Ammonia in a large container overheats to 14 bar, 300°C, due to a failure. At this state, a small crack opens in the container that acts as a nozzle. The outside environment is at 1 bar, 25°C, and the mass flow rate of Ammonia is 10 g/s . Assume negligible nozzle inlet velocity and adiabatic reversible flow. What is the exit velocity, and the exit cross section?

Q: Part b) Air enters an adiabatic turbine at 11.3 MPa, 300 K, and exits at 3.75 MPa, 240 K. Use the…

A:

Q: Thermodynamic review I cannnot solve! Someone answered this question for me but I was hoping there…

A:

Q: Can you provide the step by step solution how to get the answers? Steam flows adiabatically through…

A: Initial Pressure  p1=1517 KPa=1517000 Pa Final Pressure at the  p2=965 Kpa=965000 Pa Initial…

Q: a. The compressor power (kW). ɔ. The mass flow rate of the water (kg/s). c. The nozzle exit velocity…

A: We will use simple energy conservation

Q: Due to a failure, ammonia in a large container overheats to 14 bar, 300°C. At this state, a small…

A:

Q: pressed liquid water enter poiler at 500°C, 3000 kPa

A: Write the value of enthalpy from the steam  table as follows-

Q: Oxygen enters an insulated 12-cm-diameter pipe with a velocity of 50 m/s. At the pipe entrance, the…

A:

Q: can you help me with this question that i found online

A: refer to the explanation section for Question 2, and Question 2.Explanation:

Q: Refrigerant-134a, at 1.5 MPa, 90 °C, is to be cooled by air to a state of 1 MPa, 27 °C in a…

A:

Q: Saturated vapor water at 100 kPa enters an isentropic compressor and exits at 2 MPa. Note that…

A: Given:At compressor inlet:Phase: saturated vaporAt compressor outlet:Compressor is isentropic i.e.…

Q: (25 p) Steam at 30 bar and 320°C enters to a mixing chamber with a rate of 50000 kg/h and mixed with…

A: Condition for steam P1=30 bar T1=320°C m1˙=50000 kgh or ms˙=13.88 kgsecCondition for water P2=25 bar…

Q: What is the temperature, in K, of the O2 in the final state?

A:

Q: 12.5 Air initially at 50 psia and 660°R expands to atmospheric pressure. The process by which this…

A: Given Data: p1=50 psiaT=660oRpV1.3=Cp2=14.7 psia   To Find: (a) Final temperature. (b) Change in…

Q: Air enter the compressor operating at steady state at 330K, 100 kPa and exist at 150kPa Stray heat…

A: During a thermal process, if the entropy of the substance remains constant, the process is termed…

Q: Air enter the compressor operating at steady state at 330K, 100 kPa and exist at 150kPa Stray heat…

A: Given Data: The initial pressure of air,P1=100 kPa Initial temperature of air, T1=330 K The final…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.