A truck load with axle loads of 40kN and 60 kN on a wheel base of 5m rolls across a 12-m simply supported beam span. Determine the absolute maximum flexural moment [in kN-m].

A 400 mm 400 mm square precast concrete pile of 15 m length is driven into a sand where = 18.0 kN/m3 and = 33. Assuming = 0.7 and K = 1.4Ko, determine the load carrying capacity of the pile with factor of safety of 3.0.

In a piled raft, 450 mm diameter and 13 m long piles are placed in a rectangular grid at 1.60 m 1.63 m spacing. Find the pile-raft interaction factor assuming uniform soil conditions with depth and

For the data given in this problem, determine the magnitude of the active thrust on the wall retaining a c soil, using the procedure discussed in Section 16.10. Given H = 15.0 ft, c = 100 lb/ft2, = 26, = 115 lb/ft3, kv = 0, and kh = 0.3.

A 5.0 ft wide square footing is placed at 3.0 ft depth within the ground where c = 200 lb/ft2, = 25, and = 115.0 lb/ft3. Determine the ultimate bearing capacity of the footing using Terzaghis bearing capacity equation and the bearing capacity factors from Table 6.1. What is the maximum column load that can be allowed with a factor of safety of 3.0?

Repeat Problem 11.1 based on LRFD using the following factors: load factor for dead load = 1.25 load factor for live load = 1.75 strength reduction factor on the ultimate bearing capacity = 0.50 11.1 A continuous foundation is required in a soil where , , and . The depth of the footing will be 1.0 m. The dead load and the live load are 600 kN/m and 400 kN/m, respectively. Determine the required width for the foundation based on allowable stress design with FS = 3, using Eq. (6.10) and Table 6.1.

A W1422 acts compositely with a 4-inch-thick floor slab whose effective width b is 90 inches. The beams are spaced at 7 feet 6 inches, and the span length is 30 feet. The superimposed loads are as follows: construction load = 20 psf, partition load = 10 psf, weight of ceiling and light fixtures = 5 psf, and live load = 60 psf, A992 steel is used, and fc=4 ksi. Determine whether the flexural strength is adequate. a. Use LRFD. b. Use ASD.

A 500 mm diameter and 20 m long concrete pile is driven into a sand where = 18.5 kN/m3 and = 32. Assuming = 0.7 and K = 1.5 Ko, determine the load carrying capacity of the pile with a factor of safety of 3.

A steel pile (H-section; HP 360 1.491; see Table 18.1) is driven into a layer of sandstone The length of the pile is 18.9 m. Following are the properties of the sandstone: Unconfined compression strength = qu(lab) = 78.7 MN/m2 Angle of friction = 36 Using a factor of safety of 3, estimate the allowable point load that can be carried by the pile. Use Eq. (18.42).

A continuous foundation is required in a soil where c=10kN/m2, =26, and =19.0kN/m3. The depth of the footing will be 1.0 m. The dead load and the live load are 600 kN/m and 400 kN/m, respectively. Determine the required width for the foundation based on allowable stress design with FS = 3, using Eq. (6.10) and Table 6.1.