A. Estimate the torque on a 10 mm dimeter steel shaft when yielding begins using (a) the Tresca and (b) the Von Mises theory. The yield strength of the steel is 140 MPa.

Q: Give a complete solution, Don't use the direct formula. [1] A semicircular groove with a 5-mm radius…

A:

Q: 2.20. The uniaxial yield strength of annealed AISI 1015 steel is 386 MPa. Estimate the shear stress…

A: Given data: It is required to determine the shear stress according to the Tresca’s theory and…

Q: Estimate the 10³-cycle fatigue strength for rotating bending and also the bending endurance limit…

A:

Q: A mild steel shaft of 50mm diameter is subjected to a bending moment of 1.9kNm. If the yield point…

A: Introduction The maximum shear stress hypothesis states that a material will fail or yield if its…

Q: Shafts A and B are made of the same material and have the same cross-sectional area, but A has a…

A:

Q: A 1 m length of 50 mm diameter steel bar is subjected to a torque  of 230 Nm.  Calculate the maximum…

A:

Q: The tubular rotor shaft of a wind turbine shown in Figure 3(a) is of 50 mm and 40 mm outer and inner…

A:

Q: A 9 cm diameter solid aluminum post is subjected to a horizontal force of V= 7.8 kN and a…

A:

Q: Q6/ A material has a true stress -strain curve given by o=Kɛ", derive and calculate the true and…

A: Given data: σ=Kεnk=689.47 kPan=0.5 Need to determine the true ad engineering ultimate tensile…

Q: A part made of Aluminum 6061-T6 has a yield strength  = 400 MPa. For each stress state below, draw…

A:

Q: The shaft shown is machined from C1040, OQT (oil-quenched treatment) @ 1,000°F. It is subjected to a…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.