Air at 15°C forms a boundary layer near a solid wall. The velocity distribution in the boundary layer is given by: u/U = 1- exp (-2y/6), where U = 35 m/sec. and 6 = 0.8 cm. Find the shear stress at wall (y = 0).

Air at 15°C forms a boundary layer near a solid wall. The velocity distribution in the boundary layer is given by: u/U = 1- exp (-2y/6), where U = 35 m/sec. and 6 = 0.8 cm. Find the shear stress at wall (y = 0).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The streamlines in a particular two-dimensional flow field are all concentric circles, as shown in Fig. 5 the equation v, = wr where w is the angular velocity of the rotating mass of fluid. Determine the circulation around the path ABCD. The velocity is given by B Figure 5
Q2: A) Assuming linear variation of velocity in the boundary layer i.e. (u/u) =(y/6), up to y= 8 and then u = u, determine using the integral momentum equation, the boundary layer thickness. B) The temperature ratio: [T,-T)/(T, -T)] = sin (zy/0.015) in flow over a flat plate. If k = 0.03 W/m.K, determine the value of convective heat transfer coefficient.
A laminar boundary layer is described by the following profile: 2 2 (²/2) - (²/7) if u (y) = u。・ Uo 1.195mm calculate the shear stress induced on the wall at y=0. d = н du dy 5 μ= 1.5.10 Pa s U = m = 10- S
An incompressible viscous flow is contained between two parallel plates separated from each other by distance b. as shown in Figure 1. The flow is caused by the movement of the upper plate which has a velocity U, while the bottom plate is fixed. If U =7 m/s and b= 1 cm, and there is no pressure gradient in the flow direction. A.) Start with Navier-Stokes equations and determine the velocity at the point x = 3 cm and y= 0.41 cm. The value of the velocity is.B.) Calculate the magnitude of the vorticity at the same point. The magnitude value of vorticity. C.) Calculate the rate of angular deformation at the same point. The angular deformation value
The block of weight W = 50 N is pulled by a weight W0 = 60 N along the surface of a table by means of an inextensible cable and a pulley. Between the block and the table there is a uniform layer of oil of viscosity m = 0.1 Pa-s and clearance h = 2 mm. The contact area is 0.01 m2. Find the terminal velocity U if the table is very long.
(a) A wing section with a chord of c and a span of b is mounted at zero angle of attack in a wind tunnel. A pitot probe is used to measure the velocity profile in the viscous region downstream of the wing section as shown in the figure. The measured velocity profile is u(z) = U∞ - (U/2) cos[TZ/(2w)] for -w ≤ z ≤w. Here, w = 0.02c. Assuming a constant pressure p = po along the streamlines (dashed lines in the figure) and across the wake where the velocity was measured, calculate the friction drag coefficient Cp, of the wing section. U Streamlines u = U_ -- cos 22 2W² +w Viscous wake = -W (b) Consider a thin flat plate at zero angle of attack in an airflow at P∞ = 1.225 kg/m³, T∞ = 288 K and μ∞ 1.7894 x 10-5 kg/m/s. The length of the plate is 2 m and the span is 0.5 m. Assume the boundary layers on the plate are laminar throughout (on the upper and lower surfaces both) where LBL(x)/x = 0.664/√√/Rex applies. The freestream velocity is 100 m/s. Calculate the friction drag (Df) of the first…
Prove Navier Stokes equation for incompressible fluids
3. Air is flowing parallel to the plate at U.-5 m/s and T=300 K over the flat plate of length L=0.1 m and depth of 1 m into the paper, at the atmospheric pressure at the same temperature as the plate. Find; a) Boundary layer thickness at the point x = L of the plate b) Find the total resistance force acting on the two surfaces of the plate. c) The velocities in the hydrodynamic boundary layer are measured by a hot wire anomemeter. The velocity at x=0.1 m on the x component is measured as u=3 m/s. Find the distance from the plate and the y component of velocity v.
The velocity distribution of air between two parallel plates is linear. The top plate is moving with a velocity of 5.8 m/s and the distance between two plates is 0.1 cm. Find the shear stress at the lower wall if the dynamic viscosity of air is 2X10-5 N.s/m2. (your answer should be accurate to 5 decimal places)
Rain water is flowing through an inclined plane under gravity as shown in figure. A thin layer of thickness h is formed over the plate. An upward wind flow that exerts a shear stress on the upper surface (y = h) of the liquid layer. The wind flow tends to push the rain layer upward while gravity pulls the layer downward Write continuity and and Navier-Stokes equations to model this flow field. (Assume the flow is fully developed) Obtain expressions for the liquid velocity profile, the shear stress distribution, the volume flow rate, and the the expression for the thickness h of the liquid layer for which there is no net volume flow along the roof
plllllzzzz help me right nowww plzzzz Incompressible air (density=1.2 kg/m3) flows around the car, if the pressure coefficient at point A is Cp= -4.9 and the reference dynamic pressure is 20 kpa, then what is the velocity of air at point A?