an accurately weighed chelometric standard calcium carbonate of 150 mg was used to standardize Disodium ethylenediaminetetraacetate, using the same procedure set by the monograph. The total volume of EDTA consumed was 37.5 ml . Calculate the molarity and normality of the standard solution. 2

Q: A 25-mL portion of an unknown solution containing Cu²+ and Fe³+ was titrated with 18.05 mL of 0.065…

A: In Titration, At Equivalence point, M1V1 = M2V2    For Titration One, Given: Volume of Cu-Fe…

Q: Write the individual and the overall formation constants for the complexation of Ni with Cl which…

A:

Q: Which are TRUE for the use of indicators with dichromate? Dichromate is orange and changes color to…

A: Please find the below attachment.   Please rate if it is helpful for you.   Thank you.

Q: Calculate the concentration of phosphate in the water sample expressed in mg L1.

A: Concentration of Phosphate standard solution = 102.2 mg/L Volume of each standard solution = 100 mL…

Q: Which is NOT true about EDTA? a. EDTA acts as a complexing agent in compleximetric titrations b.…

A: EDTA(Ethylenediamine tetraacetic acid) is a polyprotic acid with 4 acid, -COOH groups and 2 amine,…

Q: Determine the concentration of [Zn²+] in the complexometric titration of Zn2+ with EDTA, where 15.00…

A:

Q: A 25.0 mL aliquot of 0.0480 M EDTA was added to a 50.0 mL solution containing an unknown…

A: EDTA forms complex with ions in 1 : 1 mole ratio. So first we would write the reactions.  Then we…

Q: Calculate pCd at each of the given points in the titration of 45.00 ml of 0.0010 M Cd with 0.0010 M…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 100 mL of mineral water containing Mg2+ and Ca2+ is taken and titrated with 86.65 mL of 0.06120 M…

A: We know that   EDTA forms 1:1 complex with metals Mg+2 and Ca+2 Initial moles of EDTA = M*V =…

Q: Demonstrate that Cu2+ can be titrated by EDTA in the presence of [CH3COO-] = 0.17 M and pH 9.5. b.…

A: The objective of this question is to show the concentration of Cu2+ ions in a sample using EDTA…

Q: 7. Draw a tiration curve for the analysis of 50.00mL solution of KOH, that is 0.1000 M and that for…

A: Hydrazine is a weak base and KOH is a strong base.

Q: 25.00 mL 0.01000 M Ni2+ is titrated with 0.01000 M EDTA in a solution buffered topH 5.0. Given that…

A:

Q: How is coulometric titration done? Explain step by step.

A: coulometric titration  - Coulometric titration is an absolute determination technique in which the…

Q: 11) What is the pM in a titration of 20.0 mL of 0.05 M Ca2 with 0.05 M EDTA if the titration is…

A:

Q: Calculate pV2 + at each of the points in the titration of 23.38 mL of 0.0440 M EDTA with 0.0220 M…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Elaborate the reason why EDTA is used in many complexometric titrations. How will you be able to…

A: complexometric titration (sometimes chelatometry) is a form of volumetric analysis in which the…

Q: Titration of a 25.00 mL sample of mineral water (containing both Ca2+ and Mg2+) at pH 10 required…

A: The objective of the question is to calculate the mass of MgCO3 in the mineral water sample. This…

Q: 25.00 mL 0.01000 M Ni2+ is titrated with 0.01000 M EDTA in a solution buffered to pH 5.0. Given that…

A: EDTA, or ethylenediaminetetraacetic acid, is a popular chelating agent that’s used in food, as a…

Q: Aluminium (III) reacts with the Chelating agent HL to give a complex AlL3 that is readily soluble in…

A:

Q: Calculate the pZn value after the addition of 25 mL of titrant in the titration of 50 mL of 0.01 M…

A:

Q: The equilibrium constant for the reaction 2CrO,2 + 2H → Cr,0;² + H,O is 4.1x1011. The molar…

A:

Q: Which of the following will cause no change in the amount of Fe calculated from the results of an…

A: Iron can be estimated spectrophotometrically by complexing Fe2+ with o-phenanthroline.

Q: A mixture of pure potassium permanganate and pure potassium chromate weighing 0.2400 gram, when…

A:

Q: A river water sample was titrated against 0.0250 M EDTA to test its hardness. of 0.0250 M EDTA. A…

A: Here we have to determine the hard ness of river water in ppm  from the following given data from…

Q: A 5.323 g of dried eggshell is transferred to a 250-mL beaker and dissolved in 25 mL of 6 M HCl. The…

A:

Q: a. A 40.0 mL sample containing 0.0400 M Ni" was titrated with 0.0400 M EDTA at pH 11.0. Given pkyy…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Write the principle behind the following methods of refining :(i) Hydraulic washing(ii) Vapour phase…

A: The principle behind these processes are, (i) Hydraulic Washing: This method is based on the…

Q: Calculate pCd²+ at each of the given points in the titration of 50.00 mL of 0.0070 M Cd²+ with…

A:

Q: A urine specimen was diluted to 2.00 L. After the solution was buffered to pH 10, a 10.00-mL aliquot…

A:

Q: What is the equivalence volume when 0.0500 M EDTA is titrated with 100.0 mL of 0.0500 M Mn+ buffered…

A: Volume of EDTA(V1) =?Concentration of EDTA(M1) = 0.0500 MConcentration of Mn+(M2) = 0.0500 MVolume…

Q: 7. Explain why Mg-EDTA complex is added to the titration mixture in the determination of calcium…

A:

Q: using the An accurately weighed chelometric standard calcium carbonate of 200 mg was used to…

A: Disodium ethylenediaminetetraacetate, also known as disodium EDTA, has the following structure: In…

Q: The equivalence point is reached when 25.00 mL of 0.100 M EDTA is titrated with 25.00 mL of 0.100 M…

A:

Q: 6. The solubilities of the sulfate and chromate of Barium in this reagent is used to distinguish the…

A:

Q: A 50.00-mL sample containing 0.004500 M Zn²+ was titrated against 0.01000 M EDTA. To ensure that the…

A: Given: Concentration of Zn2+ = 0.004500 M Volume of Zn2+ = 50.00 mL Concentration of EDTA =0.0100 M…

Q: Calculate for the molar concentration of the Mg-EDTA complex during the titration of 48.0 ml of…

A: αY4- = 4.8*10-4 The balanced equation for the formation of Mg-EDTA complex is: Mg2+(aq) +…

Q: A cyanide solution with a volume of 12.99 ml was treated with 30.00 mL. of Ni solution (containing…

A:

Q: A cyanide solution with a volume of 13.87 mL was treated with 24.00 mL of Ni+ solution (containing…

A: Concentration of CN- can be determined from the amount of Ni2+ used in the titration of CN-.

Q: A solid containing tris was dissolved in water and brought to a total volume of 50.00 ml. A 10.00 ml…

A: