Aer 3 300 100

Q: Determine the tensile strength of the welded A992 WT4×20. WT4 × 20 PL - Transverse weld

A: Given:- The steel section used = WT 4×20 The steel used = A992  To determine:- The tensile strength…

Q: Two 12 mm thick grade 350W steel plates, depicted in the figure below, are to be welded together…

A:

Q: A fillet welded joint of 6 mm size is shown in the figure. The welded

A:

Q: Question 1: The rubber band given below is subjected to the following tensile loading. Calculate the…

A: Allowable tensile strength of rubber, Allowable shear strength of steel, Tensile force, Width of…

Q: A W18×86 beam is riveted tona W24×117 grinder by q connection as shown in the figure. The diameter…

A: Bearing strength is the maximum stress load that the unit can hold before the structure fails. But…

Q: A 100 x 100 x 10 mm angle is to be welded to a gusset plate. The angle carries a load of 200 kN…

A: Retaining walls are moderately robust walls used laterally to hold soil so as to be retained on both…

Q: Two plates are connected by fillet welds of size 10 mm and subjected to tension, as shown in the…

A: Given:Load carried by both the weldsLoad carried by each weld.Constant that depends upon the angle…

Q: a. Determine the design strength of a 1-in length of a 1/4-in fillet weld formed by the shielded…

A: Consider the given data Size of weld=1 inchLength of weld=1/4 inchTensile strength, FEXX=70 ksi As…

Q: A fillet-welded joint is shown in the figure. The size of weld is 8 mm and safe stress in the weld…

A:

Q: A fillet-welded joint of 6 mm size is shown in the figure. The welded surfaces meet at 60-90 degree…

A:

Q: A mild steel flat of width 120 mm and thickness 10 mm is bent into an arc of a circle of radius 10 m…

A: Width of mild steel flat b=120 mm,Thickness t=10 mm,Radius R=10 m,To Find-The value of the pure…

Q: Two steel plates, each 400mm wide and 12mm thick, are to be joined  together by a lap splice…

A: t = 12mm For thickness of main plate <= 1/2 inch (12.7 mm) (a) S (weld size) = 3/16 inch =…

Q: A fillet-welded joint is shown in the figure. The size of the weld is 8 mm. Safe stress in the weld…

A: A fillet-weld joint-Size of the weld S = 8 mm,Permissible stress in the weld =110 N/mm2,To Find-The…

Q: A welded bracket connection is shown in figure. It supports a factored load of 150 kN at a distance…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.