A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5 m from one leg. The differenco in elevation of water levels in the two legs, open to almosphere, when the speed of rotation is 45 rpm is, nearly.

A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5 m from one leg. The differenco in elevation of water levels in the two legs, open to almosphere, when the speed of rotation is 45 rpm is, nearly.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The pressure intensity for a inclined plate is maximum on the surface of the earth and decreases as…

A: Pressure intensity increases as we move from earth's surface to to the centre of the earth, while it…

Q: It the surface tension of water in contact with air is 0.075 N/m. what correction need to be applied…

A: Surface tension, σ = 0.075 N/m Tube diameter, d = 4 mm or 0.004 m

Q: 1.) The total depth of water in a tank is 6.7 m. Under a constant head of 3 m, a jet is issued from…

A: Objective: To determine- a.) maximum height to which the jet will rise b.) point which the jet…

Q: An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of…

Q: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…

A: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…

Q: 1. Water is to be delivered from a reservoir through a pipe to a lower level and discharged into the…

Q: The jet hits the point surface that is 12 meters. Pressure = 49.05 kPa Cv = 0.97 What is the…

Q: an open circular vessel is 1m in diameter and 2m in height. it contains water filled to a depth of…

Q: A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5…

Q: SITUATION 8: A trapezoidal channel discharging 20.40 m³/sec at a depth of 1.2m and a base width of…

Q: water flows through an orifice at the vertical side of large tank under a constant head of 2.4 m.…

Q: 900N/m 1.1m 1.3m + 750N/m 1.1m

A: Loading and dimensions are given There will be reactions and moments at 2 fixed supports Form…

Q: A rectangular channel carrying supercritical stream is to be provided with a hydraulic jump type of…

Q: Air at 20°C flows over a very large bank of 2 cm OD tubes that are kept at 100°C. The air flow is…

A: We have to determine the value of h on the first tubes and on the tubes deep in the array if the air…

Q: An orifice is located in the side of a tank with its centre 10 cm above the base of the tank. The…

A: Given-Height of orifice h=10 cm=0.10 m,Water level height H=1 m,Coefficient of velocity C=0.98,We…

Q: Pressure in a pipe carrying oil (Specific Gravity 0.92) is 20 kN/m². A piezometer is connected to…

A: Given data : Pressure (P)=20 KN/m2Specific gravity (S.G)=0.92Density of water (ρWater)=1000 kg/m3

Q: he side of a square plane surface is 0.51m and to be placed vertically below the water surface. The…

A: The centre of pressure of a vertical surface submerged in water is given by h*=IGAh-+h- where…

Q: A tank in the shape of the frustum of a cone has a bottom radius of 0.75 m, top radius of 1.5 m and…

A: The figure of the frustum of the cone is as shown below

Q: Water flows through a long, horizontal conical diffuser at the rate of 4.0 m3/sec. The diameter of…

Q: Oil flows through a small standard 25m diameter orificce under a head of 5.4 m at the rate of…

Q: The pressure at point m in the figure shown was increased from 85 kPa to 125 kPa. This causes the…

A: Given, P1 = 85 KPa P2 = 125 KPa movement of Hg in sloping tube = 28 mm = 0.028 m let the change in…

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: 2. Use Virtual Work Method to calculate the deplection at C for the frame shown in the accompanying…

Q: A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5…

Q: An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of…

Q: 2/86 If the resultant of the loads shown passes through point B, determine the equivalent…

A: Couple: A couple of a system is defined as the force with a resultant moment but no force. Due to…

Q: 7. The pressure intensity for a horizontal plate is maximum on the surface of the earth and…

A: Surface of earth is geoid i.e. Earth like and acceleration due to gravity (g) is 9.81 m/s2 at…

Q: A closed tank 2m high and 1m in diameter contains 1.5 m water. The air in the space above water is…

A: Following are the given information. Closed tank height =2 m Closed tank diameter =1.0 m Height of…

Q: 8-89 Water at 15°C is drained from a large reservoir using two horizontal plastic pipes connected in…

A: We have to detemine the dscharge rate from the reservoir.

Q: Problem An open circular tank of 20 cm diameter and 100 cm long contains water upto a height of 60…

A: Given Diameter of cylinder D=20 cm, Hence, R=10 cm, Length L=100 cm, Height H=60cm, Speed N=300…

Q: A 0.9 m diameter vertical cylindrical tank which is 1 m high and is open to the atmosphere contains…

A: Given data:- Diameter of the cylindrical tank (): 0.9 m- Radius of the cylindrical tank (): = 0.45…

Q: Q:-Determine the force exerted on the cone curved surface. The liquid in the tank has a specific…

Q: The pressure in the air space above the surface of oil (SG = 0.78) in a closed tank is 125 KPa…

A: As Pabs = PGAGE + PATM SO, PGAGE = 125 - 101.325 = 23.675KPa

Q: 8-0 Water is to be withdrawn from an 8-m-high water res- ervoir by drilling a 2.2-cm-diameter hole…

Q: Water flows through an orifice at the vertical side of a large tank under a constant head of 2.2.…

A: Head, H=2.2 m y=1.5 m Assume coefficient of velocity, Cv=0.98

Q: If the pressure in the tank of oil (sp gr 0.80) is 60 psi, what is the equivalent head in feet of…

A: Note... 1 psi= 6894.757 N/m2 1 m = 3.28084 ft.

Q: Determine the horizontal component of the total hydrostatic force (kN) the oil exerts on the face AB…

A: Given: Overhang, 1.883m long Find: Horizontal component of the total hydrostatic force

Q: 3.) Determine the total pressure and center of pressure on a circular plate of diameter 3700mm which…

A: The pressure force on a submerged body is equal to product of pressure at centroid and area of body.…

Q: Air of M =2 and P = 75 kPa flow on a wedge (total angle 20°). Calculate the two oblique shock angles…

Q: 4. The intensity of pressure is related to specific weight of the liquid and vertical depth of the…

Q: 8 kN/m 12 kN m OB – 5m- - 3 m

A: Derive equations for shear and bending moment and draw SFD and BMD

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

A vertical U-tube with two legs 2 m apart is filled
with water and rotated about a vertical axis 0.5 m
from one leg. The differenco in elevation of water
levels in the two legs, open to almosphere, when
the speed of rotation is 45 rpm is, nearly.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

High velocity water flows up an inclined plane, as shown in Fig. 5-D.What are the two possible depth flows at section 2? Neglect all losses.
I need the answer as soon as possible
3. Under a constant head of 3.2 meters, water flows through an orifice on the vertical side of a huge tank. 1 m below the orifice, how far horizontally from the vena contracta will the jet contact the ground?
Hydraulics problem
A vertical tube 4 meters long with one end closed is immersed vertically with the open end down into a tank of water until the open end is submerged to a depth of 2 meters. Assume atmospheric pressure is 101.5 kPa. Which nearly gives the height of water inside the tube in meters? а. 0.5 ОЬ. 1.6 Ос. 0.8 O d. 1.1
Water flows through a pipe at 150 L/s that changes gradually in diameter from 165 mm at point A to 473 mm 4.3 m higher than at point A and B are at point respective pressures 49.8 kPa. В. В is point A. The 72 КРа and Determine the head loss of the pipe. а. b. Determine the total energy at point B with datum at point A. Determine the total energy at point A with datum at C. point A.
A vertical rectangular plane surface is submerged in water such that is top and bottom surface are 1.5 m and 6.0 m respectively below the free surface. The position of centre of pressure below the free surface will be at a distance of
The specific energy for a 5 m wide rectangular channel is to be 4 Nm/N. If the rate of flow of water through the channel is 20~m^{3}/s. determine the alternate depths of flow.
A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5 m from one leg. The differenco in elevation of water levels in the two legs, open to almosphere, when the speed of rotation is 45 rpm is, nearly.
The total pressure or pressure intensity is not zero for any point on inclined surface in space.