a. Two brass rods used as compression members, each of 3-m effective length with pin end, have the cross sections shown in Figure Q5a. Determine the wall thickness of the hollow square rod for which the rods have the same critical buckling load. P O 40 mm 60 mm

Q: The column AB is connected to the frame through pin-joints as shown in Figure 1. There exists a…

A: Given  G = 40 KN/m Q = (LL) = 20 KN/m   d=depth= 198 mm  bf = flang width = 99 mm  tf = flang…

Q: The frame shown in the figure is loaded as shown. (a) Draw the FBD for the frame. (b) Determine the…

A: The hinge at A gives the horizontal and vertical reaction The roller at E gives the horizontal…

Q: The A-36 steel plate has a thickness of 12 mm. If there are shoulder fillets at B and C, and allow =…

A: Given A36 steelt=12mmσallow=150MPa

Q: The pin-connected structure consists of a rigid bar ABCD and two axial members. Bar (1) is bronze [E…

A: The given information in the problem is shown in the following attached image:

Q: A nail connected spaced column is fabricated from two shafts of equal cross-section of 65mm x 250mm…

A: Step 1:Step 2: Step 3: Step 4:

Q: 15 in 05 im 24 in The machine link shown is subjected to an axial load P, as shown. The link is…

A:

Q: The A-36 steel rod BC as shown in Figure Q3 has a diameter of 54 mm  and is used as a strut to…

A: For solution refer below images.

Q: The simplest truss consists of two rods and is loaded by a force. F Given: angle a=64°. Cross…

A: Find the largest force Given data:- Yield strength = 270 Mpa Factor of safety = 2.2

Q: The metallic hollow pipe shown in Figure Q1 is fixed at both its ends, and is under axial…

A:

Q: Consider two types of a column cross-section: a hollow square and a hollow circular section. In both…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.