Q3: A pressurized tank filled with oil (S= 0.85). If a triangular plate was installed atone side of the tank as shown in Figure below. Find the total pressure force, F on theplate and its location from the liquid surface, h, When the pressure gage on the top ofthe tank reads 33 kPa.Ip = 33 kPaAirOil2.2 m0.60 m0.6 m0.3 m

x¯ = 2.15 + a2 = 2.15 + 0.20 = 2.35 m P= Total pressure at cable of pressure = fg x + 44 ×…

Answered: Air Oil

Engineering

Mechanical Engineering

Air Oil

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: As the temperature of the oil incresases _______________ of oil decreases. Specific volume Weight…

A: Viscosity is inversely proportional to the temperature As the temperature of the oil increase…

Q: Fin Fan air Cooler must be flat and horizonal position during preservation time for what any…

A: A fin air cooler, also known as a fin addict cooler or air fin cooler, is a type of heat exchanger…

Q: What is use to clean solutions that eventually become spent and must be disposed of properly

A: Few washers are used to clean solutions. These are given as, (1) Sump pits (2) Car washers (3) Part…

Q: What improvements can be done to increase the efficiency to boil the water?

Q: How to compute the power of the air compressor?

A: An air compressor is a machine that compresses air and stores it in a tank or reservoir. The…

Q: what should you know before choosing a respirator

A: Workers should use respirators for cover from contaminants within the air on condition that…

Q: Which of the following gases is the least dense? A.oxygen B.helium C.carbon dioxide D.argon

A: The density of the above gases at standard temperature and pressure are tabulated below: S. No.…

Q: Combustion air fans andits lubrication system Alt inlet from atmosphere Bearings Ait outlet to steam…

A: The figure represents the Combustion air fan and its lubrication system. Combustion Air Fan and…

Q: Which one of the following mechanisms is used to control the rotor speed of the wind turbine?…

A: Objective: To determine the mechanism used to control the rotor speed of the wind turbine.

Q: What prevention measures would the student take to prevent fluid overload?

A: given; What prevention measures would the student take to prevent fluid overload?

Q: What should be done to prevent excessive deposits and buildup within the cooling system? Select one:…

A: Objective: To select which of the given options are used to prevent excessive deposits and buildup…

Q: What is normal air flow rate?

A: Air is the fluid and every fluid has the tendency to flow. when the airflow from the higher pressure…

Q: A technician is inspecting a vehicle and finds the upper radiator hose is collapsed, and the cooling…

A: Given :- A technician is inspecting a vehicle and finds the upper radiator hose is collapsed, and…

Q: Different types of air conditioning system

A: The air is cooled and dehumidified using an air conditioning system. The classification of the air…

Q: Different types of equipment wind power system (whole)?

A: The Major parts or equipment in wind power systems are as follows: 1. Tower 2. Nacelle 3. Rotor 4.…

Q: placed by oil in the wate

A: Given Data : Water is replaced by oil in water pump

Q: Which of the following is NOT the all air system?

A: To find :- Correct option

Q: As the rank of the coal increases, the moisture content _________ a. increases b. decreases c. no…

A: To fill: The blanks of the statement. Explanation: Rank of coal: The rank of coal depends on the…

Q: A reddish-colored oil is discovered to be leaking during an engine oil change and inspection:…

A: Leak fluid color and its use in an automobile is shown in tabulated form Leak fluid color fluid…

Q: how can a hermetic compressor be tested for efficiency

A: Hermetic compressor: In this type of compressor, the compressor and motor are in same unit. It has…

Q: Which of the following situations will make a pump noisy? Select all that apply. O Excessive oil…

A: Answer:- All given situations will make the pump noisy. The various situation that will make the…

Q: How does sludge occur? Engine fuel reacts with condensed blowby. A faulty manifold…

A: With continuous use, the engine oil collects coolant, earth, water, fuel, and different impurities.

Q: As the temperature of the oil incresases _______________ of oil decreases. Viscosity Capillarity…

Q: Conduct FTA(Fault Tree Analysis) for the hydrogen gas station. You should have at least 4 basic…

A: Given : To find: Fault tree analysis

Q: How is air flow pressure measured

A: Normal air flow rate : Normal flow rate is 1 atm (101.3 kPa) 0r 14.696 psia at 32degree F.…

Q: In detail what are water fog systems

A: Water fog is the process in which water is made in the form of fine spray of water droplets. This…

Q: GIVE THE JOB OR OPERATION WHERE HIGH AIR HUMIDITY IS PRESENT

A: Humidity is the concentration of water vapor in the air. water vapor in the gaseous form is…

Q: For a hydraulic power unit, this part protects the pump from taking in any harmful particles that…

A: GIVEN DATA - A MCQ GIVEN RELATED TO PUMP WE HAVE TO CHOOSE CORRECT OPTION

Q: Characterize the types of evaporators used in R&AC system mentioning the principle of working in…

A: Depending upon the heat transfer process or refrigeration flow there are several way of…

Q: Air service unit and air cooler is not available in closed type of fluid power system. Select one:…

A: There are huge availability of the air in the atmosphere. The coolers are use to cool the air and…

Q: Which type of oil filter uses an anti drain back valve to prevent it from emptying of oil when the…

A: Which type of oil filter uses an anti drain back valve to prevent if form emptying of oil when…

Q: Example procedure of Level, Flow, Pressure and Temperature control system

A: Introduction: A control system is a system of interest for a specific analysis in space. The control…

Q: design of diaphragm pumps maintenance and replacement

A: Given Diaphragm pumps To find Maintenance Replacement

Q: Give an example of Reducing the Air Pressure Setting.

A: The setting of reducing air pressure is concerned with the setting of the air compressor. Air…

Q: Which one of the following has the ability to introduce a restriction into a line to reduce the…

A: To find - Which one of the following has the ability to introduce a restriction into a line to…

Q: Why does water not dissolve motor oil?

A: Water has a formula H2O . It has a hydrogen bonds. Oils as well as fat does not contain any polar…

Q: A vehicle is having its water pump replaced. When the water pump is removed, severe corrosion is…

A: A vehicle is having its water pump replaced. When the water pump is removed, severe corrosion is…

Q: Why the car overheat

A: Given Data ⇒ Overheating of car

Q: Select the type of coolant which is very toxic. O a. Mix of Long-Life ethylene glycol and Propylene…

A: Given data

Q: acts as a ... .reservoir for the lubricating oil Oil filter O Oil gallery O Oil sump O oil viscosity…

Q: Could you pump refrigerant into the receiver if the compressor valve leaks?

A: This question is based on the concept of compressor valve leak

Q: The oil in the pump should be replaced after the first ____________ hrs. a. 200 b. 0.002 c.…

A: There is a thumb rule of changing for a oil-lubricated pumps...

Q: Enumerate safety practices in air separation plant

A: Solution: Air separation plant simply separates the different components present in the air. This…

Q: y does a system need to be maintained?

A: we will discuss the need for maintenance

Q: Identify the factors that need to be considered in determining an air cleaner's overall size and…

A: The factors are -

Q: Wet gas coming from a reservoir flowing into the wellbore turns from liquid to gas in separation…

Concept explainers

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.

Question

100%

Q3: A pressurized tank filled with oil (S= 0.85). If a triangular plate was installed at
one side of the tank as shown in Figure below. Find the total pressure force, F on the
plate and its location from the liquid surface, h, When the pressure gage on the top of
the tank reads 33 kPa.
Ip = 33 kPa
Air
Oil
2.2 m
0.60 m
0.6 m
0.3 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Identify and discuss the function of each part. Turbine Fuel Flow Meters Viscous-flow air meter
True or False: Continuity equation is based on the conservation of energy.
Steam powerplant
Applications of trash pump
26. In this intake process, there is no intake pressure boost system. Intake of air and fuel is only induced from the manifold due to the created vacuum of the piston while in operation. d. Naturally Aspirated a. Vacuum charged b. Turbocharged c. Supercharged
What type of fluid is used in a pneumatic system? Industrial Maintenance
Milky looking engine oil is most likely caused by: Select one: a. A faulty radiator b. A leaking heater hose C. A blown head gasket d. Corroded water pump impeller fins
Any of various receptacles for receiving water from a water system and discharging the liquid waste into a drainage system.
List some of the good operating practices for boilers. Describe some of the emergency operation procedures.
When there is an excess potential energy during the fluid flow, it can be stored using O a. pressure relief valve. O b. pressure reducing valve. O C. accumulator. O d. pressure absorbing valve.