random error caused by run-to-run variation. a. True b. False
The maximum number of valence electrons that any element in the periodic table may have is eight. True or False?