A voltage divider of 50 ohms is 2 p connected across a 100 V DC source. A load resistance of 10 ohms is connected across a tap in the potential divider and the negative of the source. If a current of 4 A flows towards the load, what is the current supplied by the source?

Q: A circuit has resistance of 20 ohms and a reactance of 30 ohms. What is the power factor of the…

A: In this question we need to find a power factor of the given circuit.

Q: AC circuit that has a resister Current of 0.75A, and 125V. An inductor with 208 valts. What is the…

A: The voltage across resistance VR = 125 volts,Current through resistor is I = 0.75 A,Voltage across…

Q: Two batteries of nominal voltage 12 V are connected to a charger as shown in the figure below. The…

A: Step 1: Lets assume that voltage at the node of two battery connected is V.Given that,Step 2:…

Q: 4.-For-labeled currents, draw an arrow to show the direction of the actual positive current. For…

A: Given labeled currents flow and labeled volatge polarities. we need to draw the actual positive…

Q: Most sources of electrical power behave as (approximately) ideal voltage sources. In this case, if…

A: It is given that source is independent current source. And condition is given that load should…

Q: a. For the resistors in series, is there a significant difference in the values of individual…

A:

Q: A student wants to measure the electric potential difderence across the resistor R2 for the circuit…

A: Fig: Given circuit  It is known that voltmeter should be connected parallel to the element  in…

Q: electric power system

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: Find the value of the voltage V from the figure given below:

A: Draw a schematic diagram and show the mess analysis in outer loop,

Q: In the figure on the right, the ideal batteries have emfs &1= 10 V and 82 = 83 = 6 V and the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find the equivalent resistance between points A and B of figure

A:

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.