A Y-connected bulanced three-phase generator with un impedance of 0.4+ j0.3 2 per phase is connected to a Y-connected balanced load with au impedance of 24+j19 2 per phase. The line joining the geucrator and the load has an impedance of 0.6 + j0.7 2 per phase. Assuming a positive sequenee for the source voltages and that Var = 120/30 V. find: (a) the line voltages, (b) the line currents.

A Y-connected bulanced three-phase generator with un impedance of 0.4+ j0.3 2 per phase is connected to a Y-connected balanced load with au impedance of 24+j19 2 per phase. The line joining the geucrator and the load has an impedance of 0.6 + j0.7 2 per phase. Assuming a positive sequenee for the source voltages and that Var = 120/30 V. find: (a) the line voltages, (b) the line currents.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Part g
Do all the steps...
A Y-connected balanced three-phase source is connected to a three-phase balanced load through a four-wire three-phase cable. The generator has an impedance of 0.1+j0.3 Q/phase. Each phase of the cable has an impedance of 2+2j 2 The phase "B" load voltage is 102-140° kV. The impedance of each phase of the Y-connected load is 3-j5 Q/phase. For a negative sequence: 1- tto pointe) Calculate "terminal" phase voltage of phases "a" and "c" of generator. 2- E points] Calculate Vab and Vca across the load. 5 points Calculate three phase power supplied by the source. 4- 10 point] Calculate three phase power losses.
In a balanced tephasic system Y - Delta of the figure. Find the line current IL and the average and supplied power to the load
A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. The power factor at the load is: O A. 0.447 lagging O B. 0.707 leading O C. 0.447 leading O D. 0.707 lagging O E. None of choices are correct
QUESTION 6 Find the total real power dissipation in a balanced wye-delta system. Load impedance is 5kN270° and phase voltage is 320V RMS O 63W 99W 150W 36W
Determine the value of the impedance, Z₁, that causes maximum power transfer in the circuit shown in Figure Qlc. 52 j24n -j12.35n (V₂) j2403 j24n Figure Qle B
Solve it please fast
Please Answer My Questions in 30 minutes i'm very needed... Please thank u...
2. For the following system shown in the figure, calculate: a. The current through each phase of the load. b. The total real and reactive power of the three-phase load. c. The power factor at the load side. A 220 V 20° 220VL-120° U8 vol 152 I 220 VI20° 9. M.
i need the answer quickly
20) Two AC generators A and B are in Parallel. Each generator has an emf of 1000V per phase and in phase, the phase impedance are ZA = 0.1+j2 ohms, ZB = 0.2+j3.2 ohms respectively. If the common load has an impedance of (2+j1) ohms per phase, solve the voltage per phase at the load