A uniform diving board, of length 5.00 m and mass 57.0kg, is supported at two points; one support is located3.40 m from the end of the board and the second is at4.60 m from the end. A diver of mass 52.0 kg stands atthe end of the board over the water. What is the forceacting on the board due to the left-hand support? Ifthe force acting is downward, enter a negative valueand if the force acting is upward, enter a positive value.

Given that,Length of the board, 5.00mMass of the board , 57.0kgd1=3.4m;d2=4.6mMass of diver…

Answered: A uniform diving board, of length 5.00…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

answer 2nd question. determine the hydrostatic force acting on the plate at this position.
The gate holding back the oil (S=0.8) is 80 cm high and 120 cm long. If it is held in place only along the bottom edge, what is the magnitude of the force that must be applied at the bottom to keep the gate closed? binge- 40 cm 80 cm gate Select one: O a. 3.52 kN O b. 4.40 kN O c. 3.01 kN O d. 4.68 kN
... 4m 2m Hinge Water 50cm 420cm 30cm B.
A cylindrical anchor with specific weight of 24 KN/cu.m. is submerged in salt water (SG = 1.03) and attached to a gate AC as shown. The gate is hinged at B and the tension wire is attached at C. The gate is inclined by 60o from the horizontal and has a length of 2.5m. To keep the system in equilibrium, determine the diameter of the cylindrical anchor if the height is twice the diameter.
A closed cylindrical drum is 30cm in diameter and 50cm high as shown, contains a liquid (SG liquid = 0.83) and a depth of 20cm. The drum is then submerged in water and attached to a beam using a tension wire. Neglect the outer and inner thickness of the drum. To keep the beam in horizontal position, determine the following: a) The force "B" if the specific gravity of the drum is 1.65; force "B" is ____ KN b) The specific gravity of the drum if the force B is 160 kg; SG of drum is _____
6. The steel gate 2.61m square of thickness 36.1mm is to be lifted by a frictionless pulley. The coefficient of friction between the dam and plate is 0.216 ,calculate the minimum force required to lift the gate if it is fully submerged to a depth of 1.61m. Use specific gravity of steel 8.0 PLEASE ANSWER THIS ASAP!!!
Please full answer..
Fluid mechanics, i need solutions in 10 minutes please. Q/Q2 The 4 -m- diameter circular gate of Fig. E2.6a is located in the inclined wall of a large reser voir containing water (y = 9.80 kN / m³). The gate is mounted on a shaft along its horizon tal diameter. For a water depth of 10 m above the shaft determine: (a) the magnitude and lo cation of the resultant force exerted on the gate by the water, and (b) the moment that would have to be applied to the shaft to open the gate.
The 600-lb, 20ft-wide rectangular gate shown is hinged at B and leans against the floor at A making an angle of 45° with the horizontal. The gate is to be opened from its lower edge by applying a normal force P at its center. A. Determine the magnitude of the hydrostatic force acting on the gate using the HYDROSTATIC PANEL EQUATIONS. Express your answer in kips. B. Determine the minimum force P required to open the seawater gate. Express your answer in kips.
Q3. Consider a buoy attached to a supporting cable as shown. The buoy is 3 m long, it has a diameter of 200 mm, and its specific gravity relative to seawater is 0.60. In a coastal environment at low tide, the buoy is not fully submerged and inclines as shown. At high tide, the buoy is fully submerged and is oriented vertically. Density of Seawater is 1023 kg/m³. (a) What is the tension in the support cable at low tide? (b) What is the tension in the support cable at high tide? Buoy. 200 mm Low tide. Seawater 3 m 0.5 m Support cable Support -
1. A barrel in the form of a frustum of a cone with a radius of 3m at the bottom and 6m at the top. It is 5m high and is 4/5 full of oil (0.85). Determine the a. Total hydrostatic force acting on the wall of the barrel in kN and b. its line of action from the bottom c. tensile force at the top band d. the tensile force at the bottom band
1. Determine the maximum force P needed for the homogenous block to be in static equilibrium. What will happen to the block if the magnitude of force P went above the maximum? The coefficient of static friction between the block and the floor is 0.30. The weight of the block is 500 lb, indicate the direction of the impending motion. 40° Guide Questions: a. What is the direction of frictional force on the 500 lb block? b. If slipping is impending, can we assume that F = μ,N? c. Where is the location of the frictional force on the block if tipping is impending? Answer: Pmax=432.55 lb The block will tip to the right before it slips. 4 ft 6 ft

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS