A triangular channel has a 30-degree walls. A smooth asphalt lining (n = 0.013) is used and the channel slopes at 2.0%. If the water speed is measured at 3.0 m3/s, what is the water depth in the channel?

Q: An open-ended steel barrel of 1 m height and 1 m diameter is filled with saturated fine sand having…

A: Given data: Drop in water level = 0.75 m Coefficient of permeability, k=102 ms.

Q: A permeable soil layer is undertain by an impervious soil layer. The coefficient of permeability of…

A:

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: Consider the simple pipe network below. Pipe AB and CF are both 500m long with diameters of 0.8m and…

A: LAB = LCF = 500 mL1 = 200 mL2 = 300 mQ = 3 m3/s

Q: A 10 m deep canal is constructed in purely cohesive soil having c = 0-2 kg/cm², 0 = 0°, G = 2-5, e =…

A: Given - Depth of canal, H = 10 m = 1000 cm c = 0.2kg/cm2 = 200 g/cm2 G = 2.5,  e = 0.5 Stability…

Q: an open-ended steel barrel of 1 m height and 1 m diameter is filled with saturated fine sand having…

A: Given data: Drop in water level = 0.75 m Coefficient of permeability, k=102 ms.

Q: Question attached

A: Solution: Capillary risehc=4σCosθγdhere,γw=9810 N/m3σ=Surface tension=0.075 N/md1=0.00075…

Q: A 10 m deep canal is constructed in purely cohesive soil having c = 0.2 kg/cm², 0 = 0°, G = 2.5, e =…

A: given height of canal H=10 m=1000 cmG=2.5e=0.5cohesion C=0.2 kg/cm2=200 g/cm2Taylor stability number…

Q: 3. Determine the geometry that must be given to a trapezoidal channel with minimum infiltration that…

A:

Q: A hydraulically efficient trapezoidal channel section has a uniform flow depth of 2 m. The bed width…

A: Given data in question  Hydraulically efficient channel Trapezoidal channel Uniform flow depth To…

Q: A 25 cm diameter pipe carries air (p=1.22kg/m³) (v = 1.5x10-5m²/sec) at an average velocity of 8.0…

A:

Q: A triangular channel has a 30-degree walls. A smooth asphalt lining (n = 0.013) is used and the…

A: Using mannings equation

Q: The elbow flow passage volume is 0.4 m. The water volume flowrate at the inlet is 0.4 m/s and the…

A:

Q: Determine the point where the neutral axis intersects line AB. The point where the neutral axis…

A: Given,  Wall thickness= 12mm P= 19kN

Q: Determine the critical depth for a rectangular smooth concrete flume (n=0.013) 4.5m wide which is to…

A:

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: A 25 cm diameter pipe carries a (p=1.22kg/m³) (v=1.5x10-5m²/sec) at a average velocity of 8.0 m/sec.…

A:

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A: Given Data: Width of fill=12m Side slope=1.5:1 Center height=20m Interval are= 3.7 m, 2.6 m, 4.0…

Q: For the cross section shown below, what is the required flow rate (assuming uniform flow) to cause…

A:

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A: The volume of the embankment by average area method is V = ∈AnL The volume of the embankment by…

Q: A triangular channel has a 30-degree walls. A smooth asphalt lining (n = 0.013) is used and the…

A: To determine the water depth of channel for given flow rate and channel properties.   The flow rate…

Q: 2 kN 150mm 300mm Alow, Ocompressile =5 MPa

A: Given data in question  Cylinder Compressive stress  Dimensions  To find out  Maximum load in kN

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: The required water flow rate in the 6 cm diameter 30 meter long circular pipe in the diagram above…

A: givent that, Diameter of pipe (d) = 0.06 m Length of pipe (l) = 30 m Dischage (Q) = 12 lit/sec =…

Q: A rectangular channel 6 m wide and 1.5 m deep has a slope of 1 in 1200 and is lined with good rubble…

A:

Q: Ex 3 :Hw 2 Design unlined canal to carry a discharge of 1.0 m3 /s with a longitudinal slope 20cm/km…

A: Question is based on design of canal using lace's theory. Design discharge, slope, manning constant…

Q: The channel consists of a smooth cement section (m = 0.109) and overflow regions on each side that…

A:

Q: A deposit of cohesionless soil with a permeability of 0.3 mm/s has a depth of 12 m with impervious…

A: Given data,  k = 0.3 mm /s H = 3 m To find out the seepage quantity.

Q: The following cross-sectional areas (m2) are calculated for centre line of a drain trench at 5 m…

A:

Q: Question 3 Consider a wide rigid-boundary canal with bed slope of 0.004, Manning's n = 0.18 and…

A: Given- Wide-rigid boundary canal- Bed slope S=0.004, n=0.18, Depth of flow y=0.88 m It is needed to…

Q: Determine the flow rate of air through an axial bush seal. The outer diameter of the inner cylinder…

A: Given data:- The outer diameter of inner cylinder, D=250 mm1 m1000 mm=0.25 m Radial clearance, c=0.2…

Q: A wide, shallow sand-bed channel has a slope of 0.00105 (assume smooth channel banks). The average…

A: Given: Slope, Se = 0.00105 Flow rate, Q = 5380 ft3/s Area, A = 640 ft2

Q: A triangular channel has a 40-degree walls with respect to the horizontal. A smooth asphalt (n =…

A: Objective: To determine the depth of water in the channel.   Given: Angle of the channel walls = 40o…

Q: A 10 m deep canal is constructed in purely cohesive soil having c = 0-2 kg/cm2, 0 = 0°, G = 2-5, e =…

A: Given- 10 m deep canal, H=10 m, Cohesion C=0.2 kg/cm2=200 g/cm2. Specific gravity G=2.5, Void ratio…

Q: Consider the simple pipe network below. Pipe AB and CF are both 500m long with diameters of 0.8m and…

A: Pipes section with their dimensions and their friction factor are given…

Q: Example 2: A triangular gutter with side slope at angle 60 has a depth 250 mm. If the discharge is…

A:

Q: railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: A 300mm by 460mm rectangular pipe carries oil at 105 kpa absolute and 20c through 460m with an…

A: Hydraulic radius - Hydraulic Radius is defined as the cross-sectional area divided by the wetted…

Q: The following cross-sectional areas(m2) are calculated for centre line of a drain trench at 5 m…

A: Given data : Area A1=2.5 m2 Area A2=2.7 m2 Area A3=1.8 m2 Area A4=3.5 m2 Area A5=3.7 m2 Area A6=2.9…

Masonry wall construction

Masonry walls of various sorts are utilized in building construction. Masonry walls are the most enduring feature of any structure or building. It separates a structure from the outside world. In masonry construction, the common masonry materials used are building stone, brick, cast stone, glass block, and concrete block. Masonry construction is a type of construction that has the highest durability.